2054084/2

Technical product information
Topic
Market area
Brand
Transaction No.
Level
Status
Release date
Bullseye air outlets - chrome finisher detached
Bentley: worldwide (2WBE),Hongkong-Macau (5HK)
Bentley
2054084/2
EH
Released for publishing
02-Jul-2020
New customer code
Object of complaint
Complaint type
air conditioning -> air duct system, filtration, blower -> dash panel air vent
component / consumables -> damaged
air conditioning -> air duct system, filtration, blower -> centre console air vent component / consumables -> damaged
Vehicle data
Bentayga series
Sales types
Type MY Brand Designation Engine code Gearbox code Final drive code
4V1*
4V1*
4V1*
4V1*
4V1*
2017
2018
2019
2020
2021
E
E
E
E
E
Documents
Document name
master.xml
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
Position
Technical product information
Bullseye air outlets - chrome finisher detached
Transaction No.: 2054084/2
Release date: 02-Jul-2020
Customer statement / workshop findings
Air vent chrome finisher has detached from vane.
Technical background
It is possible that using aftermarket clip on devices such as mobile phone holders, air freshener holders or chewing gum disp ensers may result in
the chrome air vent finisher becoming detached from the vane.
Production change
Not applicable.
Measure
Please advise the Customer that the use of aftermarket clip on devices is not recommended and continued use may result in repeat f ailures.
Damage caused by the use of aftermarket clip on devices will not be covered under vehicle warranty.
In the event of a chrome air vent finisher becoming detached from the vane the following procedure should be carried out.
Check the vane or chrome finisher for damage, replace the affected bullseye air outlet assembly if damage is present. The four tabs on the
chrome finisher must be present.
Note: Chrome finishers or vanes are not available to order as spare parts
Apply minimal amount of Power Mix 2K or an adhesive with a similar specification, to each of the four tabs on the chrome finisher, insert the
vane finisher into the vane ensuring the finisher is located correctly with no gaps.
Note: Rotate the vane to the fully down position or fully up position, the vane in this position gives the maximum clearance
between the ends of the vane finisher & the bullseye trim ring during re- fitment.
Check the finisher and vent for any residual adhesive, if the adhesive cannot be satisfactorily removed and the appearance of the bullseye
assembly is affected then the assembly should be replaced. If required use the Electronic Parts Catalogue (ETKA) for the correct replacement
part.
When the adhesive is dry, carry out a ‘pull’ test to confirm correct bonding of the chrome vane.
Parts information
Part number
Description
Quantity
Locally source
Power Mix 2K
1