Ducati Monster S4 R 2006
Vehicle Details: Investigations, Consumer Complaints, Decoded VIN Details, Service Bulletins
Use the box here to look up VINs from DUCATI as well as other manufacturers
-
Where is the 2006 DUCATI Monster S4 R produced?
- The 2006 DUCATI Monster S4 R is produced in Bologna, Italy.
-
What is the GVWR of a 2006 DUCATI Monster S4 R?
- The 2006 DUCATI Monster S4 R has a GVWR of Class 1A: 3,000 lb or less (1,360 kg or less) lbs.
-
How much horsepower does the 2006 DUCATI Monster S4 R have?
- The 2006 DUCATI Monster S4 R has 82 horsepower.
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- SRV-SRB-24-001 - SUSPENSION: Procedure for assessing front fork oil leaks. Applicability: all models. This service repair bulletin informs dealers and service managers of the assessment criteria for identifying front fork-related defects. The purpose is prevent technic
- SRV-SRB-23-037 - POWER TRAIN: Finial drive chain maintenance precautions. Applicability: all models and model years (except xdiavel). This service bulletin replaces and cancels the previous bulletins: srv-srb-18-030 published on 05/11/2018, srv-srb-19-046 published on
- SRV-SRB-23-036 - SERVICE BRAKES, HYDRAULIC: Guided diagnosis for front brake system bleeding. Applicability: all models. This service bulletin replaces and cancels the previous bulletin srv-srb-20-014 published on 4/17/2020. It provides dealers and service managers with needed info
- SRV-SRB-23-018R1 - ENGINE AND ENGINE COOLING: Procedure for analysis and control of oil and coolant leaks from engine_rev.01. Applicability: all models. This service repair bulletin instructs dealers and service managers on authorized procedures for identifying and isolating coolant an
- TTB-23-001 rev07 - SERVICE BRAKES, AIR:DISC:CALIPER: Tips and tricks revision 7 summary. Range and motor error codes for the multistrada; assembly procedure of the brake caliper mounting plate when refitting the rear wheel for the monster; oil seal install instructions on dry clutch housing f
- SRV-SRB-23-031 - ENGINE AND ENGINE COOLING: Precautions to follow during crankcase cleaning. Applicability: all models. This service bulletin informs dealers and service managers about precautions in using abrasive cleaners for engine component sealant, and in particular the crankcas
- SRV-SRB-23-018 - ENGINE AND ENGINE COOLING: Procedure for analysis and control of oil and coolant leaks from engine. Applicability: all models. This service bulletin provides dealers and service managers with troubleshooting guidance for oil or coolant leaks. This bulletin includes s
- SRV-SRB-22-038 - SERVICE BRAKES, HYDRAULIC: Overview of rear brake system updates. Applicability: all models. This service repair bulletin provides dealers and service managers a provides a summary of the updates available for motorcycles that have customer concerns about a slight e
- SRV-TSB-22-010 - ENGINE AND ENGINE COOLING: Cr235 a?? Checking proper configuration of options installed on the motorcycle. Applicability: all models (usa & mex country versions only) . This technical service bulletin informs dealers and service managers of required bbs electronic c
- SRV-SRB-22-031 - SERVICE BRAKES, HYDRAULIC: Overview of rear brake system updates. Applicability: all us models. This service bulletin provides a summary of the updates available for motorcycles that have customer concerns about a slight elongation, over time and use, of rear brake
- SRV-SRB-22-020 - ENGINE AND ENGINE COOLING: Service operation manual update 2022. Applicability: all models, all model years. This service bulletin informs dealers and service manages of service and operations updates to the operations manual.
