Mitsubishi I-miev 2011

• Recall 105367 [USA]: If the brake vacuum pump stops functioning, the distance needed to stop the vehicle may be lengthened, increasing the risk of a crash.
  Mitsubishi motors north america, inc. (mitsubishi) is recalling certain model year 2010-2014 i-miev electric vehicles manufactured september 15, 2009, to march 25, 2014. Due to either software programming or corrosion caused by road salt, the brake vacuum pump may stop functioning.
  mitsubishi will notify owners, and depending on the affected vehicle, dealers will either reprogram the brake vacuum pump controller, replace the brake vacuum pump or do both, free of charge. The recall began on october 24, 2014. Owners may contact mitsubishi customer service at 1-888-648-7820. Mitsubishi's number for this recall is sr-14-007.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall R/2014/108 [UK]: Braking performance may be affected
  It has been identified that the failure of an electric relay can cause the service brake electric vacuum pump to fail. The issue will be identified to the driver by the illumination of a brake warning lamp on the vehicle's instrument panel and an audible warning. If this occurs it will result in a need to apply higher brake pedal force and an increase in stopping distances
  recall all affected vehicles and replace the electric vacuum pump relay.

  Show Content

• Recall R/2018/115 [UK]: Propellant in the front passenger airbag inflator may be detiorated
  The propellant in the passengers front airbag inflator may deteriorate due to high temperature and humid conditions over a longer period in use. As a result the inflator body may rupture during airbag deployment and may injure occupants.
  on affected vehicles replace the passenger airbag inflator.

  Show Content

• Recall R/2019/380 [UK]: Water may penetrate into the brake vacuum pump
  Water may penetrate into the brake vacuum pump causing corrosion.
  the brake vacuum pump will be replaced with a countermeasure one

  Show Content

• Recall R/2015/156 [UK]: Vehicle may cut out
  Due to none conformity during manufacture the resistance of the insulated base inside the motor control unit (mcu) which controls the electric motor may decrease. As a result the voltage in the circuit may become unstable causing the warning light to illuminate and the driving motor power to be restricted to the fail safe control. In the worst case scenario the vehicle may not be able to be restarted and the battery may not be able to be charged.
  recall the vehicles that are likely to be affected and replace the engine mcu.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.