A012341201475312
Service Bulletin Details
Public Details for: A012341201475312
This bulletin contains instructions for when to add gasoline additives for cleaning the injectors.
- 2019 - 2018 - 2017 - 2016 - 2015 - 2014 - 2013 - 2012 - 2011 - 2010 - 2009 - 2008 -
Models from 2019
Models from 2018
Models from 2017
Models from 2016
Models from 2015
Models from 2014
Models from 2013
Models from 2012
Models from 2011
Models from 2010
Models from 2009
Models from 2008
2008 AUDI A3 |
2008 AUDI A4 |
2008 AUDI A4 CABRIOLET |
2008 AUDI A5 |
2008 AUDI A6 |
2008 AUDI A8 |
2008 AUDI Q7 |
2008 AUDI R8 |
2008 AUDI RS4 |
2008 AUDI S4 |
2008 AUDI S5 |
2008 AUDI S6 |
2008 AUDI S8 |
2008 AUDI TT |
Technical Service Bulletin 01 MIL on (gasoline quality), DTCs for misfire, air/fuel ratio imbalance, or lean fuel system stored in the ECM P300000 01 23 41 2014753/12 February 6, 2023. Supersedes Technical Service Bulletin Group 01 number 20-54 dated April 1, 2020, for reasons listed below. Model(s) Year All Audi Vehicles 2000 – 2019 VIN Range Vehicle-Specific Equipment All Not Applicable Condition REVISION HISTORY Revision Date Purpose 12 - Revised Warranty (Updated Labor Operations) 11 04/01/2020 Revised Required and Tools (Changed to Shop Supply) 10 03/06/2020 Revised title Revised header (Added model years) Revised Technical Background (Added information) Revised Service (Added information for model years added and added part number) Revised Warranty (Added part number and table for 2016-2019 vehicles only and Claim Types) The use of contaminated gasoline or gasoline with a low content of deposit control additives may result in one or more of the following conditions: • Excessive accumulation of deposits on intake valves, intake manifold, fuel injectors, and combustion chambers. • Engine running rough after cold start. • Excessive engine cranking time. • Hesitations while driving. • Rough engine idle. • Reduced engine performance. • Poor fuel economy. Workshop findings: Conditions may be severe enough to illuminate the MIL in conjunction with storage of DTCs in engine control module (ECM), J623 (address word 0001) for one or more of the following concerns: Page 1 of 5 © 2023 Audi of America, Inc. All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the publisher. Technical Service Bulletin • Misfires (example: DTC P0300 and P030x). • Lean fuel system (example: DTC P0171, P0174, P1128, P1130, P1136, and P1138). • Air/fuel ratio imbalance (example: DTC P219C00, P219D00, P219E00, P219F00, P21A000 or P21A100). Technical Background • Condition may be caused by use of contaminated gasoline. • Condition may be caused by use of gasoline with a low content of deposit control additives. For MY16-MY19 3.0TFSI EVO (CREC) equipped vehicles: Because of deviations in the country-specific fuel quality deposits can form in the injectors preventing their complete closure. After switching off the vehicle fuel can get into the lower intake manifold or cylinder which makes the mixture too rich for the subsequent start. Do not replace injectors for this issue. Production Solution Not applicable. Service For MY16-MY19 3.0TFSI EVO (CREC) equipped vehicles, and If deposits in the injector is suspected: Use the multi-purpose additive for gasoline according to the guidelines to remove any deposits on the low and high pressure injector and to ensure their tight closure. Do not replace injectors for this issue. Use additive first then continue with further diagnosis if the issue persists. If use of contaminated gasoline is suspected: Consider advising the customer to change gasoline source (brand/gas station). Contaminated gasoline may exhibit one or more of the following characteristics: • May have unique color and odor. • May contain undissolved water. • May contain sediments and suspended matter. • May appear cloudy and (after settling) may show signs of separation. If use of gasoline with a low content of deposit control additives is suspected: Recommend to the customer the exclusive use of TOP TIER Detergent Gasoline, which provides improved deposit control performance. At the time of this publication, retailers in the USA providing TOP TIER Detergent Gasoline in all grades of their gasoline include: Page 2 of 5 © 2023 Audi of America, Inc. All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the publisher. Technical Service Bulletin • 76 Stations • Holiday Stationstores, Inc. • Rebel Oil • Aloha Petroleum • Kwik Trip / Kwik Star • Road Ranger • Chevron • MFA Oil Co. • Severson Oil • Conoco • Mileage Stations • Shell • CountryMark • Mobil • Texaco • Entec Stations • Ohana Fuels • Tri-Par Oil Co. • Exxon • Phillips 66 • U.S. Oil • Hawaii Fueling Network • Quik Trip For the most up-to-date list of TOP TIER retailers, visit www.toptiergas.com. Repair: Gasoline additive G 001770A2 can be used for removal of existing carbon deposits from: • Injectors (MPI and FSI engines). • Combustion chambers (MPI and FSI engines). • Intake valves (MPI engines only). Mix the additive with gasoline directly in the full fuel tank following the mix ratio. For example, 60 ml per 20 liters gasoline or 120 ml per 10 gallons of gasoline. For MY16-MY19 3.0TFSI EVO (CREC) equipped vehicles use additive G 001780M3 (200 ml). Tip: For removal of carbon deposits from intake valves of FSI engines, refer to TSB 2019948: 01 MIL on (P0300 and/or P0301 - P0306 stored in ECM). Warranty Claim Type: • 110 up to 48 Months/50,000 Miles. • G10 for CPO Covered Vehicles – Verify Owner. • If the vehicle is outside any warranty, this Technical Service Bulletin is informational only. Service Number: 2020 Damage Code: 0010 Page 3 of 5 © 2023 Audi of America, Inc. All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the publisher. Technical Service Bulletin Labor Operations: 60 Mile test drive (includes compensation for gasoline) 0121 0199 140 TU Diagnostic Time: GFF 0150 0000 Time stated on the diagnostic protocol (Max 20 TU) Road test prior to the service procedure No allowance 0 TU Road test after the service procedure No allowance 0 TU Claim Comment: As per TSB 2014753/12 All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures Manual. Claims are subject to review or audit by Audi Warranty. Note: The use of gasoline additive G 001770A2 is not reimbursed under warranty. Required Parts and Tools Always check with your Parts Department and/or ETKA for the latest information and parts bulletins. Part Number Part Description Quantity See ETKA Fasteners, Bolts, Nuts, and Screws as needed per the Repair Manual See ETKA/ELSA G 001780M3 (2016 – 2019 only) Additive Shop Supply Additional Information The following Technical Service Bulletin(s) will be necessary to complete this procedure: • TSB 2019948, 01 MIL on (P0300 and/or P0301 - P0306 stored in ECM). All parts and service references provided in this TSB (2014753) are subject to change and/or removal. ©2023 Audi of America, Inc. All rights reserved. The information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of America, Inc., its affiliated companies, and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may Page 4 of 5 © 2023 Audi of America, Inc. All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the publisher. Technical Service Bulletin these materials be modified or reposted to other sites, without the prior expressed written permission of the publisher. Page 5 of 5 © 2023 Audi of America, Inc. All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the publisher.