Ducati Monster 696 2007
Vehicle Details: Investigations, Consumer Complaints, Decoded VIN Details, Service Bulletins
Use the box here to look up VINs from DUCATI as well as other manufacturers
-
Where is the 2007 DUCATI Monster 696 produced?
- The 2007 DUCATI Monster 696 is produced in Bologna Emilia-romagna, Italy.
-
What is the GVWR of a 2007 DUCATI Monster 696?
- The 2007 DUCATI Monster 696 has a GVWR of Class 1A: 3,000 lb or less (1,360 kg or less) lbs.
-
How much horsepower does the 2007 DUCATI Monster 696 have?
- The 2007 DUCATI Monster 696 has 69 horsepower.
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- SRV-SRB-24-001 - SUSPENSION: Procedure for assessing front fork oil leaks. Applicability: all models. This service repair bulletin informs dealers and service managers of the assessment criteria for identifying front fork-related defects. The purpose is prevent technic
- SRV-SRB-23-037 - ENGINE AND ENGINE COOLING: Finial drive chain maintenance precautions. Applicability: all models and model years (except xdiavel). This service bulletin replaces and cancels the previous bulletins: srv-srb-18-030 published on 05/11/2018, srv-srb-19-046 published on
- SRV-SRB-23-036 - SERVICE BRAKES, HYDRAULIC: Guided diagnosis for front brake system bleeding. Applicability: all models. This service bulletin replaces and cancels the previous bulletin srv-srb-20-014 published on 4/17/2020. It provides dealers and service managers with needed info
- SRV-SRB-23-018R1 - ENGINE AND ENGINE COOLING: Procedure for analysis and control of oil and coolant leaks from engine_rev.01. Applicability: all models. This service repair bulletin instructs dealers and service managers on authorized procedures for identifying and isolating coolant an
- TTB-23-001 rev07 - SERVICE BRAKES, AIR:DISC:CALIPER: Tips and tricks revision 7 summary. Range and motor error codes for the multistrada; assembly procedure of the brake caliper mounting plate when refitting the rear wheel for the monster; oil seal install instructions on dry clutch housing f
- SRV-SRB-23-031 - ENGINE AND ENGINE COOLING: Precautions to follow during crankcase cleaning. Applicability: all models. This service bulletin informs dealers and service managers about precautions in using abrasive cleaners for engine component sealant, and in particular the crankcas
- SRV-SRB-23-018 - ENGINE AND ENGINE COOLING: Procedure for analysis and control of oil and coolant leaks from engine. Applicability: all models. This service bulletin provides dealers and service managers with troubleshooting guidance for oil or coolant leaks. This bulletin includes s
- SRV-SRB-22-038 - SERVICE BRAKES, HYDRAULIC: Overview of rear brake system updates. Applicability: all models. This service repair bulletin provides dealers and service managers a provides a summary of the updates available for motorcycles that have customer concerns about a slight e
- SRV-TSB-22-010 - ENGINE AND ENGINE COOLING: Cr235 a?? Checking proper configuration of options installed on the motorcycle. Applicability: all models (usa & mex country versions only) . This technical service bulletin informs dealers and service managers of required bbs electronic c
- SRV-SRB-22-031 - SERVICE BRAKES, HYDRAULIC: Overview of rear brake system updates. Applicability: all us models. This service bulletin provides a summary of the updates available for motorcycles that have customer concerns about a slight elongation, over time and use, of rear brake
- SRV-SRB-22-020 - BRAKES (PWS): Service operation manual update 2022. Applicability: all models, all model years. This service bulletin informs dealers and service manages of service and operations updates to the operations manual.
