Mack Ch 2004

• Recall 72736 [USA]: A leak in the fuel injection line may spray fuel on the hot surfaces of the exhaust gas recirculation system, which could result in an engine fire.
  On certain trucks equipped with aset ac model engines, the engine as configured with an external exhaust gas recirculation system makes servicing the fuel injection lines difficult when using traditional tools. Therefore, it is possible for fuel leaks to develop when removing and installing the fuel injection lines.
  dealers will replace the fuel injection lines free of charge. Note: this recall supersedes a previous campaign conducted in 2006 (please see 06v392). The recall began on september 11, 2007, with subsequent mailings every six weeks until april 2008. Owners may contact mack at 800-528-6586.
  mack recall no. SC0324.Customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov.

  Show Content

• Recall 37510 [USA]: This could potentially result in an engine fire.
  On certain trucks, a leak in the aset ac fuel injection line may spray fuel on the exhaust gas recirculation pipes that carry hot exhaust gases .
  mack has issued a stop work on this campaign under further notice (2-22-2007). The remedy does not adequately address the issue on all vehicles. Mack will re-release the recall in the near future. (please see nhtsa no. 07v159/mack recall no. Sco323 for vehicles that have had this repair already performed.) this recall has been superseded (please see 07v401/sC0324).
  mack trucks recall no. SC0317.Customers can also contact the national highway traffic safety administration?S vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov.

  Show Content

• Recall 55178 [USA]: If the hose fails, fuel can be sprayed on the exhaust manifold, which could potentially lead to an engine compartment fire.
  On certain heavy duty class 8 diesel trucks equipped with aset ac engines, the location of the fuel inlet hose may result in overheating or abrasion of the hose, which may lead to a premature failure.
  dealers will repair and replace the fuel inlet hose free of charge. The recall began on february 14, 2005. Due to some quality and supply issues with parts to support this safety recall, owners may have been informed during april 2005,that the safety recall was on hold. These issues have now been resolved. For owners who have not had their vehicle(s) repaired, contact a mack parts and service center immediately to schedule an appointment to have your vehicle(s) repaired. Owners may contact mack trucks at 610-709-2131.
  mack trucks recall no. SC0292.Customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov.

  Show Content

• Recall 56340 [USA]: Failure of two of the three bolts could result in the loss of steering, which could result in loss of vehicle control, increasing the risk of a crash .
  On certain truck chassis, the steering gear mounting bolts were over-torqued at installation. The steering gear is mounted to the vehicle's frame rail with 3 bolts.
  dealers will inspect vehicles. New steering gear mounting bolts will be installed. The recall began october 2004. Owners should contact mack at 1-610-709-3337.
  mack recall no. SC0288.Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 34662 [USA]: This could cause ice buildup on the discharge side of the primary and secondary pressure system allowing the relief system to freeze and become blocked resulting in over pressurization of the lng tanks creating the risk of catastrophic tank rupture which could cause serious injury or death.
  On certain chassis built with lng engines, the nexgen lng tank's primary and secondary relief valves could fail to open and relieve tank pressure.
  dealers will retrofit the lng tanks with a new primary relief valve pipe away tube and a new ventilated shroud. The recall began april 6, 2004. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact mack at 1-610-709-3337.
  mackrecall no sC0287.Customers can contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 2007278 [Canada]: Brakes
  On certain trucks, the engine configuration makes servicing fuel injection lines difficult when using traditional tools. It is possible for fuel leaks to develop following recall campaign 2006258 (mack sC0317) or when line removal is required to gain access to other engine components. Underhood fuel leakage could result in a vehicle fire. Correction: dealers will install an updated fuel injection line that offers better clamping surface when torqued. This will be done using specially designed tools to ensure correct torque is applied.

  Show Content

• Recall 2006258 [Canada]: Fuel supply
  On certain trucks, a leak in the fuel injection line may spray fuel on the exhaust gas recirculation (egr) pipes. The hot egr pipes could ignite the fuel, causing an underhood fire. Correction: dealers will inspect and, if required, replace the fuel injection lines. A protective sleeve will be installed over the lines. Note: recall cancelled, see tc 2007102

  Show Content

• Recall 2005009 [Canada]: Fuel supply
  On certain vehicles, the location of the fuel hose used on the aset ac engine may result in overheating and/or abrasion of the hose, which may lead to a premature failure. If the hose fails, fuel can be sprayed on the exhaust manifold, which could potentially lead to an engine compartment fire. Correction: dealers will replace the fuel inlet hose.

  Show Content

• Recall 2004218 [Canada]: Brakes
  On certain vehicles equipped with 18,000 lb and 20,000 lb front axle assemblies, the front brake chamber is too small to meet the stopping distance requirements of cmvss 121. Correction: dealer will replace the type-20 brake chamber with a larger type-24 brake chamber.

  Show Content

• Recall 2004288 [Canada]: Steering
  On certain vehicles, the steering gear mounting bolts were over-torqued during vehicle assembly and could fail. The steering gear is mounted to the vehicle's frame rail with 3 bolts. Failure of two of the three bolts could result in the loss of steering, increasing the risk of a crash. Correction: dealers will install new steering gear mounting bolts.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.