34-093
Service Bulletin Details
Public Details for: 34-093
34-093 model 389 78-inch sleeper 12v power port supplier change
- 2023 - 2022 - 2021 - 2020 - 2019 - 2018 - 2017 - 2016 - 2015 - 2014 -
Models from 2023
2023 PETERBILT 389 |
Models from 2022
2022 PETERBILT 389 |
Models from 2021
2021 PETERBILT 389 |
Models from 2020
2020 PETERBILT 389 |
Models from 2019
2019 PETERBILT 389 |
Models from 2018
2018 PETERBILT 389 |
Models from 2017
2017 PETERBILT 389 |
Models from 2016
2016 PETERBILT 389 |
2016 PETERBILT 389G |
Models from 2015
2015 PETERBILT 389 |
Models from 2014
2014 PETERBILT 389 |
2014 PETERBILT 389K |
34-093 Model 389 78-inch Sleeper 12V Power Port Supplier Change 11/10/2022 Edit Clone 34-093 34-093 Model 389 78-inch Sleeper 12V Power Port Supplier Change Subject 34-093 Model 389 78-inch Sleeper 12V Power Port Supplier Change Whats New Abstract Information Only Model 389 equipped with a 78-inch sleeper, control panel 12V power port supplier change. Condition S leeper control panel 12V power port part obsoletion has resulted in the need to source a new supplier for the 12V power ports. This new part will be required only in the event that the original 12V power port requires replacement. Chassis Affected Model 389 chassis equipped with a 78-Inch sleeper Action Information Only This bulletin is to provide information for a 12V power port part number change and jumper harness requirement for Model 389 chassis with a 78-inch sleeper. Parts Parts are available from PACCAR Parts. Quantity Part Number 1 U926137 Jumper 1 U186007 Bezel 1 P226007 Power Port 1 P226006 Cap Description Background The original sleeper control panel 12V power port is no longer available. New 12V power ports are available from a new supplier. The new 12V power ports are compatible with the control panel, but the electrical connectors are different. This change requires a jumper harness to combine the original power port harness to the main sleeper harness. Obsoleted 12V power port part numbers: • 18-02859 – Power Port • 17-02745 – Bezel Procedure Please follow your dealership's safety procedures and precautions to ensure the vehicle can be safely repaired and maintained. To replace the electrical side for the new Casco power port: 1. Cut the harness for the old power port 15mm behind the protective insulation on each side using a wire cutter/crimper. 2. Insert both ends of the harness into a butt-splice connector, attaching the respected circuits between the two harnesses: RED6953-1, ORN6120-3, and WHIT1130-5. 3. Crimp both sides of the butt-splice connector, then heat shrink the butt-splice connector until it is snug around the wire. Attachments Authored by D. Cook