- TTB-22-001_R 01 - ELECTRICAL SYSTEM: Tips & tricks v 01 - applicability: all models. Pg 13 : possible damage to water pump gear oil seal. Diavel 1260 (all model versions). Pg. 15: indication for replacement of brake hoses under warranty. Multistrada v4 pp, pg. 41, possible pre
- SRV-ESB-22-002 - ELECTRICAL SYSTEM: Rules for battery replacement under warranty. Applicability: all models, all years. This electronic service bulletin replaces and cancels srv-esb-19-001, published january 17, 2019. It provides dealers and service managers the correct repl
- TTB-20-001 r25 - STRUCTURE: Tips & tricks v25 - applicability: all models. Pg 12 : update of engine oil filter cartridge tightening torque. Multistrada v4 (all model versions). Pg. 38: possible incorrect diameter of the silencer front or rear manifold in the racing ex
- TTB-20-001 rev20 - SEATS: Tips & tricks. Applicability: all models, all model years, p. 10-error P0314 validation: high misfire with risk of damaging the catalytic converter; p.11-control unit reprogramming. Multistrada v4s all model years, p.30-right-hand switch b
- SRV-TTB-21-001v3 - EQUIPMENT: Tips & tricks ver 03. Applicability: all models, all model years. This tips & tricks bulletin informs dealers and service managers of non-safety time-saving efficiencies and observations, encountered by ducati field technicians. Topics i
- SRV-TTB-20-001 r - EQUIPMENT: Tips & tricks ver 12. Applicability: all models, all model years. This tips & tricks bulletin informs dealers and service managers of non-safety time-saving efficiencies and observations, encountered by ducati field technicians. Topics ra
- SRV-SRB-21-013 - ENGINE (PWS): Rideability complaints. Applicability: all models. The purpose of this service bulletin is distribute a questionnaire to help dealers and service managers collect detailed information about any rideability complaints for models equipped w
- SRV-SRB-20-014 - SERVICE BRAKES, HYDRAULIC: Guided diagnosis for front brake system bleeding - applicability: all vehicle models, all years. This service bulletin provides guidance for front brake system bleeding. It includes a "guided diagnosis" attachment, which outlines the seque
- SRV-ESB-20-001 - EQUIPMENT ADAPTIVE/MOBILITY: Ducati immobilizer systems - applicability: all vehicles with electronic coded keys. This electronic service bulletin replaces and cancels the bulletin srv-esb-18-004 published on may 3rd, 2018 and provides information regarding the immobi
- SRV-SRB-19-045 - EQUIPMENT: Scheduled maintenance check list update - applicability: all models. This service bulletin provides dealers and service managers with scheduled maintenance updates specific to each of ducati's models. This includes updated mileage and time
- SRV-SRB-19-046 - POWER TRAIN: Final drive chain maintenance precautions - applicability: all models and model years (except xdiavel). The purpose of this service bulletin is to further inform dealers and service managers of proper maintenance to ensure optimal performa
- SRV-SRV-19-035 - EQUIPMENT: Tiltwatch indicator for engine shipments - applicability: all models, all years. This service repair bulletin informs dealers and service managers about the "tiltwatch" indicator being implemented on engine packages. It also provides inst
- SRV-ESB-18-004 - ENGINE (PWS): Immobilizer systems - this electronic service bulletin supersedes srv-esb-16-002 published 10/06/2016. It contains updated system information regarding ducati immobilizer systems (engine start lock systems) for the listed year models. The
- SVC-09-009 - POWER TRAIN:AUTOMATIC TRANSMISSION:GEAR POSITION INDICATION (PRNDL): Ducati motorcycle: the gear selector mechanism applicable to all ducati model motorcycles equipped with 2v/4v engines has been revised due to difficulty in selecting a gear and gear selector was set incorrectly. No model years listed.
- TSB-08-007 - EQUIPMENT ADAPTIVE/MOBILITY: Ducati motorcycle: heat guard retaining screw. It will become loosen and needs to be replaced on the right and left heat guards. *pe
- TSB-08-008 - ELECTRICAL SYSTEM:WIRING: Ducati motorcycle: oil pressure sensor wiring. Possible contact between the horizontal cylinder exhaust pipe and the wiring cable of the oil pressure sensor. *pe
Fuel leak at pump/tank interface investigation # PE10045
After opening this pe, we met with subject owners, dealers, and ducati north america personnel.We learned that the subject leakage is limited to the multistrada line alone and is unrelated to composite fuel tank deformation.Rather it stems from the inability of the original sealing o-ring to conform to the tanks relatively rough sealing surface.Recall 11v-020 provides a new "x" section o-ring to address the multistrada issue and with that recall, this pe is closed for the multistrada.Meanwhile, unlike the multistrada, the monster line fails to exhibit a current safety defect trend and, on that basis, this pe is closed for those models as well.
139 Results returned successfully. NOTE: Any missing decoded values should be interpreted as NHTSA does not have data on the specific variable. Missing value should NOT be interpreted as an indication that a feature or technology is unavailable for a vehicle.
