Prevost H3 Vip 2008
Vehicle Details: Recalls, Service Bulletins
Below you will find all available information on the 2008 PREVOST H3 Vip.
| Manufacturer | Known WMI(s) | Fuel Type |
|---|---|---|
| PREVOST |
PREVOST VIN Decoder
Use the box here to look up VINs from PREVOST as well as other manufacturers
Frequently Asked Questions
-
Are there recalls for the 2008 PREVOST H3 Vip?
- There are 2 recall(s) for the 2008 PREVOST H3 Vip, additional information is below.
NHTSA Mandated Recalls
Recall 101804 [USA]: Once electrically conductive, the material is capable of melting and burning, increasing the risk of a fire.
Recall 99638 [USA]: If the springs break, the pedal may not return to idle once the driver lifts their foot off the pedal. this unintended acceleration increases the risk of a crash.
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.
Bulletins
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- MI16-32 - ENGINE AND ENGINE COOLING: Improved bearings are now available to replace the original bearings used on some prevost vehicles idler pulleys.
- IS-21072B - ELECTRICAL SYSTEM: Steering gateway. Revision b - pin 2 and 10 were inverted on connector a139
- MI22-12B - SERVICE BRAKES, AIR: Air tanks draining sequence. Revision: b - general update
- MI22-12A - SERVICE BRAKES, AIR: Air tanks draining sequence. Revision: a - erroneous secondary & accessory tanks location.
- MI22-12 - SERVICE BRAKES, AIR: Air tanks draining sequence
- IS-17151C - EXTERIOR LIGHTING: Halogen to led fog light replacement kit. Revision: c - advanced kits canceled
- MI20-08C - EQUIPMENT: Storage and startup guidelines : part number updates
- IS20-925A - VISIBILITY: Central hvac merv filters installation
- MI20-08C - STRUCTURE: Storage and startup guidelines: periodically, circumstances arise requiring operators to temporarily park a coach in storage. Whether it is a few weeks or several months, sporadic out of service times or a full stop, prevost recommends foll
- IS-20925A - POWER TRAIN: Central hvac merv filters installation reva
- IS-18091A - STEERING: Tie rod 610052 first installation instructions: use these instructions when replacing the drop joint tie rod on s82, s84 / s84u i-beam axles. The new tie rod will be adjusted to the length of the original; however, a steering alignment ne
- MI20-19B - EQUIPMENT: Introducing a new engine coolant into prevost service center network
- IS-13106A - STRUCTURE: Slide-out linear bearing and guides kit
- MI20-19A - EQUIPMENT: Rev a: mention added concerning ddc series 60 engine sca requirement
- MI20-19 - EQUIPMENT: Introducing a new engine coolant into service
- MI20-08B - EQUIPMENT: Storage and startup guidelines revision: b parts added to suggested material 08-10-2020
- IS-20922 - SEATS: Sigma passenger seats partition kit
- MI20-12 - STEERING: Jerky, noisy or hard to turn steering gearbox. Hydraulic end limiter adjustment. All models ⿿ equipped with rb bosch/zf servocom or servocomtronic steering gearbox
- MI20-08A - EQUIPMENT: Storage and startup guidelines: rev a: 21516229 replaced by 23381562 20523393 replaced by 21454749 800383 removed 611471 replaced by 611360 70376808 replaced by 21036050 21396642 replaced by 20967831
- MI20-09 - EQUIPMENT:OTHER:LABELS: Prevost vehicle disinfection procedure
- MI20-08 - UNKNOWN OR OTHER: Storage and startup guidelines - all prevost vehicles & volvo 9700
- IS-19064 - STRUCTURE: Baggage door seal replacement
- MI15-24 - ELECTRICAL SYSTEM: Added: power cables for l.H. Side alternator & fan drive breaker box
- IS-19092 - ELECTRICAL SYSTEM: This instruction sheet explains how to install 780428 door actuator replacement.
- IS-17906A - ENGINE (PWS): This instruction sheet explains how to install an eld interface kit for prevost vehicles equipped with multiplex detroit diesel engines
- IS-11003G - EQUIPMENT: This instruction sheet explains how to replace the ?Master id? With ?Mcm? Module
- IS-11003F - ELECTRICAL SYSTEM: This instruction sheet explains how to replace the "master id with mcm" module
- IS-17906 - FUEL SYSTEM, DIESEL: This instruction sheet explains how to install an eld interface kit for prevost vehicles equipped with multiplex detroit diesel engines
- SP13-44 - ELECTRICAL SYSTEM: The light switch may operate incorrectly when doors are closed for vehicles affected by this bulletin. Corrective action is presented.
- MI13-33 - SUSPENSION:MULTIPLE AXLE:TORQUE ARM: This maintenance information explains that polyester reinforced silicone hoses and elbowscan be repalced by aramid reinforced hoses and elbows for improved long term durability, and that constant torque hose clamps for silicone hoses with 5
- MI15-18 - EQUIPMENT: This maintenance information does explain how five year old vehicles and older should be subjected to a thorough structural inspection.
- MI15-24 - EQUIPMENT: This maintenance information explains how to perform an inspection of the vehicle power cables. Power cables in poor condition can be the cause of failures and serious damages in the engine compartment.
- Mi16-15 - TIRES:PRESSURE MONITORING AND REGULATING SYSTEMS: The beru sensors used on prevost vehicles to monitor tire pressure (tpms system) are being replaced by new huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, repla
- MI16-15B - EQUIPMENT:RECREATIONAL VEHICLE/TRAILER:LPG SYSTEMS:TANK VALVE/GAUGE: The beru sensors used on prevost vehicles to monitor tire pressure (tpms system) are being replaced by new huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, repla
- MI16-22 - EQUIPMENT:ELECTRICAL: Use this maintenance information procedure to resolve an undesired behaviour on 2008-2012 vehicles. In sleep mode, certain marker lights may remain illuminated.
- MI16-15A - TIRES:PRESSURE MONITORING AND REGULATING SYSTEMS: The beru sensors used on prevost vehicles to monitor tire pressure (tpms system) are being replaced by new huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, repla
- IS-14085 - EQUIPMENT: This instruction sheet explains how to prevent ac copper pipes chaffing at engine bulkhead
- IS-11003E - ELECTRICAL SYSTEM: This instruction sheet explains how to remplace master id? With ?Mcm? Module
- IS-17901 - BRAKES (PWS): This instructions sheet explains how to program a wabco smart trac abs ecu.
- IS-14130 - EQUIPMENT:APPLIANCE:AIR CONDITIONER: This instruction sheet explains how to use retrofit kit for obsoleted small ac condensers (950018 & 950335)
- IS-13158 - EQUIPMENT:ELECTRICAL: This instruction sheet explains how to install keyless keypad using either kit 069140 or 069141
- IS-12143B - ENGINE AND ENGINE COOLING:ENGINE:DIESEL: This instruction sheet explains how to retrofit the def tank left side filler neck on h3 vip motorhomes with central or small a/c system