K31126441
Service Bulletin Details
Public Details for: K31126441
Diagnostic trouble code (dtc) P2042-01: diagnostic instructions - us17+obd16 emissions and newer
- 2021 - 2020 - 2019 - 2018 - 2017 - 2016 -
Models from 2021
2021 MACK GRANITE (GR) |
2021 MACK GRANITE (GU) |
Models from 2020
2020 MACK GRANITE (GR) |
2020 MACK GRANITE (GU) |
Models from 2019
2019 MACK GRANITE (GR) |
2019 MACK GRANITE (GU) |
Models from 2018
2018 MACK GRANITE (GR) |
2018 MACK GRANITE (GU) |
Models from 2017
2017 MACK GRANITE (GR) |
2017 MACK GRANITE (GU) |
Models from 2016
2016 MACK GRANITE (GR) |
2016 MACK GRANITE (GU) |
5/28/2020 Print Case Solution K31126441 Thursday, May 28, 2020 1:51:37 PM CEST ** SOLUTION ** Title Mack Chassis - Granite Models (GU, GR) - Hood Warpage: Hood Warped, Dented, Divot Near Center Of Hood - MY 2016 And Newer Mack Models Mack Model GU - Granite ** SOLUTION ** Cause Warpage of the hood may be experienced on certain Mack Granite chassis manufactured for model years 2016 and newer. Solution Affected models will have an appearance similar to the one shown in the circled area in the example below. https://secure4.volvo.com/cbr/printCase.action?caseId=368548 1/5 5/28/2020 Print Case It has been determined that an increase of lateral structural hood support is required to correct this issue. Parts And Materials Part Number Description 82172316 Upper Section (Support, RH) 82151844 Upper Section (Support, LH) Product Information Lord Fusor® T21 Composite Adhesive (Slow) Repair 1. Remove the hood, rotate the hood upside down, and support all 4 corners. https://secure4.volvo.com/cbr/printCase.action?caseId=368548 2/5 5/28/2020 Print Case 2. The new supports should be positioned approximately 18 inches (45 cm) from the rear edge of the hood. 3. Notch each of the support sections where they passes over the grooved sections on each side of the hood. One groove and the areas to be trimmed out around it are shown in the photo below: https://secure4.volvo.com/cbr/printCase.action?caseId=368548 3/5 5/28/2020 Print Case 4. Install the new hood support using Lord Fusor® T21 Composite Adhesive. Add weight evenally across the new hood support to hold it firmly to the hood. Cure time is 4 hours. https://secure4.volvo.com/cbr/printCase.action?caseId=368548 4/5 5/28/2020 Print Case 5. Once the composite adhesive has cured a body shop can complete the rework of the underside of the hood and the paint repair. Solution visibility Dealer distribution Function Group Function Group 821 engine hood, cover with assembly parts Customer effect Main customer effect visual appearance Visual appearance distortion Administration Author A241298 Dealer ID A241298 Last modified by A241298 Creation date 05-03-2020 18:03 Date of last update 13-05-2020 20:05 Status Published UNCONTROLLED COPY. Printed document is for temporary use only and should not be retained. https://secure4.volvo.com/cbr/printCase.action?caseId=368548 5/5