Mack Dmm 1988
Vehicle Details: Recalls, Decoded VIN Details, Service Bulletins
Use the box here to look up VINs from MACK as well as other manufacturers
Sub-models: - Dmm Series -
-
Where is the 1988 MACK Dmm produced?
- The 1988 MACK Dmm is produced in Winnsboro South Carolina, United States (usa).
-
Are there recalls for the 1988 MACK Dmm?
- There are 11 recall(s) for the 1988 MACK Dmm, additional information is below.
-
What is the GVWR of a 1988 MACK Dmm?
- The 1988 MACK Dmm has a GVWR of Class 8: 33,001 lb and above (14,969 kg and above) lbs.
Recall 19554 [USA]: In the event the primary throttle return fails, failure of the secondary throttle return system would not provide protection against loss of throttle control.
Recall 23426 [USA]: Steering arm could fail without warning resulting in loss of steering control and possibly a crash.
Recall 25272 [USA]: Under certain conditions, hose could fail resulting inloss of power steering assist and possibly an accident.
Recall 25286 [USA]: This could result in loosening and failure of the boltswith possible loss of control and accident potential.
Recall 25942 [USA]: Failure of one or both brackets could cause dislocationof engine and transmission assembly, which could result in truck disablement,possible loss of accelerator control and an accident.
Recall 26936 [USA]: This would allow the pitman arm to come off the steeringgear sector shaft and result in immediate loss of steering control and a vehiclecrash could occur.
Recall 27823 [USA]: If clamp plate breaks, yoke would fly off at detachedpoint and could injury anyone struck by flying fragments. also, the detachedinner shaft could interfere with the brake system air supply hoses and tractortires, which could result in loss of truck control and an accident.
Recall 1990005 [Canada]: Steering
Recall 1990038 [Canada]: Steering
Recall 1989032 [Canada]: Suspension
Recall 1988117 [Canada]: Steering
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- KC-2112 - ENGINE AND ENGINE COOLING: Programming failure - chassis with cummins engine and an allison transmission
- KC-2143 - VEHICLE SPEED CONTROL: (back office) - cruise control inoperative after updating software vecu5 without esp package (uesp).
- KC-745 - POWER TRAIN: Automated manual transmission ( amt ) i-shift / mdrive - ribbon harness replacement - speed sensor bolts, possible fault codes P1058 - 21 or mid 130 pid 161 fmi 1
- KC-750 - ENGINE AND ENGINE COOLING: Us10 emission engines - diagnostic trouble code ( dtc ) spn 1231 fmi 9 troubleshooting.
- KC-663 - ENGINE AND ENGINE COOLING: Emcon (spark assist) engine aftertreatment system troubleshooting check sheet - us07 emissions
- KC-653 - ENGINE AND ENGINE COOLING: Low oil pressure diagnostic process for 11 liter engines
- KC-627 - EQUIPMENT: Premium tech tool ( ptt ) training materials and support tools
- KC-2172 - ELECTRICAL SYSTEM: No start condition after over the air programing - vecu5 no start "safe state"
- KC-2171 - ENGINE AND ENGINE COOLING: Temperature sensor troubleshooting guide - us10+obd13 and newer
- KC-2170 - SUSPENSION: Electronically controlled suspension (ecs) losing air pressure
- KC-2169 - ELECTRICAL SYSTEM: Low voltage disconnect (lvd), function description
- KC-2165 - ENGINE AND ENGINE COOLING: Def pump troubleshooting guide - us10+obd13 and newer emissions
- KC-2161 - ENGINE AND ENGINE COOLING: Def pump cycling periodically hours after key off
- KC-2158 - ENGINE AND ENGINE COOLING: Selective catalytic reduction (scr) muffler troubleshooting guide - us10+obd13 and newer emissions
- KC-2131 - ENGINE AND ENGINE COOLING: Use for new vehicles (us21+obd22 emissions) - intermittent diagnostic trouble codes U02A3, U029D, U029E
- KC-2116 - ENGINE AND ENGINE COOLING: Nox sensor troubleshooting guide - us10+obd13 and newer emissions
- KC-626 - POWER TRAIN: Mack chassis - vehicles equipped with an automated manual transmission model f ( amt-f, mdrive ), premium tech tool ( ptt ) gearbox calibration failure; gearbox calibration operation stops and fails at 33% when run with transmission removed
- KC-648 - UNKNOWN OR OTHER: Mack - pto pump speed calculator
- KC-686 - VEHICLE SPEED CONTROL: (back office only) mack chassis - cruise control inoperative after disabling the electronic stability program (esp)
- KC-698 - ENGINE AND ENGINE COOLING: Mack chassis - diesel exhaust fluid ( def ) system cleaning/flush after def pump failure or system contamination
- KC-699 - ELECTRICAL SYSTEM: Mack chassis - bendix vendor configuration program ( vcp ) software download information
- KC-714 - ENGINE AND ENGINE COOLING: Mack chassis - diagnostic trouble codes ( dtc's ) - P020113, P020213, P020313, P020413, P020513, P020613, cylinders 1 through 6 injector a open circuit
1 Results returned successfully. NOTE: Any missing decoded values should be interpreted as NHTSA does not have data on the specific variable. Missing value should NOT be interpreted as an indication that a feature or technology is unavailable for a vehicle.
Variable | Value |
---|---|
Additional Error Text | Unused position(s): 6,7; The Model Year decoded for this VIN may be incorrect. If you know the Model year, please enter it and decode again to get more accurate information. |
Body Cab Type | MDHD: CBE (Cab Behind Engine) |
Body Class | Truck |
Brake System Type | Air |
Error Code | 0,14 |
Error Text | 0 - VIN decoded clean. Check Digit (9th position) is correct; 14 - Unable to provide information for some of the characters in the VIN, based on the manufacturer submission. |
GVWR | Class 8: 33,001 lb and above (14,969 kg and above) |
Make | MACK |
MakeID | 490 |
Manufacturer | MACK TRUCKS INC. |
Manufacturer Id | 1027 |
Model | DMM |
ModelID | 9457 |
Model Year | 1988 |
NCSA Body Type | Single-unit straight truck or Cab-Chassis (GVWR greater than 26,000 lbs.) |
NCSA Make | Mack |
NCSA Model | Medium/Heavy - CBE |
Plant City | WINNSBORO |
Plant Country | UNITED STATES (USA) |
Plant State | SOUTH CAROLINA |
Series | 600 |
VIN | 1M2E126C5JW004152 |
Vehicle Descriptor | 1M2E126C*JW |
Vehicle Type | INCOMPLETE VEHICLE |
VIN | Year | Model | Manufactured In |
---|---|---|---|
1M2E126C5JW004152 | 1988 | DMM | WINNSBORO SOUTH CAROLINA, UNITED STATES (USA) |