- TTB-22-001_R 01 - SERVICE BRAKES, HYDRAULIC: Tips & tricks v 01 - applicability: all models. Pg 13 : possible damage to water pump gear oil seal. Diavel 1260 (all model versions). Pg. 15: indication for replacement of brake hoses under warranty. Multistrada v4 pp, pg. 41, possible pre
- SRV-ESB-22-002 - ELECTRICAL SYSTEM: Rules for battery replacement under warranty. Applicability: all models, all years. This electronic service bulletin replaces and cancels srv-esb-19-001, published january 17, 2019. It provides dealers and service managers the correct repl
- TTB-20-001 r25 - ENGINE AND ENGINE COOLING: Tips & tricks v25 - applicability: all models. Pg 12 : update of engine oil filter cartridge tightening torque. Multistrada v4 (all model versions). Pg. 38: possible incorrect diameter of the silencer front or rear manifold in the racing ex
- TTB-20-001 rev20 - ENGINE AND ENGINE COOLING: Tips & tricks. Applicability: all models, all model years, p. 10-error P0314 validation: high misfire with risk of damaging the catalytic converter; p.11-control unit reprogramming. Multistrada v4s all model years, p.30-right-hand switch b
- SRV-TTB-21-001v3 - TIRES:PRESSURE MONITORING AND REGULATING SYSTEMS: Tips & tricks ver 03. Applicability: all models, all model years. This tips & tricks bulletin informs dealers and service managers of non-safety time-saving efficiencies and observations, encountered by ducati field technicians. Topics i
- SRV-TTB-20-001 r - VEHICLE SPEED CONTROL: Tips & tricks ver 12. Applicability: all models, all model years. This tips & tricks bulletin informs dealers and service managers of non-safety time-saving efficiencies and observations, encountered by ducati field technicians. Topics ra
- SRV-SRB-21-013 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Rideability complaints. Applicability: all models. The purpose of this service bulletin is distribute a questionnaire to help dealers and service managers collect detailed information about any rideability complaints for models equipped w
- SRV-SRB-20-014 - SERVICE BRAKES, HYDRAULIC: Guided diagnosis for front brake system bleeding - applicability: all vehicle models, all years. This service bulletin provides guidance for front brake system bleeding. It includes a "guided diagnosis" attachment, which outlines the seque
- SRV-SRB-19-045 - EQUIPMENT: Scheduled maintenance check list update - applicability: all models. This service bulletin provides dealers and service managers with scheduled maintenance updates specific to each of ducati's models. This includes updated mileage and time
- SRV-SRB-19-046 - POWER TRAIN: Final drive chain maintenance precautions - applicability: all models and model years (except xdiavel). The purpose of this service bulletin is to further inform dealers and service managers of proper maintenance to ensure optimal performa
- SRV-SRV-19-035 - ENGINE AND ENGINE COOLING: Tiltwatch indicator for engine shipments - applicability: all models, all years. This service repair bulletin informs dealers and service managers about the "tiltwatch" indicator being implemented on engine packages. It also provides inst
- SRV-ESB-18-004 - ENGINE (PWS): Immobilizer systems - this electronic service bulletin supersedes srv-esb-16-002 published 10/06/2016. It contains updated system information regarding ducati immobilizer systems (engine start lock systems) for the listed year models. The
- SVC-11-022 - FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY: Ducati motorcycle: information being provided regarding improper coupling of tank rubber pads onto frame and the difficult use of front closing tank hook due to fuel tank expansion. *pe
- SVC-09-009 - STEERING:GEAR BOX:SHAFT SECTOR: Ducati motorcycle: the gear selector mechanism applicable to all ducati model motorcycles equipped with 2v/4v engines has been revised due to difficulty in selecting a gear and gear selector was set incorrectly. No model years listed.
- 684 - ELECTRICAL SYSTEM:WIRING: Main wirin harnes for monster s4 models from 2003-2006. Ducati. *kb
Fuel leak at pump/tank interface investigation # PE10045
After opening this pe, we met with subject owners, dealers, and ducati north america personnel.We learned that the subject leakage is limited to the multistrada line alone and is unrelated to composite fuel tank deformation.Rather it stems from the inability of the original sealing o-ring to conform to the tanks relatively rough sealing surface.Recall 11v-020 provides a new "x" section o-ring to address the multistrada issue and with that recall, this pe is closed for the multistrada.Meanwhile, unlike the multistrada, the monster line fails to exhibit a current safety defect trend and, on that basis, this pe is closed for those models as well.
1 Results returned successfully. NOTE: Any missing decoded values should be interpreted as NHTSA does not have data on the specific variable. Missing value should NOT be interpreted as an indication that a feature or technology is unavailable for a vehicle.