Variable | Value |
---|---|
Body Class | Motorcycle - Street |
Cooling Type | Air |
DisplacementCC | 695 |
DisplacementCI | 42.411502145 |
DisplacementL | 0.695000 |
EngineHP | 69 |
EngineHP_to | 73 |
EngineKW | 51.4533 |
Error Text | 0 - VIN decoded clean. Check Digit (9th position) is correct |
GVWR | Class 1A: 3,000 lb or less (1,360 kg or less) |
Make | DUCATI |
MakeID | 568 |
Manufacturer | DUCATI MOTOR HOLDING S.P.A. |
Manufacturer Id | 1133 |
Model | Monster |
ModelID | 2927 |
Model Year | 2007 |
NCSA Body Type | Two Wheel Motorcycle (excluding motor scooters) |
NCSA Make | Ducati |
NCSA Model | 450-749cc |
Other Engine Info | TWIN CYLINDER 90 DEGREE |
Plant Company Name | Ducati Motor Holding Spa |
Plant Country | ITALY |
Plant State | EMILIA-ROMAGNA |
Series | Naked Standard Bike |
VIN | ZDM1RADM07B103208 |
Vehicle Type | MOTORCYCLE |
Crash | Fire | Towed | Injured | Deaths | Failure Date |
---|
No | No | N | None | None | 20110131 |
Ethanol reacts with the plastic tank causing it to expand resulting in possible gas leaking. Warping of the tank and expansion signs are visible. Nothing has been done yet to correct this issue. *tr
No | No | N | None | None | 20100915 |
2007 ducati monster 695 fuel tank is expanding and warping. Tank is a plastic construction and shows signs of changes in size. *tr
No | No | N | None | None | 20100831 |
The plastic gas tank on my 2007 ducati monster 695 is expanding, the rubber mounts that hold it to the frame have now completely overlapped the frame on one side, and it is expanding over the ignition switch and putting considerable pressure on it. I don't know how much more it will expand before it cracks somewhere. The vehicle has not been modified, it is completely stock from the factory. *tr
No | No | N | None | None | 20100803 |
The nylon fuel tank on my ducati monster is expanding due to use of ethanol fuel blends at most major gas stations. It is beginning to leak around the top and swell on the sides. *tr
No | No | N | None | None | 20100702 |
My motorcycle has a plastic gas tank which has begun to expand. The outside dimensions of the tank have increased and it now does not sit correctly in the frame, the handlebars hit it on turning, and it presses against the ignition switch. Previously it opened and closed without problems, now i have to wedge it against the ignition switch to close it. The rubber mounts no longer sit on the frame. I have not significantly modified my motorcycle except for an aftermarket exhaust and some cosmetic changes. I have made no modifications to the fuel tank or fuel pump. I took the bike to the dealer who submitted a claim to ducati north america (the importer/factory). I am very concerned as to the safety of this motorcycle now. The tank's swelling has made it so the handlebars do not turn correctly. If the tank swells enough, it will split open and i am concerned this will happen while i am riding. *tr
No | No | N | None | None | 20100615 |
I have a warped/expanding gas tank on a 2007 ducati monster 695 motorcycle. *tr
No | No | N | None | None | 20100604 |
My motorcycle has a plastic gas tank which has begun to expand. The outside dimensions of the tank have increased and it now does not sit correctly in the frame, the handlebars hit it on turning, and it presses against the ignition switch. Previously it opened and closed without problems, now i have to wedge it against the ignition switch to close it. The rubber mounts no longer sit on the frame. I have not significantly modified my motorcycle except for an aftermarket exhaust and some cosmetic changes. I have made no modifications to the fuel tank or fuel pump. I am concerned as to the safety of this motorcycle now. The tank's swelling has made it so the handlebars do not turn correctly. If the tank swells enough, it will split open and i am concerned this will happen while i am riding. *tr
No | No | N | None | None | 20091204 |
My motorcycle has a plastic gas tank which has begun to expand. The outside dimensions of the tank have increased and it now does not sit correctly in the frame, the handlebars hit it on turning, and it presses against the ignition switch. Previously it opened and closed without problems, now i have to wedge it against the ignition switch to close it. The rubber mounts no longer sit on the frame. I have not significantly modified my motorcycle except for an aftermarket exhaust and some cosmetic changes. I have made no modifications to the fuel tank or fuel pump. I am very concerned as to the safety of this motorcycle now. The tank's swelling has made it so the handlebars do not turn correctly. If the tank swells enough, it will split open and i am concerned this will happen while i am riding. I have had the tank inspected by a ducati dealership who has contacted ducati na and have not yet received a response. *tr
No | No | N | None | None | 20091028 |
The plastic gas tank is swollen and will not mount properly to the frame nor allows free operation of the handlebars, which make contact with the frame. Gas tank has swollen to the point that the paint has cracked and the mounts are past the frame...Brings concerns of fuel leakage or rupture onto a hot engine.
Common OBD-II Error Codes
- P0314 [1] Single Cylinder Misfire (Cylinder not Specified)
VIN | Year | Model | Manufactured In |
---|---|---|---|
ZDM1RADM07B103208 | 2007 | Monster | EMILIA-ROMAGNA, ITALY |