Oshkosh S Series 1988

Vehicle Details: Recalls, Service Bulletins

Below you will find all available information on the 1988 OSHKOSH S Series.

ManufacturerKnown WMI(s)Fuel Type
OSHKOSH
OSHKOSH VIN Decoder

Use the box here to look up VINs from OSHKOSH as well as other manufacturers

#
Frequently Asked Questions
  • Are there recalls for the 1988 OSHKOSH S Series?
     - There are 2 recall(s) for the 1988 OSHKOSH S Series, additional information is below.
NHTSA Mandated Recalls

  • Recall 23145 [USA]: Persons exiting the cab can trip and fall on upturnededges. also, fatigue or broken bolts could cause the steps to break away at thetime that a person is entering or exiting the vehicles.

  • Recall 28363 [USA]: Separated fan blade could result in bodily injury topersons near by and also could damage the engine, radiator, etc.

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Recalls are also available on the Complaints page
Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • FDM-SVC-030 - FUEL SYSTEM, OTHER:FUEL FILTER: This bulletin provides instruction for installing a hydraulic system charge pump filter.
  • FDM-TSIB-043 - EQUIPMENT: This bulletin provides information on updating hydraulic hose clamping below the cab to match current production. Engineering recommends changing out the front stauff clamp using the following procedure. The second stauff clamp can be cha
  • FDM-TSIB-027 - POWER TRAIN: This bulletin provides information for vehicle owners that have a dana series 172 or 175 rear axle without a lubricant drain plug in the bottom of the axle housing.
  • FDM-TSIB-026 - POWER TRAIN: This bulletin provides instruction for replacing the mixer pump pto shaft, mixer pump input yoke, and mixer pump input yoke bearing u-bolts to the current production configuration. The new pto shaft is larger with greaseable crosses and r
  • FDM-TSIB-025 - EQUIPMENT: This bulletin provides instructions for bolting the water tank mounting feet to the water tank if the bonded feet become loose.
  • FDM-SVC-002 - EQUIPMENT: This bulletin provides instruction for replacing the water pump impeller due to corrosion. Oshkosh has received reports of non-working water pumps due to the pump impeller becoming corroded and seized, causing the pump not to spin. A new
  • FDM-TSIB-024 - ELECTRICAL SYSTEM: This bulletin provides instruction for checking electrical connections at various critical locations. Loose electrical connections can cause false readings and lead to electrical system errors.
  • FDM-TSIB-023 - ELECTRICAL SYSTEM: This bulletin provides instruction on replacing the frame ground stud nut located at the rear of the vehicle on the inside right-hand frame rail. Engineering has changed the nut from a jam nut to a lock nut after receiving reports of the

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.