ITB16-037b
Service Bulletin Details
Public Details for: ITB16-037b
2014-2016 q50; air mix door motor lh service information this bulletin has been amended throughout. Discard all previous versions of this bulletin.
Models from 2016
2016 INFINITI Q50 |
2016 INFINITI Q50 HYBRID |
Models from 2015
2015 INFINITI Q50 |
2015 INFINITI Q50 HYBRID |
Models from 2014
2014 INFINITI Q50 |
2014 INFINITI Q50 HYBRID |
Classification: Reference: Date: HA16-006b ITB16-037b November 22, 2016 2014-2016 Q50; AIR MIX DOOR MOTOR LH SERVICE INFORMATION This bulletin has been amended throughout. Discard all previous versions of this bulletin. APPLIED VEHICLES: 2014-2016 Q50 and Q50 Hybrid (V37) SERVICE INFORMATION When replacing the Air Mix Door Motor LH in an APPLIED VEHICLE for any reason, the instrument panel and/or heater case does not need to be removed as part of the procedure. Do not remove either the instrument panel or the heater case from the vehicle for this procedure. When replacing the Air Mix Door Motor LH in an APPLIED VEHICLE for any reason, use the SERVICE PROCEDURE in this bulletin. When this repair is performed under warranty, use the CLAIMS INFORMATION in this bulletin. DO NOT REMOVE Figure 1 Infiniti Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Infiniti retailer to determine if this applies to your vehicle. 1/5 SERVICE PROCEDURE Air Mix Door Motor LH Removal 1. Remove the instrument panel side finisher LH with a suitable finesse tool (see Figure 2). 2. Remove the instrument lower panel LH (see Figure 3). a. Disconnect the aspirator duct. b. Disconnect all electrical connections, and then disconnect all harness clips. c. Disconnect the hood release handle and cable. Step 1 Figure 2 b. Connectors Connector c. Hood release b. Connector b. Clips Clips a. Duct Instrument panel lower LH b. Connectors Figure 3 2/5 ITB16-037b 3. Remove the four (4) bolts, and then remove bracket 1 (see Figure 4). Bolts Bracket 1 Figure 4 4. Remove the heater duct. a. Unfasten the heater duct by inserting a flat blade screwdriver and GENTLY twisting it to release the duct from the clip (see Figure 5). Insert screwdriver here b. After unfastening at the top, the heater duct will lift off a pin at the duct bottom. Figure 5 Heater duct Figure 6 3/5 ITB16-037b 5. Remove bracket 2 (see Figure 7). Clip a. Remove the screw. b. Turn the bracket to get to the backside of the harness clip, and then pinch with a suitable tool to unfasten it. Bracket 2 Screw Figure 7 6. Remove the air mix door motor LH (see Figure 8). Connector Screw a. Remove the two (2) screws. b. Pull off the air mix door motor LH, and then disconnect its electrical connector. Air mix door motor LH Figure 8 4/5 ITB16-037b Air mix door motor LH Bracket 2 Figure 9 Air Mix Door Motor LH Installation 1. Install the new air mix door motor LH in reverse order of removal. CLAIMS INFORMATION Submit a Primary Part (PP) type line claim using the following claims coding: DESCRIPTION PFP OP CODE SYM Replace Air Mix Door Motor 27742-4GF0A 5/5 TX46AA ZE DIA FRT 32 0.5 ITB16-037b