650215

Service Bulletin Details

Public Details for: 650215

Sidrive controller trim peeling. The chrome ring on the idrive controller is peeling. Poor chrome material adhesion


- 2016 - 2015 - 2014 - 2013 - 2012 - 2011 - 2010 - 2009 - 2008 - 2007 - 2006 -

Models from 2016
2016 BMW Z4
Page 1 of 2
SI B65 02 15
Audio, Navigation, Monitors, Alarms, SRS
February 2015
Technical Service
SUBJECT
iDrive Controller Trim Peeling
MODEL
E82 (1 Series Coupe)
E88 (1 Series Convertible)
E90 (3 Series Sedan)
E91 (3 Series Sport Wagon)
E92 (3 Series Coupe)
E93 (3 Series Convertible)
E84 (X1)
E89 (Z4)
With option 609 (CIC, Car Infotainment Computer)
SITUATION
The chrome ring on the iDrive controller is peeling.
CAUSE
Poor chrome material adhesion
CORRECTION
Only replace the chrome trim.
PROCEDURE
Do not replace the complete iDrive controller for this issue.
Replace the iDrive controller trim piece per ISTA Repair Instruction 6131198, “Replace controller chrome ring.”
The instructions are included in this Service Information bulletin.
Special tools required: 00 9 340 (part
of set 83 30 0 493 687)
1. Carefully pry up the “OPTION,”
“BACK,” and “MENU” buttons
with special tool 00 9 340.
https://www.bmwtis.net/tiscode/cgi-bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/21100.1.B650215.... 3/2/2015
Page 2 of 2
2. Carefully pry the chrome ring
from the controller latch
mechanism with special tool 00
9 340. Remove upwards.
Note: Be careful not to break the
retaining tabs on the controller.
3. Install the new chrome ring by
pushing it gently into place on
the controller, until it locks in.
4. Reinstall the buttons that were
previously removed.
5. Check the operation of the
controller.
PARTS INFORMATION
Part Number
Description
Quantity
65 82 9 353 029
Pearl-Glanz Chrome
1
Pearl-Grey
1
or
65 82 9 353 030
WARRANTY INFORMATION
Covered under the terms of the BMW New Vehicle/SAV Limited Warranty as applicable.
Defect Code:
61 31 68 78 00
Labor Operation:
Labor Allowance:
Description:
61 31 198*
3 FRU
Replace controller chrome ring
Labor operation code 61 31 198 is a Main labor operation. If you are using a Main labor code for another repair,
use the Plus code labor operation 61 31 698 instead.
[ Copyright ©2015 BMW of North America, Inc. ]
https://www.bmwtis.net/tiscode/cgi-bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/21100.1.B650215.... 3/2/2015


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.