2003 MAZDA MILLENIAMazda Millenia 2003

Vehicle Details: Consumer Complaints, Service Bulletins

Below you will find all available information on the 2003 MAZDA MILLENIA, manufacturered by Auto Alliance International, Usa.

ManufacturerKnown WMI(s)Fuel Type
MAZDA1YV JM1
MAZDA VIN Decoder

Use the box here to look up VINs from MAZDA as well as other manufacturers

#
Frequently Asked Questions
  • Where is the 2003 MAZDA MILLENIA produced?
     - The 2003 MAZDA MILLENIA is produced in Wasington Dc, United States (usa).
NHTSA Mandated Recalls

No recalls could be found for this vehicle. To ensure accuracy and for your safety, do a free VIN recall check here or here [USA] - UK - Canada.

Recalls are also available on the Complaints page
Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • 09-016-23 - ELECTRICAL SYSTEM:INSTRUMENT PANEL:SPEEDOMETER/ODOMETER: Speedometer replacement procedure
  • 0901216 - EQUIPMENT: Paint damage mazda pocket paint guide
  • 09-034-21-3850 - STRUCTURE: Some vehicles may exhibit the inner cloth (a) falling down at the rear end causing a poor appearance and obstructing the view of the back window.
  • 09-025-21-3824 - EQUIPMENT: This service bulletin provides information regarding the proper use of the driver??A?A?S floor mat to avoid any potential interference with the foot pedals. The following are possible causes of floor mat interference, which can be avoided w
  • 01-006-21-3779 - ELECTRICAL SYSTEM: This service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in sto
  • 01-005-21-3778 - ELECTRICAL SYSTEM: The mazda dca-8000pm is required for all warranty battery testing. If the mazda dca-8000pm is not used, incorrect battery testing may result in unnecessary battery replacement. Use the following test procedures in this service bulletin to t
  • 09-002-21-3770 - ELECTRICAL SYSTEM: In accordance with federal regulations, follow the procedure listed below when replacing a speedometer
  • 09-006-20-3673a - EQUIPMENT: When encountering a vehicle with paint damage, refer to the "mazda paint warranty guide" to determine cause, prevention, remedy, and warranty coverage (if applicable).
  • 09-003-20-3671 - ELECTRICAL SYSTEM: In accordance with federal regulations, follow the procedure listed below when replacing a speedometer. Note: tampering with a motor vehicle odometer is strictly prohibited by federal, and state laws. It is the dealerâ¿¿s responsibility
  • SA-061-17 - ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL: In an effort to achieve a higher level of customer experience and retain the value of mazda's vehicles, mnao warranty operations is? 2017 mazda north american operations, u.S.A. Allowing all mazda dealers to utilize a third party, specmo en
  • 02-001-13-2752 - EQUIPMENT: Some customers may complain of signs of oil on the struts or shock absorbers. In most cases the oil that is present is normal, and a result of the oil that remains on the shaft during the normal sweeping process of the shaft seal. Follow th
  • 0900104 - VISIBILITY:REARVIEW MIRRORS/DEVICES:INTERIOR: Port or dealer installed auto-dimming (electro-chromic) mirror, with electronic compass, ambient temperature. *mr
Vehicle Documentation
[pdf] Confidentiality Request Letter
Mazda2003 book MA000 fm turnewj Mazda Reference JustAnswer MA3 MODE 1—Adaptive Memory Produce Drive Mode This mode applies to the following models 1996 97 626 MX6 with 2 5L engine 0L and manual transmission 2002 Millenia 2003 MPV MX5 Miata Protege z To perform this 1 drive cycle Verify that all electrical loads headlights 3c257df7 dd4e 4729 994b 86c6c790e834 mazda f01 justanswer indy tech
MA000 Mazda Reference Subject: Source: Drive cycle for 19962005 cars and B-Series trucks Mazda service manuals The purpose of the OBD-II Drive Cycle is to execute the monitors and identify any concerns with the system. The DTC P1000 code is erased when all monitors have been completed during the ...
lang:en score:20 filesize: 618.38 K page_count: 49 document date: 2010-02-22
Most Recent Consumer Complaints and Accidents
CrashFireTowedInjuredDeathsFailure
Date
NoNoN NoneNone20021207

Vehicle was parked and no reason the back window shattered. Dealer has been notified. Please provide further information. Mr

For a complete list of all consumer complaints and OBD II codes, see the Complaints page

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.