Mercedes Benz Cl216 2008

• Recall 80501 [USA]: A variation in the transmitted values between affected and unaffected sensors can result in one front strut adjusting to a value indicating body movement while another strut does not adjust presenting the driver with an uneven front suspension. this condition may lead to unexpected body movements at the front axle which can adversely influence the vehicle's directional stability and could lead to a vehicle crash.
  Mercedes benz is recalling 4,564 my 2001-2006 cl-class (model 215), my 2002-2006 s-class (model 220), my 2003-2007 sl-class (model 230), my 2007-2008 cl-class (model 216), and my 2007 s-class (model 221)passenger vehicles equipped with active body control (abc) acceleration sensors on the front struts. These sensors measure acceleration around the z-axis of the vehicle and assure an automatic adaptation of the front struts to maintain a relatively level body position. Variations in the soldering process resulted in soldering points on the board of the abc sensors which may not be within design tolerances. Signals from the affected sensors measuring the acceleration may not be accurately transmitted to the engine control unit.
  dealers will inspect and replace, if necessary, the front abc sensors in all potentially affected vehicles. The recall began on september 22, 2008. Owners may contact mercedes-benz at 1-800-367-6372.
  mercedes-benz recall no. 2008080004.Customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.Safercar.Gov.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

• Loss of rear lighting assembly investigation # EA13008

  The office of defects investigation (odi) opened an investigation based on consumer allegations of loss of rear lighting in model year (my) 2008-2011 mercedes benz c-class vehicles.Complainants alleged that one or both rear lighting assemblies fail to illuminate (i.E., all lights housed within the assembly extinguish, including the stop, tail, and turn signal functions) or illuminate dimly.In some reports, complainants also alleged that the failure was accompanied by a burning smell emanating from the trunk of the vehicle.When examined, these vehicles showed evidence of overheating at the lighting assembly harness connector, including damaged (blackened) wiring and plastic.The rear lighting failures typically involved one side of the vehicle however in some cases both assemblies failed (although probably not simultaneously).Odi identified 5 fire and one injury allegations during the course of this investigation.Two fires occurred while the vehicles were parked.One originated in the vicinity of the driver?S side light assembly where the fire and associated damage was confined to the trunk area, and the fire self extinguished due to oxygen starvation.As a result of the fire, the vehicle was repurchased by mercedes and salvaged.The second fire originated on the passengers side and required fire department response to extinguish; the fire damaged the tail light and surrounding body panels as well as the trunk area and wiring.The vehicle was repaired and returned to service.Two firesoccurred while the vehicle was being driven.In the first instance, the driver detected an odor and pulled over to observe smoking and a small flame at the lighting assembly wiring in the trunk.The owner was able to extinguish the fire before any significant damage occurred.In the second instance, the driver smelled smoke, pulled over, and opened the trunk to find smoke and sparks emanating from the forward facing side of the tail light.The driver was able to extinguish the sparks and drive the vehicle to the dealer. A fifth fire was reported by a fleet manager who observed a vehicle with fire damage originating near one of the tail light assemblies.The injury incident occurred when a technician burned their hand while diagnosing a failed light.The technician touched the tail light wiring which was hot enough to burn him although the injury did not require medical attention.On april 10th, 2014, mercedes notified odi that it would conduct a safety recall to remedy the rear light assemblies in approximately 252,867 my 2008 - 2011 c-class vehicles including the c300, c350 and c63 amg models.Each rear light assembly has separate bulbs that act as brake, tail lamp, backup and turn signal indicators.The bulbs are mounted in a bulb carrier which uses a common electrical ground circuit at the harness connection.According to mercedes, oxidation due to the use of dissimilar metals on the harness and bulb carrier electrical connectors can result in increased resistance and a subsequent dimming or loss of lighting function.The heat caused by the increased resistance/oxidation can also lead to the melting of the surrounding plastic, or in some cases, present a fire hazard.In conducting recall 14v-171, mercedes dealers will inspect the left and right bulb carriers and harness connectors for the presence of dissimilar electrical connectors and/or evidence of related thermal damage; affected bulb carriers and/or harness connectors will be replaced free of charge.Mercedes notes that service replacement bulb carriers produced from january 2012 eliminate the dissimilar metal condition and that these bulb carriers will not requ
  

  Show Content