LI54.18-P-057974

Service Bulletin Details

Public Details for: LI54.18-P-057974

Esp?, bas, pre-safe?, hold function, hill-start assist and esp? Trailer stabilization are unavailable due to a malfunction. Also the adaptive brake lights, adaptive brake assist and/or attention assist may have failed or be deactivated. The


- 2020 - 2019 - 2018 - 2017 - 2016 - 2015 - 2014 - 2013 - 2012 - 2011 -

ESP, BAS, PRE-SAFE - Fault message in instrument cluster
Topic number
LI54.18-P-057974
Version
2
Design group
54.18 Cable harnesses
Date
03-13-2014
Validity
Model 117, 176, 246 with engine 270, 607, 651
Reason for change
Remedy adapted
Reason for block
Complaint:
ESP®, BAS, PRE-SAFE®, HOLD function, Hill-Start Assist and ESP® trailer stabilization are unavailable due to a
malfunction. Also the adaptive brake lights, Adaptive Brake Assist and/or ATTENTION ASSIST may have failed or be
deactivated. The brake system continues to operate with normal effectiveness. The support functions listed may have
failed, but are available again after an ignition off/on cycle.
One or more of the faults relating to the accelerator pedal (B37) listed under 'Control unit / Fault code' are stored in
the engine control unit. Consequential faults may be stored in the ESP; see also under 'Control unit / Fault code'.
Cause:
The fault entry could have been caused by occasional transition resistance at contacts.
Remedy:
If all the test steps stored in Xentry Diagnostics have been performed and no component faults were found, the following work must be carried out:
- Check contacts of accelerator pedal plug connector (B37) for widening/damage! Make sure that testing is performed
using the correct contact spring (here MLK1.2) from the electrics case, otherwise the contact could be damaged! If damage/widening is found, the female contacts must be replaced.
- Disconnect engine control unit "plug connector - F and M" once and then reconnect.
Engines 651 and 270 only:
If the fault reoccurs, or if this is a reoccurrence of the same fault, the relevant female contacts of the engine control
unit connector "M" or "F" must be replaced. A PTSS case should be opened and MBUSA will dispatch a person to
perform the repair in the attached instructions!
Notes:
Contact spray must never be used on contacts on the engine wiring harness. The use of contact cleaners can cause
consequential damage!
Please do not replace any components!
Attachments
File
Designation
651,270_117,176,246_Tausch Kontaktbuchse_german.
pdf
Instructions: Replace female contact - German
651,270_117,176,246_Change female contact_english.
pdf
Instructions: Replace female contact - English
03-13-2014 3:02 PM
© Copyright Daimler AG
PLUBONS
Page 1/5
Symptoms
Power generation / Engine management / Engine management indicator lamp / Engine diagnosis / lit
Chassis/suspension / Brake system / Brakes/traction regulation system / Brake assist system BAS / Display message / Brake assist - not available
Chassis/suspension / Brake system / Brakes/traction regulation system / Starting-off aid / Nonfunctional
Chassis/suspension / Brake system / Brakes/traction regulation system / Brake assist system BAS / Indicator lamp /
Goes on
Chassis/suspension / Brake system / Brakes/traction regulation system / Electronic Stability Program ESP / Indicator
lamp / Goes on
Chassis/suspension / Brake system / Brakes/traction regulation system / Electronic Stability Program ESP / Display
message / Display text, yellow/white / Unavailable - ESP - See Operator's Man.
Communication/information / Warning and control system / COLLISION PREVENTION ASSIST / Warning system
nonfunctional
Control unit/fault code
Control unit
Fault code
Fault text
CDI - Motor electronics
P022664
'CRR1' for combustion engine
'OM607' (N3/9)
Fault of function monitoring of electronic accelerator There is an
implausible signal.
CDI - Motor electronics
P213862
'CDID3' for combustion engine
'OM651' (N3/9) (CRD3)
The values from the position sensors of the accelerator pedal are
implausible relative to each other. The signal comparison is faulty.
ESP® - Electronic stability pro- C03A400
