PIC5650J

Service Bulletin Details

Public Details for: PIC5650J

This preliminary information communication provides information to the technician about vehicles that have an intermittent no crank, no start, or start stall concern with the security light coming on. Technician may find diagnostic trouble


- 2018 - 2017 - 2016 - 2015 - 2014 - 2013 - 2012 - 2011 - 2010 - 2009 - 2008 - 2007 -

Bulletin No.: PIC5650J
Published date: 07/21/2021
Preliminary Information
PIC5650J Diagnostic Tip - Security Light on Intermittently / No
Crank/No Start or Start Stall / Keyless Access Vehicles May Display
No Remote/Fob Detected / Poor or No RKE Range / Service TPM
Models
Brand:
All
Model:
All
Model Years:
2007 - 2022
VIN:
from
All
Engine:
to
All
All
Transmissions:
All
Supersession Statement
This PI was superseded to update the Models and Recommendations / Instructions section . Please discard
PIC5650H.
Condition / Concern
A customer may comment on any of the following complaints:
- Intermittent no crank
- Intermittent no start, or start and stall
- Security / Theft light / Message
- Poor or no RKE range
- Keyless or passive entry/start inoperative
- No Fob Detected message
- Service Tire Pressure Monitor message
- Any of the following DTC's: B3055, B3060, B3935, C0750, C0755, C0760, C0765, and/or C0775.
Note: On vehicles equipped with keyless/passive start, the vehicle will start if the fob is placed in the fob pocket.
In most cases, these concerns cannot be duplicated.
The above systems use Radio Frequency (RF) to transmit information. Some aftermarket devices cause Radio
Frequency Interference (RFI), which can "jam" the radio frequency being transmitted.
Listed below are a number of aftermarket devices that can cause RFI. In many cases, these types of devices will
be attached to the customer's key ring and could be removed from the key ring or from inside the vehicle when
the customer drops the vehicle o for service.
-
Vehicle immobilizer keys from other vehicles
Keyless access transmitters from other vehicles
Interstate/bridge toll passes
Gate/door passes to allow access to pools, driveways, entry doors, etc.
Community/parking access cards
Fuel station speed passes
Building access swipe cards/ transponder devices
Additional items to be aware of:
- Aftermarket LED dome, tail, turn, stop, strip, oor, door, Logo, head lights
In many cases, when the LED lighting is turned on it can interfere with a RF signal. Example, RKE inoperative after the rst
fob button press. When the RKE fob button is pressed the dome lights may turn on, which if equipped with an aftermarket
LED dome light, it can interfere with any additional fob button presses.
- Certain cell phone chargers
- USB power banks
- USB ash lights
- Fans (12 volt or 110 volt)
- Any type of USB, 12 volt or 110 volt chargers
- “Bedazzle Trim Ring” surrounding ignition lock cylinder, shown below (1)
Recommendations / Instructions
Important: Do not replace any parts for this concern prior to duplicating the concern and
reviewing the following information:
Before any in depth diagnosis is performed, question the customer or inspect the vehicle
for any types of aftermarket equipment, like shown above, which could cause RFI. These
items need to removed and/or disconnected from the vehicle.
It is possible to get RFI from transponders or other frequency emitting devices in the area. Aftermarket RFI
meters/sni ers are available that can be utilized as an aid to locate stray RFI signals. It is important to know what
the complaint is and what frequency you are checking. When testing a vehicle for stray RFI signals there are three
common frequencies that are used; 315 MHZ, 433 MHz, and 125 kHz. Make sure the meter you use checks for
frequencies at and around these 3 commonly used frequencies.
315 MHz (RKE and TPM frequency)
433 MHz (RKE and TPM frequency)
125 kHz (Passive entry antennas used on vehicles with passive start/entry)
In some cases, the use of the J 43241 Keyless Entry Tester or EL-52545 Tire Pressure Monitor Sensor and RF
Diagnostic Tools to scan the vehicle for stray RFI signals have been useful. Remember while scanning the vehicle
you may need to turn on and o electrical devices to see if they are causing the RF interference. An example of
this is if a vehicle is equipped with aftermarket LED dome lights. If the dome lights are not on when you scan the
vehicle, no interference will be found.
Important: Dealer should also direct their customers to the appropriate section in the Owner
manuals that references that the device complies with Part 15 of the FCC Rules. Examples, of
where this info may be found depend on the model and/or year. This may be found under
Immobilizer Operation, Keyless Entry, Keyless Access, or Radio Frequency Statement
sections.
© 2021 General Motors. All Rights Reserved.


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.