Variable | Value |
---|---|
Additional Error Text | Unused position(s): 11; |
Body Class | Motorcycle - Street |
Cooling Type | Air |
DisplacementCC | 750 |
DisplacementCI | 45.767808071 |
DisplacementL | 0.750000 |
EngineHP | 82 |
EngineHP_to | 90 |
Error Code | 2,14 |
Error Text | 2 - VIN corrected, error in one position; 14 - Unable to provide information for some of the characters in the VIN, based on the manufacturer submission. |
GVWR | Class 1A: 3,000 lb or less (1,360 kg or less) |
Make | DUCATI |
MakeID | 568 |
Manufacturer | DUCATI MOTOR HOLDING S.P.A. |
Manufacturer Id | 1133 |
Model | Monster |
ModelID | 2927 |
Model Year | 2006 |
NCSA Body Type | Two Wheel Motorcycle (excluding motor scooters) |
NCSA Make | Ducati |
NCSA Model | 750cc or greater |
Other Engine Info | TWIN CYLINDER 90 DEGREE |
Possible Values | (11:B) |
Series | Naked Standard Bike |
SuggestedVIN | ZDM1RA3P76B752302 |
VIN | ZDM1RA3P760752302 |
Vehicle Descriptor | ZDM1RA3P*60 |
Vehicle Type | MOTORCYCLE |
Crash | Fire | Towed | Injured | Deaths | Failure Date |
---|
No | No | N | None | None | 20110221 |
My motorcycle has a plastic gas tank which has begun to expand. The outside dimensions of the tank have increased and it now does not sit correctly in the frame, the handlebars hit it on turning, and it presses against the ignition switch. Previously it opened and closed without problems, now i have to wedge it against the ignition switch to close it. The rubber mounts no longer sit on the frame. I have not significantly modified my motorcycle except for an aftermarket exhaust and some cosmetic changes. I have made no modifications to the fuel tank or fuel pump. I took the bike to the dealer (hattar motorsports) who submitted a claim to ducati north america (the importer/factory). I have been told it will be replaced. I am very concerned as to the safety of this motorcycle now. The tank's swelling has made it so the handlebars do not turn correctly. If the tank swells enough, it will split open and i am concerned this will happen while i am riding. *tr
No | No | N | None | None | 20101130 |
Plastic fuel tank swelling. *tr
No | No | N | None | None | 20101130 |
2006 ducati monster s2r gas tank is expanding and flexing. Eventual failure would lead to fuel leaking onto hot engine and exhaust parts. *tr
No | No | N | None | None | 20101031 |
I own a 2006 ducati monster s2r-1000 (purchased new 11/2006), and it has a plastic gas tank that has become distorted from its original shape. My fuel tank has become distorted on the left/ right sides of the tank in the area where my knees touch the tank. There is some type of demformation around the gas cap, which is causing the paint to crack. The rubber pucks, which are on the bottom of the tank, support the tank on the frame. The pucks no longer sit correctly on the frame, and the tank does not sit securely on the frame. *tr
No | No | N | None | None | 20100621 |
Plastic gas tank expanding on ducati monster s2r1000. Tank has not ruptured or failed yet, but continued expansion could cause damage. *tr
No | No | N | None | None | 20100619 |
The plastic gas tank on my motorcycle is swelling, causing it to not fit properly on the frame anymore. It is also interfering with the ignition switch and tank latch mechanism. There is also cosmetic damage (ripples) on the side of the tank. Am worried that tank will eventually fail or leak. *tr
No | No | N | None | None | 20100228 |
The gas tank on my 2006 ducati monster s2r has expanded in both width and length. The larger dimensions now allow the handlebars to hit the tank which could cause a loss of control/crash. Another worrisome issue with an ever-expanding plastic gas tank is the fact that it sits in your lap while riding. Not really where i would want a sudden expulsion of flammable liquid onto a hot engine when the tank splits open. *tr
No | No | N | None | None | 20091203 |
My motorcycle has a plastic gas tank which has begun to expand. The outside dimensions of the tank have increased and it now does not sit correctly in the frame, the handlebars nearly hit it on turning, and it nearly presses against the ignition switch. The rubber mounts no longer sit on the frame - they each sit out 1/4 to 1/2". I have not significantly modified my motorcycle except for an aftermarket exhaust and some cosmetic changes. I have made no modifications to the fuel tank or fuel pump. I took the bike to the dealer who adjusted the tank and thought it was simply out of adjustment. I am very concerned as to the safety of this motorcycle now. The tank's swelling has made it so the handlebars do not turn correctly. If the tank swells enough, it will split open and i am concerned this will happen while i am riding. *tr
No | No | N | None | None | 20091109 |
Recently found that my fuel tank on my 2006 ducati monster s2r 800 motorcycle has expanded and is becoming deformed causing contact between latch and ignition switch. Also found that the tank no longer properly rests on the frame. *tr
Common OBD-II Error Codes
- P0314 [1] Single Cylinder Misfire (Cylinder not Specified)
VIN | Year | Model | Manufactured In |
---|---|---|---|
ZDM1RABPX6B080595 | 2006 | Monster | EMILIA-ROMAGNA, ITALY |
ZDM1RA3U763752302 | 2006 | Monster | , |
ZDM1RA3P760752302 | 2006 | Monster | , |