gram (N30/4) (ESP9MFA)
The CAN message from control unit 'Engine' is faulty.
EFB - Electric parking brake
(N128) (EPKB166)
Communication with the control unit 'combustion engine' has a
malfunction.
U010000
CDI - Motor electronics
P212714
'CDID3' for combustion engine
'OM651' (N3/9) (CRD3)
Position sensor 2 for the accelerator pedal has a short circuit to
ground. There is a short circuit to ground or an open circuit.
ME - Motor electronics
'MED40' for combustion engine 'M274' (N3/10)
The values from the position sensors of the accelerator pedal are
implausible relative to each other. _
P213800
Parts
Part number
ES1 ES2 Designation
Quantity Note
EPC Other
make
part
A 002 982 58 26
Female contact MLK1.2S ----0.5mm²
"B37 - Accelerator pedal"
X
A 000 982 30 26
Female contact MLK1.2S ----0.75mm²
"B37 - Accelerator pedal"
X
A 001 545 50 80
Single-wire seal
"B37 - Accelerator pedal"
X
W00058913990 0
Wiring harness repair kit, basic
To be ordered as special tool!
X
W22058904990 0
Wiring harness repair kit, supplement for passenger cars
To be ordered as special tool!
X
03-13-2014 3:02 PM
© Copyright Daimler AG
PLUBONS
Page 2/5
W22058901994 0
Wire stripper
To be ordered as special tool!
X
A 021 545 01 26
Female contact MCP1.2 -----0.5-0.75mm²
For engine control unit
connector M/F - See attachment
X
A 021 545 05 26
Female contact MCP1.2 -----0.25-0.35 mm²
For engine control unit
connector M/F - See attachment
X
A 007 989 07 85
Fabric tape
See attachment
X
A 004 997 98 90
Cable tie
For engine control unit
connector M/F - See attachment
X
Work units
Op. no.
Operation text
Time
Damage
code
Note
54581 73
Diesel engine control unit
598BF 74
Connector/line F for gasoline engine
control unit
59202 74
Connector/line for accelerator pedal
sensor
598DF 74
Connector/line F for diesel engine
control unit
WIS-References
Document number
Title
Note
Allocation
AR00.19-P-0100A
Wiring harness general repair methods
Remedy
AR00.19-P-0120A
Remove contacts from
connectors, couplings
Remedy
WS00.19-P-0002B
220 589 02 99 00 Wiring
harness repair kit
Remedy
WS00.19-P-0006B
220 589 04 99 00 Wiring
harness repair kit, supplement for passenger cars
Remedy
Validity
Vehicle
Engine
Transmission
117.342
270
*
117.343
270
*
117.344
270
*
117.346
270
*
246.200
651
*
246.201
651
*
246.203
651
*
03-13-2014 3:02 PM
© Copyright Daimler AG
PLUBONS
Page 3/5
246.207
651
*
246.211
607
*
246.212
607
*
246.242
270
*
246.243
270
*
246.244
270
*
246.247
270
*
A (176)
270
*
A (176)
607
*
A (176)
651
*
CLA (117)
607
*
CLA (117)
651
*
Vehicle
Engine
Transmission
117.301
651.901
711.642
117.301
651.901
724.003
117.303
651.930
724.003
117.312
607.951
711.632
117.312
607.951
724.020
117.342
270.910
711.632
117.342
270.910
711.643
117.342
270.910
724.002
117.343
270.910
711.643
117.343
270.910
724.002
117.344
270.920
724.003
117.346
270.920
724.011
176.000
651.901
711.642
176.000
651.901
724.003
176.001
651.901
711.642
176.001
651.901
724.003
176.002
651.930
724.011
176.003
651.930
724.003
176.005
651.930
724.011
176.007
651.930
711.645
176.007
651.930
724.003
176.008
651.930
711.645
176.008
651.930
724.003
176.011
607.951
711.632
176.011
607.951
711.645
176.011
607.951
724.020
176.012
607.951
711.632
Full model designation breakdown
03-13-2014 3:02 PM
© Copyright Daimler AG
PLUBONS
Page 4/5
176.012
607.951
711.645
176.012
607.951
724.020
176.042
270.910
711.632
176.042
270.910
711.643
176.042
270.910
724.002
176.043
270.910
711.643
176.043
270.910
724.002
176.044
270.920
724.003
176.046
270.920
724.011
246.200
651.901
711.642
246.200
651.901
724.003
246.201
651.901
711.642
246.201
651.901
724.003
246.203
651.930
724.003
246.207
651.930
711.645
246.207
651.930
724.003
246.211
607.951
711.632
246.211
607.951
724.020
246.212
607.951
711.632
246.212
607.951
711.645
246.212
607.951
724.020
246.242
270.910
711.632
246.242
270.910
711.643
246.242
270.910
724.002
246.243
270.910
711.643
246.243
270.910
724.002
246.243
270.910
724.003
246.244
270.920
724.003
246.247
270.920
724.011
03-13-2014 3:02 PM
© Copyright Daimler AG
PLUBONS
Page 5/5


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.