2000 INTERNATIONAL 9400IInternational 9400i 2000

Complaint Information: OBD II Codes

NHTSA Mandated Recalls
  • Recall 2001124 [Canada]: Brakes
    On certain vehicles, the automatic slack adjuster anchor brackets can fail due to fatigue fracture and completely separate, causing the slack adjusters to function as manual slack adjusters. If the support bracket for an automatic slack adjuster fails, the brakes at that wheel end will not automatically adjust. As the brake linings wear, the vehicle will have reduced braking capacity, increasing the risk of a crash. Correction: dealers will install a new bracket on each suspect slack adjuster.

  • Recall 2000130 [Canada]: Seats and restraints
    On certain vehicles, the four bolts that hold the bunk webbing restraint latch brackets to the bunk base may be of an incorrect grade. Grade 5 bolts were used in lieu of the required grade 8 bolts. Grade 5 bolts do not meet the original design intent of the restraint. Correction: vehicles will be inspected and all grade 5 bolts will be replaced with grade 8 bolts.

  • Recall 2004049 [Canada]: Other
    On certain vehicles, a defect in the front wheel hub bearings will result in premature spalling which will lead to eventual breakdown of the bearing. An early breakdown of the wheel hub bearing system, when undetected, can possibly cause a wheel fire, wheel separation, loss of vehicle control, or vehicle fire. Correction: dealer will inspect the front axle hubs, and replace if necessary. This is an expansion of recall 03-134.

  • Recall 2004074 [Canada]: Electrical
    On certain vehicles, water intrusion into the sleeper berth's bunk control panel area may pool in the tops of the dome light, tv/vcr, and/or refrigerator power switches. The led circuit boards in these switches may begin to heat up and possibly produce a flame or fire, without warning, that could cause property damage, personal injury, or death. Correction: dealer will install a water shield over the back of the entire bunk control panel.

  • Recall 2003134 [Canada]: Other
    On certain vehicles, a defect in the front wheel hub bearings will result in premature spalling which will lead to eventual breakdown of the bearing. An early breakdown of the wheel hub bearing system, when undetected, can possibly cause a wheel fire, wheel separation, loss of vehicle control, or vehicle fire. Correction: dealer will replace front axle hubs.

  • Recall 2000145 [Canada]: Powertrain
    On certain vehicles equipped with eaton autoshift transmissions, incorrect software in these transmissions could cause a condition whereby in certain circumstances, when reverse is selected the transmission engages 2nd gear. Incorrect gear engagement can result in a crash without prior warning. Correction: suspect software will be reprogrammed.

  • Recall 2004074 [Canada]: Electrical
    On certain vehicles, water intrusion into the sleeper berth's bunk control panel area may pool in the tops of the dome light, tv/vcr, and/or refrigerator power switches. The led circuit boards in these switches may begin to heat up and possibly produce a flame or fire, without warning, that could cause property damage, personal injury, or death. Correction: dealer will install a water shield over the back of the entire bunk control panel.

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.