Use the box here to look up VINs from ENTEGRA as well as other manufacturers
Frequently Asked Questions
Are there recalls for the 2011 ENTEGRA Insignia?
- There are 7 recall(s) for the 2011 ENTEGRA Insignia, additional information is below.
NHTSA Mandated Recalls
Recall 115520 [USA]: Unstable entry and exit steps increase the risk of injury.
Entegra coach (entegra) is recalling certain model year 2008 and 2010-2011 aspire and anthem motorhomes, 2008 and 2010 cornerstone motorhomes, 2008 emblem and alante motorhomes, and 2009-2011 insignia motorhomes. The affected vehicles are equipped with certain lippert-brand coachstep double aelectric steps. These steps use a bolt to attach the fan gear assembly to the steps. This bolt may fracture allowing the fan gear to disengage from the steps. As a result, the steps may not remain in the expected position and may become unstable. entegra will notify owners, and dealers will install a retainer bracket on the double step assemblies. On the trip step assemblies, the coachstep linkage assembly will be replaced and a retainer bracket will be installed. The manufacturer has not yet provided a notification schedule. Owners may contact entegra customer service at 1-800-945-4787, or lippert customer service at 1-574-537-8900. Entegra's number for this recall is 9903275. owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.
Recall 78445 [USA]: Improper height on the headlights may not fully illuminate the road surface or may inhibit the ability of motorists to see vehicles which can increase the risk of a crash.
Entegra is recalling certain model year 2010 and 2011 aspire class a motorhomes manufactured from april 22, 2009, through december 23, 2010 for failing to comply with the requirements of federal motor vehicle safety no. 108, "lamps, reflective devices, and associated equipment." the position of the high beam and low-beam headlamps are transposed from their proper position. dealers will disconnect and move the headlamps so that they are in their proper position. This service will be performed free of charge. The safety recall began on february 21, 2011. Owners may contact entegra at 1-800-945-4787. owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov .
Recall 70942 [USA]: The sensing algorithm or thermal switch installed to shut off power to the refrigerator when high temperatures are detected due to a possible hydrogen gas leak may not shut off in sufficient time to prevent a fire.
Entegra is recalling certain fifth wheel trailers equipped with 1200-series norcold refrigerators. The population of refrigerators being addressed contains either a sensing algorithm or thermal switch to shut off power to the refrigerator when high temperatures are detected in order to prevent a potential fire. The response times of the sensor algorithm and thermal switch devices to stop power are not sufficient. entegra is working with norcold to identify and notify any affected owners. Owners will be instructed to contact norcold dealers to receive the remedy free of charge. Please see norcold's defect report 10e-049 for additional information. The recall began on january 25, 2011. Owners may contact norcold at 1-800-767-9101. owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov .
Recall 2016017 [Canada]: Accessories
On certain motorhomes equipped with lippert components inc. Electric entry steps, an internal bolt on the steps that attaches the fan gear assembly to the steps could fracture. This results in the fan gear disengaging from the steps, which could cause the steps to stop in an unexpected position and appear to be loose or unstable. If the steps become unstable, it could cause a person to fall, resulting in injury. Correction: dealers will install a step retainer bracket to reinforce the operating mechanism, and all bolts of the mechanism will also be replaced.
Recall 2013005 [Canada]: Electrical
On certain vehicles, the connector for the brake and cruise control signal diode jumper assembly may come loose, resulting in a possible intermittent or continuously open circuit. Two circuits are potentially affected. One circuit disengages the cruise control with brake pedal application, and the other circuit illuminates the brake lights with brake application. Failure of the cruise control to disengage, or of the brake lights to illuminate when the brake pedal is depressed, could result in a crash causing property damage and/or personal injury. Correction: dealers will verify that the locking tabs on the diode jumper assembly connector are fully engaged and locked into place.
Recall 2012132 [Canada]: Engine
On certain motorhomes equipped with a cummins engine, the v-band clamps used to connect the inlet and outlet cone sections to the diesel oxidation catalyst (doc) / diesel particulate filter (dpf) include a t-bolt which can fracture and fail when subjected to stress or load. A fracture or failure of the t-bolt may cause the clamp to loosen and the inlet or outlet sections attached to the doc/dpf housing to disconnect. Should this occur, hot exhaust gases can vent prior to exiting the tailpipe, creating a risk of combustion or damage to adjacent materials, which could result in a vehicle fire. If both clamps fail, the doc/dpf housing could detach completely, separate from the vehicle, and strike another vehicle, stationary object, or bystander. These issues could result in property damage and/or personal injury. Correction: cummins will install updated v-band clamps.
Recall 2012097 [Canada]: Accessories
Certain motorhomes equipped with a spartan chassis may experience an unintended increase in vehicle speed after the cruise control is set. Then, if the brake is applied and released, cruise control function may resume and the vehicle speed may continue to increase. An unexpected moderate increase in vehicle speed may go unnoticed by the driver and, depending on traffic and road conditions, and the driver's reactions, could result in a crash causing property damage and/or personal injury. Correction: owners are advised to contact spartan motor chassis, inc. At 800-393-8861, to locate an authorized repair facility. The remedy consists of replacing the cruise control switch and reprogramming the control module.
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.
Bulletins
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
SRP 24-004 - EQUIPMENT: Standard repair procedure (srp) if vanity, kitchen, and dinette slide outs need to be loosened for alignment. Instructions on how to adjust slide system. Craig welding system.
INC 22-067 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Jayco and entegra coach storage tips. Instructions for storing jayco and entegra coach diesel pushers.
INC 22-066 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Process for cleaning soiled carpet. Carpet cleaning recommendations
SRP 22-053 - EQUIPMENT:ELECTRICAL: False warning on dash for the jayco/entegra coach harness into spartan chassis harness. Instruction for diode installation for park brake ground wire.
INC 22-054 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : (inc) informational communication on when to sanitize the fresh water system.
INC 21-038 - EQUIPMENT:MECHANICAL:INTEGRATED JACK/LEVELER/STABILIZER: Equalizer leveling jack manual override procedure. Instructions for override mode on equalizer leveling system.
20-034 INC - EQUIPMENT: Informational communication (inc) when replacing united brand shade motor with mcd motor, the united shad bracket requires modification to fit the mcd motor.
20-016 INC - EQUIPMENT: Steps to find and correct air noise from or around the ptl entrance doors on motorhomes.
19-025 - LATCHES/LOCKS/LINKAGES: Baggage doors may leaking due to incorrect o-ring installed in handle