Mitsubishi Fuso Fe639 1996

• Recall 81367 [USA]: The purpose of this standard is to reduce deaths and injuries from motor vehicle crashes by providing adequate illumination of the roadway.
  Mitsubishi fuso truck of america (mfta) is recalling 156 halogen sealed beam high beam headlamp assemblies sold between october 24, 2007 and december 2, 2008 for use as replacement equipment for certain mitsubishi fuso trucks. These lamps fail to conform to the sae standards or recommended practices referenced in table i of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment."
  mfta will notify owners and replace the headlamps free of charge. The safety recall began on april 15, 2009. Owners may contact mfta at 1-856-467-4500.
  mfta's recall no. C1003910.Owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov .

  Show Content

• Recall 56379 [USA]: In this condition, the parking brake cable may bend and break due to fatigue. the parking brake may become inoperative and the truck may roll and cause a crash, property and personal injuries.
  On certain trucks, the cable end of the parking brake cable, where it attaches to the parking brake lever, is designed improperly. Repeated normal parking brake operation may cause the cable end to become improperly seated in the parking brake lever groove.
  dealers will inspect the parking brake cable for bending or damage at the cable end and install a modified parking brake cable assembly if the cable is bent or damaged at the cable end. If no bending or damage exists, dealers will install a cable retainer on the cable end of the parking brake cable. The recall began on january 13, 2005. Owners should contact mitsubishi fuso at 1-877-711-0707.
  mitsubishi fuso recall no. C0021610.Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 42912 [USA]: The tie rod end ball joint could separate from the tie rod end, disabling the steering system, and causing a crash .
  On certain trucks, the tie rod end ball joint dust boot was designed with insufficient sealing ability. This condition could allow contamination to enter into the tie rod end ball joint, abnormally wearing the resin bearing located inside the joint.
  dealers will install modified tie rod end assemblies. The recall began on january 13, 2005. Owners should contact mitsubishi fuso at 856-467-3917.
  mitsubishi fuso recall no. R3128610.Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 2004372 [Canada]: Brakes
  On certain vehicles, the cable end of the parking brake cable, where it attaches to the parking brake lever, is designed improperly. Repeated normal parking brake operation may cause the cable end to become improperly seated in the parking brake lever groove. In this condition, the parking brake cable may bend and/or break due to fatigue. In the worst case, the parking brake may become inoperative. Correction: dealers will inspect and, if necessary, replace the parking brake cable assembly.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.