Altec Digger Derrick 2021
Vehicle Details: Recalls, Service Bulletins
Below you will find all available information on the 2021 ALTEC Digger Derrick.
| Manufacturer | Known WMI(s) | Fuel Type |
|---|---|---|
| ALTEC |
Use the box here to look up VINs from ALTEC as well as other manufacturers
-
Are there recalls for the 2021 ALTEC Digger Derrick?
- There are 8 recall(s) for the 2021 ALTEC Digger Derrick, additional information is below.
Recall 249781 [USA]: An uncontrolled load falling increases the risk of injury to personnel or others nearby.
Recall 240356 [USA]: An electrical short-circuit can increase the risk of a fire.
Recall 245507 [USA]: Lifting loads above the boom capacity could overload the unit and cause instability, increasing the risk of injury.
Recall 234793 [USA]: An auger extension bar that detaches while the digger drive unit is deployed, can increase the risk of injury to nearby personnel.
Recall 234435 [USA]: A missing weld on the rear pole rack can lead to a crack that could cause the pole and rack to drop in height, increasing the risk of an injury.
Recall 200230 [USA]: A nonfunctional overload protection system may result in the operator unknowingly overloading the system, increasing the risk of injury.
Recall 231241 [USA]: Shear plate failure can result in the separation of the subbase and truck frame, increasing the risk of injury.
Recall 204322 [USA]: An unintentionally engaged joystick could result in uncontrolled movement of an unbalanced load, increasing the risk of injury.
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- SIL 3119 - UNKNOWN OR OTHER: Altec has learned that an incorrect grade auger retention pin could be installed on certain dc, dl, and dm derricks built from july 2015 to august 2023. Over time, this could result in the pin becoming damaged.
- SIL 3099 - EQUIPMENT: Altec has learned that on certain altec units equipped with air suspension built from april 2020 to june 2023, some operators may be dumping the chassis airbags before deploying the outriggers. This can cause the airbags to become damaged.
- SIL 3054 - EQUIPMENT: Altec has learned that certain units built with a jobsite energy management system (jems) s/se/le from october 2020 to may 17, 2023, may fail to charge or operate properly, particularly when the battery is cold. Altec has developed a firmwa
- SIL 3068 - EQUIPMENT: Altec has learned that certain digger derricks and aerial devices of various models built from january 2010 to january 2023 may contain access steps with a handrail and side plate that come together in a small space causing a potential pinc
- CSR-3092 - VISIBILITY: Altec industries, inc. Has received notification from daimler truck north america llc (dtna), on behalf of its freightliner truck division, that a condition exists relating to motor vehicle safety, compliance, or emissions in a vehicle you
- CSR 3075 - POWER TRAIN: Altec industries, inc. Has received notification from navistar, inc. That a condition exists relating to motor vehicle safety, compliance, or emissions in certain 2022 through 2024 model year navistar hv and mv series vehicles built from ja
- SIL 3041 - UNKNOWN OR OTHER: Altec has learned that when the coolant-style oil heater on certain ah75b/85B100B aerial devices built from april 2021 to august 2022 is active, the operator has to turn off the engine in order to disengage the power take-off (pto). Replace
- CSR 3051 - SERVICE BRAKES, AIR: Altec industries, inc. Has received notification from peterbilt that a condition exists relating to motor vehicle safety, compliance, or emissions in a vehicle you possess that is equipped with altec equipment. Peterbilt has decided that ce
- CSR 3050 - SUSPENSION: Altec industries, inc. Has received notification from navistar that a condition exists relating to motor vehicle safety, compliance, or emissions in a vehicle you possess that is equipped with altec equipment. Navistar has decided that cert
- SIL 850 - ELECTRICAL SYSTEM: The body compartment wiring on certain altec aerial devices, digger derricks, and body-only units built from 2014 to 2021 contains an in-line fuse located close to the lighting in the compartment, while other units are fused upstream, close
- SIL 843 - EQUIPMENT: Altec has learned that the lift cylinder pivot pin retainers may bend or break during use on dt80 digger derricks built from march 2007 to october 2021. If the pin retainer fails, the pivot pin will still be held in place in the turntable o
- SIL 852 - EQUIPMENT: Altec has learned that the electrohydraulic outrigger/tools control valve on aa755l and a-series aerial devices and dlb, dmb, and d2/3/4000b series digger derricks could have the potential to produce a very small amount of flow into the low
- CSR 539 - FUEL SYSTEM, GASOLINE: Altec industries, inc. Has received notification from an original equipment manufacturer (oem) that a condition exists relating to motor vehicle safety, compliance, or emissions in a vehicle you possess that is equipped with altec equipment
- CSR 532 - PARKING BRAKE: Altec industries, inc. Has received notification from navistar that a condition exists relating to motor vehicle safety, compliance, or emissions in a vehicle you possess that is equipped with altec equipment. On certain trucks equipped
- CSR 529 - SUSPENSION: Altec industries, inc. Has received notification from an original equipment manufacturer (oem) that a condition exists. This condition relates to the operation or customer satisfaction of the unit when equipped with an altec aerial device o
- No comms 2021-12 - UNKNOWN OR OTHER: There are no manufacturer communications in accordance with 49 cfr 579.5 to report for december 2021 for altec industries, inc.