2007 MERCEDES BENZ Cl216Mercedes Benz Cl216 2007

Vehicle Details: Recalls, Consumer Complaints, Service Bulletins

Below you will find all available information on the 2007 MERCEDES BENZ Cl216.

ManufacturerKnown WMI(s)Fuel Type
MERCEDES BENZ
MERCEDES BENZ VIN Decoder

Use the box here to look up VINs from MERCEDES BENZ as well as other manufacturers

#
Frequently Asked Questions
  • Are there recalls for the 2007 MERCEDES BENZ Cl216?
     - There are 1 recall(s) for the 2007 MERCEDES BENZ Cl216, additional information is below.
NHTSA Mandated Recalls
  • Recall 80513 [USA]: A variation in the transmitted values between affected and unaffected sensors can result in one front strut adjusting to a value indicating body movement while another strut does not adjust presenting the driver with an uneven front suspension. this condition may lead to unexpected body movements at the front axle which can adversely influence the vehicle's directional stability and could lead to a vehicle crash.

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • LI82.30-P-059239 - VISIBILITY:WINDSHIELD WIPER/WASHER: Complaints about poor wiping effect of winshield wiper
  • LI68.05-P-059193 - EQUIPMENT:ELECTRICAL:ANTI-THEFT DEVICES: Sentex gate operator with clik card remote not compatible with homelink
  • LI27.55-P-058976 - POWER TRAIN: Procedure in case of slight oil traces on transmission 722.9
  • LI49.00-P-054888 - ENGINE AND ENGINE COOLING: Engine diagnosis warning lamp active - the fault code P262600 or P262900 relating to the oxygen sensor upstream of the catalytic converter may be stored in the engine control unit
  • LI27.55-P-058976 - POWER TRAIN: Procedure in case of slight oil traces on transmission 722.9
  • LI18.00-P-058770 - ENGINE AND ENGINE COOLING: Warning message in instrument cluster. The fault code P052400 "the oil pressure is too low" is logged in the engine control unit.
  • LI47.40-P-053871 - ENGINE AND ENGINE COOLING: Fault code P045600 or P044200 without complaints about engine running characteristics
  • LI27.20-P-055758 - POWER TRAIN: Friction power of torque converter lockup clutch is too high (fc 2783) or actuation of torque converter lockup clutch not possible (fc 0741)
  • LI27.55-P-058976 - POWER TRAIN: Procedure in case of slight oil traces on transmission 722.9 with code b03
  • LI47.40-P-053871 - ENGINE AND ENGINE COOLING: Fault code P045600 or P044200 without complaints about engine running characteristics
  • LI27.20-P-055758 - POWER TRAIN: Friction power of torque converter lockup clutch is too high (fc 2783) or actuation of torque converter lockup clutch not possible (fc 0741)
  • LI42.47-P-048216 - ELECTRONIC STABILITY CONTROL: Message in instrument cluster "esp malfunction - service required"
  • LI83.00-P-052510 - ELECTRICAL SYSTEM: Malfunctions of various control units and/or on-board power supply problems caused by water in the control unit tray under the driver/front passenger seat (dislocated, pinched or leaking condensation hose)
  • LI54.18-P-058597 - ENGINE AND ENGINE COOLING: Check engine light (cel) on, dtc fault code(s) concerning throttle valve actuator
  • LI68.05-P-049515 - EQUIPMENT:ELECTRICAL: Garage door opener cannot be programmed or the range is too short
  • LI91.25-P-059392 - SEATS: Multicontour/dynamic seat, malfunctions
  • LI91.00-P-049798 - SEATS: Venting noises from dynamic seat
  • SB-32-25-82 - SUSPENSION:FRONT:SPRINGS:AIR SUSPENSION SYSTEM: Mercedes-benz: shock absorber procedure. *rm
Most Recent Consumer Complaints and Accidents
CrashFireTowedInjuredDeathsFailure
Date
NoFireN NoneNone20121031

Abc line suspension failure fluid drain into engine bay and under tire. *tr

Common OBD-II Error Codes
  • P2626 [1] O2 Sensor Pumping Current Trim Circuit/Open Bank 1 Sensor 1
  • P2629 [1] O2 Sensor Pumping Current Trim Circuit/Open Bank 2 Sensor 1
  • P0524 [1] Engine Oil Pressure Too Low
  • P0442 [2] Evaporative Emission Control System Leak Detected (small leak)
  • P0456 [2] Evaporative Emissions System Small Leak Detected

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.