Prevost H3 2003

Vehicle Details: Recalls, Investigations, Decoded VIN Details, Service Bulletins

Below you will find all available information on the 2003 PREVOST H3, manufacturered by Volvo Group Canada, Inc.
The vehicle is described as a Other Bus Type.

ManufacturerKnown WMI(s)Fuel Type
PREVOST2PC 2P9001 2PC 2PC 2P9110 2P9001 2PC Diesel
PREVOST VIN Decoder

Use the box here to look up VINs from PREVOST as well as other manufacturers

#

Sub-models: - H3-41 - H3-45 - H3 Vip - H3-45vip - H3 Coach - H3-45 Vip - H3-41 Coach - H3-45 Coach - H3-45 Vip Coach - H3-45 Vip Entertainer -

Frequently Asked Questions
  • Where is the 2003 PREVOST H3 produced?
     - The 2003 PREVOST H3 is produced in Ste-claire Quebec, Canada.
  • Are there recalls for the 2003 PREVOST H3?
     - There are 12 recall(s) for the 2003 PREVOST H3, additional information is below.
NHTSA Mandated Recalls
  • Recall 101809 [USA]: Once electrically conductive, the material is capable of melting and burning, increasing the risk of a fire.

  • Recall 36622 [USA]: The surface temperature of the exhaust tube exiting from the heater can increase and could potentially ignite combustible materials in or around the vehicle.

  • Recall 55840 [USA]: Loss of steering control can cause a vehicle crash without prior notice.

  • Recall 64376 [USA]: The steering gearbox may become loose affecting steering control, increasing the risk of a crash.

  • Recall 64347 [USA]: in such a case, a loss of steering would occur.

  • Recall 2013139 [Canada]: Steering

  • Recall 2005073 [Canada]: Steering

  • Recall 2003085 [Canada]: Steering

  • Recall 2013139 [Canada]: Steering

  • Recall 2005073 [Canada]: Steering

  • Recall 2003085 [Canada]: Steering

  • Recall 2003086 [Canada]: Structure

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • IS-23019 - SUSPENSION: Sway bar collars improvement
  • IS-22106 - EQUIPMENT: H3 lavatory fan retrofit kit
  • IS-21072B - ELECTRICAL SYSTEM: Steering gateway. Revision b - pin 2 and 10 were inverted on connector a139
  • MI22-12B - SERVICE BRAKES, AIR: Air tanks draining sequence. Revision: b - general update
  • MI22-12A - SERVICE BRAKES, AIR: Air tanks draining sequence. Revision: a - erroneous secondary & accessory tanks location.
  • MI22-12 - SERVICE BRAKES, AIR: Air tanks draining sequence
  • IS-17151C - EXTERIOR LIGHTING: Halogen to led fog light replacement kit. Revision: c - advanced kits canceled
  • IS20-925A - VISIBILITY: Central hvac merv filters installation
  • MI20-08C - STRUCTURE: Storage and startup guidelines: periodically, circumstances arise requiring operators to temporarily park a coach in storage. Whether it is a few weeks or several months, sporadic out of service times or a full stop, prevost recommends foll
  • IS-20925A - POWER TRAIN: Central hvac merv filters installation reva
  • IS-18091A - STEERING: Tie rod 610052 first installation instructions: use these instructions when replacing the drop joint tie rod on s82, s84 / s84u i-beam axles. The new tie rod will be adjusted to the length of the original; however, a steering alignment ne
  • IS-13106A - EQUIPMENT: Slide-out linear bearing and guides kit
  • MI20-19A - ENGINE AND ENGINE COOLING: Rev a: mention added concerning ddc series 60 engine sca requirement
  • MI20-19 - EQUIPMENT: Introducing a new engine coolant into service
  • MI02-17A - EQUIPMENT ADAPTIVE/MOBILITY: Revision : a torque value reduced
  • IS-19165A - ELECTRICAL SYSTEM: Lavatory fan retrofit kit applicable for h3 series coaches from r-1012 (1994) revision a: added installation detail at step 8
  • SCi20-16 - ENGINE AND ENGINE COOLING: Fan clutch plate bolts re-torquing
  • IS-20923 - EQUIPMENT: H3 driver⿿s partition lite installation
  • IS-03103A - EQUIPMENT: Keyless entry system new hand held transmitter and receiver module revision a: added link to programming instructions
  • P040200 - ENGINE AND ENGINE COOLING:ENGINE:HARD PARTS INTERNAL/MECHANICAL: Engine exhaust gas recirculation differential pressure - mechanical system not responding properly us13 ⿿ us20 emissions
  • MI20-08B - EQUIPMENT: Storage and startup guidelines revision: b parts added to suggested material 08-10-2020
  • IS-20922 - EQUIPMENT ADAPTIVE/MOBILITY: Sigma passenger seats partition kit
  • MI20-12 - STEERING: Jerky, noisy or hard to turn steering gearbox. Hydraulic end limiter adjustment. All models ⿿ equipped with rb bosch/zf servocom or servocomtronic steering gearbox
  • MI20-08A - EQUIPMENT: Storage and startup guidelines: rev a: 21516229 replaced by 23381562 20523393 replaced by 21454749 800383 removed 611471 replaced by 611360 70376808 replaced by 21036050 21396642 replaced by 20967831
  • MI20-09 - EQUIPMENT:OTHER:LABELS: Prevost vehicle disinfection procedure
  • MI20-08 - UNKNOWN OR OTHER: Storage and startup guidelines - all prevost vehicles & volvo 9700
  • IS-20905 - EQUIPMENT: Hand sanitizer dispenser installation
  • IS-19064 - STRUCTURE: Baggage door seal replacement
  • MI15-24 - EQUIPMENT ADAPTIVE/MOBILITY: Added: power cables for l.H. Side alternator & fan drive breaker box
  • IS-14076 - EQUIPMENT: This instruction sheets explains how to replace the fuel tank on h-series vehicles. (replacing older series tanks by newer model)
  • IS-04106B - POWER TRAIN: This instruction sheet explains how to replace clutch and radiator fan transfer mechanism mounting base
  • SCI19-30 - EQUIPMENT:APPLIANCE:AIR CONDITIONER: The intent of this procedure is to guide you through the steps required to program a mcm especially for the control of the hvac module as described in instruction sheets is-19923.
  • IS-18091 - STEERING: This instruction sheet explains how to perform the first installation of tie rod 610052 on prevost vehicles equipped with dana s82, s84 / s84u i-beam axles, 1994- today
  • MI18-45A - POWER TRAIN: Vehicles identified below are compatible with a new tie rod design. This new tie rod 610052 has updated ball joints and a fine adjuster sleeve. It replaces former drop type ball joint tie rods. Refer to is-18091 for installation instruction
  • IS-19915 - EQUIPMENT: Mp-1000 multimedia player installation
  • IS-18091 - SUSPENSION: This instruction sheet explains how to install the tie rod 610052.
  • IS-17910A - EQUIPMENT: Message center display (mcd) replacement
  • MI07-04 - SUSPENSION:FRONT:WHEEL BEARING: Prevost: oil lubricated wheel hub bearings. For maximum performances and safety, ensuring that the wheel hubs are inspected daily and lubricated in regular intervals is of the utmost importance. *js
  • 0416 - POWER TRAIN: Modification of speed sensor connectors on allison world transmission. Prevost. *tt
  • 0410 - STEERING: Inspection & replacement of power steering pressure hose. Prevost. *tt
  • 0404 - ENGINE AND ENGINE COOLING: Replacement of hoses and clamps and verification of minimum clearance on the charge air cooler (cac) system. Prevost warranty bulletin. Various prevost 2004 models. *tt
  • 0317A - SERVICE BRAKES, AIR: Bendix ad-9 air dryer connection. *tt
  • 0311 - ELECTRICAL SYSTEM: Elimination of connector c530, c531 & c532 from the interior fluorescent lighting and reading lights fuse holder. This includes model year 2004 models. *tt
Known Recall Investigations
  • Power steering hose leakage investigation # PE05012

