Bmw M3 2008

• Recall 179298 [USA]: An inflator explosion may result in sharp metal fragments striking the driver or other occupants resulting in serious injury or death.
  Bmw of north america, llc (bmw) is recalling certain 2008-2013 128i and 135i convertibles, 128i, 135i, and m coupes, 2007-2010 x3 30si and x3 xdrive30i, 2013-2015 x1 sdrive28i, x1 xdrive28i and x1 xdrive35i, 2007-2013 328i, 328i xdrive, 335i, 335is, 335i xdrive and m3 coupes, 2006-2011 328i, 328xi, 328i xdrive, 325i, 325xi, 330i, 330xi, 335i, 335xi, 335i xdrive and m3, 2009-2011 335d, 2006-2012 325xi, 328i, 328xi and 328i xdrive, 2010-2011 x6 activehybrid, 2007-2013 328i, 335i, 335is, m3 coupes, x5 30si, x5 xdrive30i, x5 xdrive35i, x5 48i, x5 xdrive48i, x5 xdrive50i and x5 m, 2009-2013 x5 xdrive35d and 2008-2014 x6 xdrive35i, x6 xdrive50i and x6m vehicles equipped with non-desiccated driver frontal air bag inflators containing phase stabilized ammonium nitrate (psan) that were used as interim remedy parts for previous takata recalls. These inflators may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, high temperatures, and high temperature cycling.
  bmw will notify owners, and dealers will replace the driver air bag. On x5 and x6 vehicles, only the inflator will be replaced. All repairs will be performed free of charge. The recall began march 11, 2020. Owners may contact bmw customer service at 1-800-525-7417.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall 146877 [USA]: A loss of electrical power can cause the vehicle to stall, increasing the risk of a crash.
  Bmw of north america, llc (bmw) is recalling certain 2009 328i and 328xi, 2009-2011 335d, 2008-2012 m3 coupe and m3 convertible, and 2008-2011 m3 sedan vehicles. The connection of the positive battery cable at the fuse box terminal may degrade, resulting in an intermittent loss of electrical power.
  bmw will notify owners, and dealers will replace and secure the positive battery cable connector, free of charge. The recall began august 14, 2019. Owners may contact bmw customer service at 1-800-525-7417. Note: this recall is an expansion of a previous recall, number 18v-314.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall 138146 [USA]: Wiring that overheats could cause the electrical connectors to melt, and increase the risk of a fire, even when the vehicle is unattended.
  Bmw of north america, llc (bmw) is recalling certain 2006-2011 323i, 325i, 325xi, 328i, 328xi, 330i, 330xi, 335i, 335xi and m3, 2007-2011 328i xdrive, 335i xdrive and 335is and 2009-2011 335d vehicles. The wiring and electrical connectors for the system that controls air flow for the heating and air conditioning system may overheat.
  bmw will notify owners, and dealers will replace the wiring and electrical connectors, free of charge. Interim letters were mailed on november 27, 2017. Owners will receive a second notice when the remedy becomes available. Owners may contact bmw customer service at 1-800-525-7417.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall 107791 [USA]: In the event of a crash necessitating deployment of the driver's frontal air bag, the inflator could rupture with metal fragments striking the driver or other occupants resulting in serious injury or death.
  Bmw of north america, llc (bmw) is recalling certain model year 2008-2013 128i and 135i coupes and convertibles and 1 series m coupes, 2006-2011 325i, 325xi, 328i, 328xi, 328i xdrive, 330i, 330xi, 335i, 335xi, 335i xdrive sedans, 2009-2011 335d sedans, 2006-2012 325xit, 328i and 328xi sports wagons, 2007-2013 328i, 328xi, 328i xdrive, 335i, 335xi, 335i xdrive, 335is and m3 coupes and convertibles, 2013-2015 x1 sdrive28i, x1 xdrive28i and x1 xdrive35i savs, 2007-2010 x3 xdrive30i savs, 2007-2013 x5 xdrive30i, x5 xdrive35i, x5 xdrive48i, x5 xdrive50i and x5 m savs, 2009-2013 bmw x5 xdrive35d savs, 2008-2014 x6 xdrive35i, x6 xdrive50i, and x6 m sacs, 2010-2011 bmw x6 xdrive50i sacs and 2008-2011 m3 sedan vehicles. Upon deployment of the driver's frontal air bag, excessive internal pressure may cause the inflator to rupture.
  bmw will notify owners, and dealers will replace the driver's frontal air bag module or inflator depending on the vehicle model, free of charge. The recall began march 9, 2018. Owners may contact bmw customer service at 1-800-525-7417.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall 85014 [USA]: In that situation, at low vehicle speeds, it is possible for the engine to stall increasing the risk of a crash.
  Bmw is recalling 2,500 my 2008-2009 m3 passenger vehicles with an optional double clutch transmission. The problem involves the double clutch gearbox. In a situation of rapid vehicle deceleration, the transmission software may perform a multistage downshift.
  dealers will reprogram the engine and transmission electronic control unit with updated software free of charge. The recall began on december 3, 2008. Owners may contact bmw at 1-800-831-1117.
  customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

