Mazda 929 1994

• Recall 110645 [USA]: If the ignition switch overheats there would be an increased risk of a fire.
  Mazda north american operations (mazda) is recalling certain model year 1989-1998 mpv, 1990-1995 323, 1990-1998 protege, 1992-1993 mx-3, 1993-1995 929, 1993-1997 mx-6, and 1993-1998 626 vehicles. In the affected vehicles, grease applied to the contact points inside the ignition switch may become conductive and overheat.
  mazda will notify owners, and dealers will replace the ignition switch, free of charge. The recall began on december 17, 2015. Owners may contact mazda customer experience center at 1-800-222-5500, option#6. Mazda's number for this recall is 8715j.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall 2015489 [Canada]: Electrical
  On certain vehicles, a defect in the ignition switch could cause an electrical short to develop over time. This could result in smoke and/or fire, increasing the risk of injury and/or damage to property. Correction: dealers will replace the ignition switch.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

1994 mazda 929 has been experiencing unintended acceleration problems. Have not gotten it fixed yet so i don't know what it will cost.

Right rear tire belt broke causing extensive damage to rear bumper / under carriage & right rear door. *yc

When the rear passenger side and driver side windows are put down they will not go back up,and there is a humming sound. *ak

Sun roof/driver window/left rear window and right rear window came down while driving on its own,and the motor will not assist in helping the window to go back up. Also my car is stalling while driving approximately 17 miles. The car does a jerking motion before stalling. Finally, the passenger's air bag is warped, and detached from the dashboard. *ak

When backing up, stopping, and then shifting to the drive position: rotor assembly and front suspension clash. Causing rotors to becom unbalanced and warped, hazardous handling and excessive maintenance

My spouse was on her way to work when the car engine was rough idling and stalled. No engine light or instrument warning indicator came on. The car was towed to a local mazda service dealer the same day. We contacted the service dept on 01/07/99 and learned that the car had a failure, an electrical short in one of the six ignition wires. We also learned that unburned fuel due to this ignition wire failure pass through to the catalyst converters and damaged the left catalytic converter (ruptured). The estimate given to us by the mazda dealer for replacement parts + labor was $1300 for replacing 3 converters. Mazda indicated the emission system (including the converters) was not covered by either our extended warranty or by mazda. All failed parts involved were original mazda for mazda 929. I and my spouse extremely concern of driving this vehicle based on this incident. There should be a recall for mazda 929's to check the ignition wires and exhaust systems at their expense at the next scheduled maintenance interval. *ak

While driving vehicle about 65 mph consumer had a frontal accident, hitting a wall. Air bags did not deploy, causing minor injuries to consumer. Manufacturer was contacted. *ak

Failure of the parking shift, the vehicle was placed in park the keys was out the ignition and the shift was placed out of gear. *ak

Abs brakes failed. Also, front brake disc rotors/pads continuously warped due to manufacturer's defect.