Kia Sedona 2005

• Recall 36364 [USA]: This can cause the cable to stick, thus preventing the engine from returning to idle and causing the vehicle to maintain speed or accelerate. such an event can occur without warning and could cause a crash.
  On certain mini vans, freezing conditions can cause water on the throttle cable to freeze during normal operation. Resistance to movement of the throttle cable can occur when the driver lifts their foot off of the gas pedal.
  dealers will modify a protective sleeve around the throttle cable. The recall began on august 15, 2005. Owners may contact kia at 1-800-333-4542.
  kia recall no. Sc-051.Customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236; (tty: 1-800-424-9153); or go to http://www.Safercar.Gov.

  Show Content

• Recall 36628 [USA]: Wheel bearing failure may occur without warning which could result in a crash.
  On certain mini vans equipped with alloy wheels, moisture can accumulate around the rear hub caps causing damage to the outer wheel bearing.
  dealers will replace the rear hub caps free of charge. Upon inspection, some vehicles will also require replacement of the rear outer bearings and/or hub assembly. The recall began on june 13, 2005. Owners may contact kia at 1-800-333-4542.
  kia recall no. Sc-049. Customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov.

  Show Content

• Recall R/2020/187 [UK]: Water or oil may enter the hydraulic electronic control unit
  Water or oil may enter the hydraulic electronic control unit over a long period of time causing an electrical short circuit.
  install a relay to isolate the hecu when the ignition is switched off.

  Show Content

• Recall R/2014/012 [UK]: Front suspension arm may fail
  The front suspension lower suspension arms may corrode due to insufficient coating of the steel on the inner surfaces. Excessive corrosion could cause weakening of the arms (thinning of metal). Gradual weakening of the lower suspension arms. Customers are unlikely to notice any symptoms but may notice juddering from suspension area. Ultimately the arm could fracture.
  the front suspension lower arms will be checked for corrosion and the thickness of the steel measured. If the thickness of the steel is sufficient the cavities will be filled with cavity wax to prevent corrosion. If the thickness of the steel is below the minimum the arms will be replaced.

  Show Content

• Recall R/2016/197 [UK]: Bonnet catch may fail
  Affected vehicles may suffer surface corrosion that could cause the secondary bonnet latch to remain in the open position when the bonnet is closed. Under these circumstances if the bonnet has not been properly and fully closed in the lock position the bonnet may open while driving and obscure the driver?S vision
  replace bonnet catch on affected vehicles.

  Show Content

• Recall 2005165 [Canada]: Other
  On certain vehicles equipped with alloy wheels, moisture can enter the rear hub and cause damage to the wheel bearing. In certain conditions, this can result in wheel bearing failure which could lead to a loss of vehicle control. Correction: dealers will inspect and, if necessary, replace the hub assemblies.

  Show Content

• Recall 2005228 [Canada]: Engine
  On certain vehicles, water may enter between a protective rubber sleeve and the throttle cable towards the rear portion of the cable. If the ambient temperature drops below zero degrees celsius, the water could freeze, causing the throttle to stick and the vehicle to accelerate unexpectedly. Correction: dealers will modify the throttle cable rubber sleeve.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

The following is a list of any known keyfobs for the Kia Sedona 2005 as well as their FCC IDs if available

• OR-KIA014: 2003-2005 Kia Sorento Sedona / 3-Button Keyless Entry Remote / PN: 95430-3E101 / PLNBONTEC-T009 (OEM Refurb)
  FCC ID: PLNBONTEC-T009

The ga recoal bot never fxe

The ga recoal bot never fxe

Tl* the contact owned a 2005 kia sedona. While parked at the contact's residence, the vehicle caught fire underneath the hood and inside the vehicle. The fire department extinguished the fire. The vehicle was totaled. The dealer and manufacturer were not contacted. The cause of the failure was not determined. The failure mileage was 200,000. *as photos attached *jb

My 2005 kia sedona was parked in my garage and it caught fire in the dash in front of the steering wheel. That is where the fire department said it started. It was a total loss, only had 115,000 miles, no issues. Thank god it was at 8 am and we were awake, earlier my whole family and our home may have been gone as well.

My kia sedona starts when it wants to. I have power to the dash lights, radio, and other electronics. The company has known about this issue since the 2002 version and with high miles. It has to deal with the "an issue with the factory vehicle immobilizer control module can cause the vehicle to think it is being stolen. This will immediately disallow the vehicle from starting.". While this is good most of the time, it isn't good since it doesn't set off the "engine light" so mechanics can read the computer. I have been without my vehicle for a month and missed numerous days of work due to this issue. The mechanics that attempt to work on my vehicle, can not get it to duplicate the "not starting", it will start every time for them. Making me feel like an idiot. This problem has been going on for two months and it draining my finances. I did some research of my own and discovered that on www.Repairpal.Com has many who have the same issues. Kia wants me to take the vehicle to the nearest kia dealer to have it checked out. The nearest dealer is 6 hrs away and there is no guarantee that it would make it there. I couldn't even drive it 2 hrs with out an issue. I feel since they knew there was an ongoing issue with this module on this vehicle, they should have to replace it and make compensation for the customer.

While driving at approx 55mph on both a 2 lane hwy and the interstate hwy, the van would suddenly make a loud bang sound, jump, and the rpms would go up to over 4000 and sound like it was in 2nd gear. Eng light code said intake trans sensor, which i had replaced. Same problem happend 2 more times after that and still not fixed.Will work for a while after shutting car off and restarting it but same problem happens after about 20 miles. Code still reads intake sensor problem each time. I tried using off brand sensors the first 2 times and an authentic kia sensor the 3rd time. There was no difference in performance, just the cost of the parts.

My air bag light is on and i talk to kia about it they want to charge me a price for to take it off i hae a wheel bearing promble to. I had to get my wheel bearing repair to.

I was driving on route 55 with my 2yr old daughter and i was going 70mph when the tread separated from the tire causing my car to fishtail in between both lanes on the highway until i was able to gain control again and got my car to the shoulder of the highway. The defective tire is a firestone wilderness ht 225/70r15

Stalls with no warning all speeds all weather conditions..Engine hot or cold..Starts right back up..Very dangerous

Common OBD-II Error Codes

• P1330 [1] Incorrect function of changing the ignition advance angle - cylinder anti-knock system 5
• P2135 [1] Throttle/Pedal Pos Sensor/Switch A / B Voltage Correlation
• P0638 [1] Throttle Actuator Control Range/Performance (Bank 1)
• P0446 [1] Evaporative Emission Control System Vent Control Circuit Malfunction
• P2422 [1] Evaporative Emission System Vent Valve Stuck Closed