NTB-12-028
Service Bulletin Details
Public Details for: NTB-12-028
Nissan: power steering hose service part change. The hose now comes without the pressure sensor. Do not damage pressure sensor upon removal. If only pressure sensor needs replacement, do not replace hose. *js
- 2012 - 2011 - 2010 - 2009 - 2008 - 2007 - 2006 - 2005 - 2004 -
Models from 2012
2012 NISSAN ARMADA |
2012 NISSAN TITAN |
Models from 2011
2011 NISSAN ARMADA |
2011 NISSAN TITAN |
Models from 2010
2010 NISSAN ARMADA |
2010 NISSAN TITAN |
Models from 2009
2009 NISSAN ARMADA |
2009 NISSAN TITAN |
Models from 2008
2008 NISSAN ARMADA |
2008 NISSAN TITAN |
Models from 2007
2007 NISSAN ARMADA |
2007 NISSAN TITAN |
Models from 2006
2006 NISSAN ARMADA |
2006 NISSAN TITAN |
Models from 2005
2005 NISSAN ARMADA |
2005 NISSAN TITAN |
Models from 2004
2004 NISSAN ARMADA |
2004 NISSAN TITAN |
SB-10043772-8780 Classification : Referen ce: ST11-007 D ate: NTB12-028 March 22, 2012 ARMADA AND TITAN; POWER STEERING HOSE SERVICE PART CHANGE APPLIED VEHICLES: 2004-2012 Armada (TA60) 2004-2012 Titan (A60) SERVICE INFORMATION If the high pressure hose on an Applied Vehicle needs to be replaced for any reason: • The hose now comes without the pressure sensor (refer to page 2). • When replacing this hose, reuse the existing pressure sensor. Replace the pressure sensor ONLY IF there is a pressure sensor related issue. • Do not replace other related hoses unless necessary (i.e., do not replace as a set). • Do not damage the pressure sensor during removal or installation. • Always use a new O-ring when installing a new or existing pressure sensor (refer to page 2). • Pressure sensor mounting torque: 19.6 N•m (2.0 kg-m, 14.5 ft lb) • If only the pressure sensor needs replacement, do not replace any hoses. • Always replace both copper washers (mounted at the power steering pump). CAUTIONS: ¾ Do not allow dirt or contamination to enter the hydraulic system. ¾ Always secure the pressure sensor mounting block in a soft jaw vise when removing and installing the pressure sensor. Do not clamp onto the “banjo” end of the hose. • Refer to the appropriate Electronic Service Manual (ESM) for power steering hose removal, installation, and torque specifications. PARTS INFORMATION DESCRIPTION HOSE & TUBE ASSY-PRESS, PS (1) GASKET-CONNECTOR (COPPER WASHER) SEAL – O-RING HOSE WITH SENSOR 49720-7S000 SEN ASSY-PRESSURE, PS HOSE W/O SENSOR 49720-7S00A QTY 1 49726-Y0100 2 49345-6N200 1 49763-6N20A 1 (1) Refer to FAST or your electronic parts catalog to determine the part for your application. Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. 1/2 Mounting block “Banjo” end 2/2 NTB12-028