    This investigation was opened as the result of odisreview of prevost service bulletin, wb04-10,issued in december 2004 and titled "inspection and replacement of power steering pressure hose.The bulletin addressed the possibility that power steering assist could be lost due to a power steering pressure hose failure.The bulletin instructed the dealer to inspect, replace, and repositioned the hoses throughout the vehicle.As a result of odis investigation, prevost has agreed to conducta safety recall to inspect the power steering hoses for signs of abrading and to replace certain power steering hoses on the subject vehicles.A copy of the safety recall is attached.This action resolves the issues raised by this investigation. Accordingly, this investigation is closed.

NHTSA decoded information from VIN

1 Results returned successfully. NOTE: Any missing decoded values should be interpreted as NHTSA does not have data on the specific variable. Missing value should NOT be interpreted as an indication that a feature or technology is unavailable for a vehicle.

Variable Value
Body ClassBus
Brake System TypeAir
Bus Length45
Error Text0 - VIN decoded clean. Check Digit (9th position) is correct
Fuel Type PrimaryDiesel
MakePREVOST
MakeID4148
ManufacturerVOLVO GROUP CANADA, INC
Manufacturer Id13545
ModelH3 Coach
ModelID8906
Model Year2003
NCSA Body TypeOther Bus Type
NCSA MakeOther Make
NCSA ModelBus: Rear engine, Flat front
Other Bus InfoFrom 1981-1983: Integral Structure / From 1984: Monocoque Construction 102" Wide
Other Engine InfoDiesel Heavy Duty
Plant CitySTE-CLAIRE
Plant CountryCANADA
Plant StateQUEBEC
SeriesHigh Decker
VIN2PCH3349031014753
Vehicle Descriptor2PCH3349*31
Vehicle TypeBUS
Latest VINs Decoded for this Manufacturer
VIN Year Model Manufactured In
2PCH33498310145162003H3 CoachSTE-CLAIRE QUEBEC, CANADA
2PCH33491310146022003H3 CoachSTE-CLAIRE QUEBEC, CANADA
2PCH33490310147532003H3 CoachSTE-CLAIRE QUEBEC, CANADA
2PCH33498310145022003H3 CoachSTE-CLAIRE QUEBEC, CANADA
2PCH33492310144942003H3 CoachSTE-CLAIRE QUEBEC, CANADA
2PCH33492310146082003H3 CoachSTE-CLAIRE QUEBEC, CANADA
2PCH33493310145362003H3 CoachSTE-CLAIRE QUEBEC, CANADA
2PCH33496310145462003H3 CoachSTE-CLAIRE QUEBEC, CANADA
2PCH33499310146852003H3 CoachSTE-CLAIRE QUEBEC, CANADA
2PCH334943C7126002003H3 CoachSTE-CLAIRE QUEBEC, CANADA
2PCH33494310146742003H3 CoachSTE-CLAIRE QUEBEC, CANADA
2PCH33498310147092003H3 CoachSTE-CLAIRE QUEBEC, CANADA
2PCH33499310146402003H3 CoachSTE-CLAIRE QUEBEC, CANADA

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.