5NP-H3D9Z-03

GROUP
NUMBER
AUTOMATIC
TRANSMISSION
17-AT-002
DATE
MODEL
Technical Service Bulletin
FEBRUARY 2017
GENESIS SEDAN (BH/DH)
GENESIS COUPE (BK)
EQUUS (VI)
GENESIS G80 (DH)
GENESIS G90 (HI)
SUBJECT
8-SPEED AUTOMATIC TRANSMISSION FLUID LEVEL
:
This TSB supersedes TSB 14-AT-005 to add 2017 Genesis G80 (DH) and Genesis G90 (HI).
Description: The following vehicles are equipped with an 8-speed automatic transmission. The
ATF level can be checked by the procedure shown below.
Applicable Vehicles:
2012~16 Genesis Sedan (BH, DH) 3.8L/4.6L/5.0L,
2012~16 Equus (VI) 5.0L
2013~16 Genesis Coupe (BK) 2.0L/3.8L
2017~ Genesis G80 (DH)
2017~ Genesis G90 (HI)
PARTS INFORMATION:
Part Name
Description
Part Number
Hyundai SPH-IV-RR
8-speed ATF
00232-19052
NOTICE
Use only ATF meeting the SPH-IV-RR specification approved by Hyundai.
Do not use SP-III, SPH-IV or other ATF which may result in degradation of
shift quality.
WARRANTY INFORMATION: Normal warranty applies
ATF LEVEL INSPECTION:
1.
Remove the plastic shield under the transmission.
2.
If the ATF has been completely drained, go to Step 3.
To check the ATF level, go to Step 5.
Circulate To: Service Manager, Warranty Manager, Service Advisors, Technicians, Fleet Repair
8-SPEED AUTOMATIC TRANSMISSION FLUID LEVEL
SUBJECT:
3.
Turn the engine off, shift to Neutral and lift the
vehicle on a hoist.
Use an 8mm or 5/16” hex wrench and remove
the fill plug and washer.
4.
Remove the overflow plug.
Use a fluid pump or suction gun to add
SPH-IV-RR ATF through the fill plug until ATF
flows from the overflow plug.
Reinstall the overflow plug and fill plug.
.
NOTICE
Use only SPH-IV-RR ATF, P/N
00232-19052.
5.
Attach a GDS and select vehicle, Data Analysis, A/T menu and Oil Temperature Sensor.
Move the shift lever from P-R-D and back to P. Drive the vehicle until the ATF is at the low end
of the range of 122~140°F (50~60°C).
TSB #: 17-AT-002
Page 2 of 3
AUTOMATIC TRANSAXLE TCM UPDATE
6.
Start the engine, shift to Neutral and raise the
vehicle on a hoist.
Remove the fill plug and overflow plug.
Add SPH-IV-RR ATF through the fill plug until
the ATF flows out the overflow.
Reinstall the overflow plug.
Torque: 16~18 lb-ft (2.3~2.5 kgf.m, 21~24 N.m)
Reinstall the fill plug and washer.
Torque: 27~33 lb.ft (3.7~4.6 kgf.m, 33~44 N.m)
ATF TEMPERATURE = 122~140°F (50~60°C)
SHIFT LEVER IN “N” AND ENGINE RUNNING
Maintenance Schedule:
Driving Condition
Normal service
Severe service
ATF Maintenance
No inspection or replacement
Replace ATF every 60,000 miles
Severe service is defined as:
 Frequent driving on mountain roads
 Repeated short distance driving of 5~10 miles
 Frequent driving in heavy traffic or stop-and-go conditions with extensive idling for long
distances
 Trailer towing or commercial operation such as a taxi
TSB #: 17-AT-002
Page 3 of 3