• Desiccated air bag inflator rupture investigation # EA21002

  From 2000 through 2017, takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("psan") propellant -- propellant 2004 and propellant 2004l. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 blomquist report at www.Nhtsa.Gov/sites/nhtsa.Gov/files/documents/expert_report-hrblomquist.Pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in us vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004l that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated psan inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All takata inflators produced with propellant 2004l contain desiccant, and none of these desiccated inflators using propellant 2004l are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated psan inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- takata (now known as tk global), the independent testing coalition, and exponent -- have been studying the long-term behavior of takata desiccated psan inflators using propellant 2004l (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004l is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004l.The office of defects investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated psan frontal inflators manufactured by takata. This investigation will require extensive information on takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated psan inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.Gov/recalls?Nhtsaid=ea21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede ea15-001, which remains open.
  

  Show Content

Visible gasoline leak from the chassis under the driver side rear passenger area. Stationary inside garage.

Visible gasoline leak from the chassis under the driver side rear passenger area. Stationary inside garage.

While driving at approximately 70mph on the highway, cel came on, car went into limp mode, before losing power altogether while driving. Vehicle would not turn back on. Report of engine damage requiring an entire replacement.

Tl* the contact owns a 2008 bmw m3. The contact stated that the vehicle was parked in reverse on a hill. The emergency brake was not applied properly and the vehicle rolled down the hill and crashed into another vehicle. There were no injuries. A police report was filed. The air bags did not deploy. The contact's vehicle sustained damages to the hood, bumper, and fender. The vehicle was towed by aaa to automaster bmw (3328 shelburne rd, #3, shelburne, vt 05482, (802) 985-1850) where it was diagnosed that the electrical system needed to be replaced. The electrical system was replaced; however, the body damage was not repaired. The contact referenced nhtsa campaign number: 19v472000 (electrical system) as a potential cause of the failure, but he had not received a recall notice. The manufacturer was made aware of the failure and assisted with the repair cost. The vehicle was currently at an independent mechanic to have the body damage repaired. The failure mileage was approximately 90,000. *tr*jb

Nhtsa recall number: 17v676 this recall was issued over a year ago and still have yet to be contacted by bmw to resolve the recall or provide any recourse. What is the typical response time?

Tl* the contact owns a 2008 bmw m3. The contact received notification of nhtsa campaign number: 17v676000 (electrical system); however, the parts to do the repair were unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The dealer (basney bmw mazda, 52203 in-933, south bend, in 46637, (574) 272-8504) was contacted and confirmed that the parts were not available for the recall remedy. The manufacturer was made aware of the issue and was not able to confirm when the parts were to become available. The contact had not experienced a failure. Vin tool confirms parts not available.

Takata recall. Despite my having received 2 recall notices regarding my airbag, and my car's vin being listed on nhtsa.Dot.Gov as being subject to an airbag recall, the bmw dealer listed on my recall notice, bmw of mountain view, in mountain view, california, refused to do the recall repair on 5/16/2018 on the basis that their computer system said there were no open recalls on the vehicle. They further said that the recall notice i received meant that their might be a recall but that in fact there was no recall.

Passenger restraint error keeps coming up due to fault in seat mats. Recalled for other 3 series vehicles, 2008 m3 should be included in recall.

I've been driving bmw for over 12 years. My absolute favorite car to drive. I've had my m3 for a year. My dream car. I took the upmost care of her. Coming home from work late monday driving around 65-70 miles per hour. I heard a loud noise from my car and an engine malfunction notification on my car. Almost hit an 18 wheeler as my car lost control before i swerved into a ditch. Had it towed to my mechanic where he confirmed a piece of a rod poking out the lower part of my block. I never thought the rod bearing failure would ever happen to me! It happened. I currently have no car and i still make payments. I have to get a ride to work which i hate. Bmw should be held responsible for all s65 motors that have these no clearance rod bearings. This was my baby. Now she'll never be the same again.

Common OBD-II Error Codes

• C2A82 [1] C2A82