Van Hool Tdx25 2018
Vehicle Details: Recalls, Investigations, Service Bulletins
Below you will find all available information on the 2018 VAN HOOL Tdx25.
| Manufacturer | Known WMI(s) | Fuel Type |
|---|---|---|
| VAN HOOL |
Use the box here to look up VINs from VAN HOOL as well as other manufacturers
-
Are there recalls for the 2018 VAN HOOL Tdx25?
- There are 3 recall(s) for the 2018 VAN HOOL Tdx25, additional information is below.
Recall 213930 [USA]: A fuel leak in the presence of an ignition source increases the risk of a fire.
Recall 139029 [USA]: If the fire suppression system does not work as intended, it can increase the risk of injury in the event of a fire.
Recall 133475 [USA]: The exposed seat belt buckles may reduce the seat occupants likelihood of using the seat belt, increasing the risk of injury in the event of a crash.
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- SB2372 - VISIBILITY:POWER WINDOW DEVICES AND CONTROLS: This service bulletin provides you with information about the location of emergency side window decals so that the vehicle meets the national highway traffic safety administrationa??S (nhtsa) federal motor vehicle safety standards (fmvss)
- SB2393 - SUSPENSION:FRONT:SPRINGS:LEAF SPRING ASSEMBLY:U-BOLT, LEAF SPRING TO AXLE: Van hool regularly receives questions regarding the bolts securing the wheel suspension arms of the front axle and tag axles to the chassis. The purpose of this service information bulletin is to inform and is partly a reminder of what al
- SB2255 - EQUIPMENT:ELECTRICAL: Service information: in its production process, bock, manufacturer of refrigerant compressors, has switched to a new type of motor protection switch for the electric motor of the refrigerant compressor. As the mp10 motor protection switch (
- SB1709 - WHEELS: Product improvement: all vehicles with light-alloy wheels - introduction of wheel-end monitoring system (wem). Van hool has released a wheel-end monitoring system (wem) which can be installed on all vehicles equipped with light-alloy wheels
- SB2128 - EQUIPMENT: Service information: removal and installation of shaw def tank sensor unit the purpose of this service information bulletin is to inform you about the removal and installation of a shaw def tank sensor unit.
- SB2094 - FUEL SYSTEM, OTHER: Product improvement: introduction of new generation def tank sensor unit some previous manufactured def tank sensor units are no longer available as spare part. This service bulletin gives you information about the visual points of differe
- SB2039A - POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT:VALVES/VALVE BODY: Service information - introduction of new 4/2 solenoid valve in compressed-air circuit van hool has switched over into production to a new type of 4/2 solenoid valve in the compressed-air system. As the previous knorr-bremse (bosch) soleno
- SB1856 - POWER TRAIN: Service information - maintenance operations related to refrigerant compressor oil this service information bulletin is a reminder/update about refrigerant compressor oil maintenance. To ensure a reliable system, it is important to perform
- SB1334 - BRAKES (PWS): To change "quick release valve" of front axle brakes.
- SB1323 - SUSPENSION: Introducion to electronic contrlolled air suspension(elc).
- SB2039 - EQUIPMENT ADAPTIVE/MOBILITY: Service information bulletin: van hool has switched over into production to a new type of 4/2 solenoid valve in the compressed-air system. As the previous knorr-bremse (bosch) solenoid valve (vh11102170) is no longer made available as spare
- SB1961 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Service information bulletin: what to do in case of prolonged vehicle standstill. This service bulletin provides an overview of works to be performed during prolonged vehicle standstill.
- WP1120A - POWER TRAIN: Work procedure: to reinforce structure of trailing axle module (fix on fail) this procedure has been released to assist in successfully reinforce the connection between the diagonals and horizontal tube in the trailing axle module.
- SB1702 - ENGINE AND ENGINE COOLING: Service information bulletin: stress-free installation of flex pipe this service bulletin gives step-by-step instructions on how to install the flex pipe properly. The flexible part of the flex pipe handles thermal expansion and engine vib
- MIC-VANH-090820 - EQUIPMENT: Van hool n.V. And abc companies did not release any new service bulletins during the month of august 2020.
- SB1826 - ENGINE AND ENGINE COOLING: Service information bulletin: the purpose of this bulletin is to inform you about how to align the cooling fan drive. This should be performed every time components of the fan drive have been removed, and when evidence of contact damage h
- SB1796 - ENGINE (PWS): Service information: he purpose of this service bulletin is to inform you about the innocent traces of lubricant at the bottom of the transmission bell housing on new vehicles. They are caused by the protective anti-corrosion coating at the
- SB1777 - STRUCTURE: Service information: this bulletin is being released as a reminder of the importance of wheel bearing preventive maintenance. Check the wheel bearing end-play every 50,000 miles*, and when having any work done on the brakes or any other com
- SB1746 - BRAKES (PWS): Field change program: it has come to the attention of van hool that the fire suppression system, when activated while driving, shuts down the engine after 15 seconds. As a result of this, the door brake is automatically applied. To preven
- SB1508 - POWER TRAIN: Transmission refuses to shift into gear after a low air pressure condition. It has come to the attention of van hool that on the cx35, cx45, tx45 and tdx25 with cummins epa2013/epa2016 engines and allison transmission that the transmission
- WP1108 - EQUIPMENT: To retrofit from iteris to wabco ldw2 land departure warning system. Van hool has released a work procedure to assist abc companies in successfully retrofitting a tdx.. Coach factory equipped with an iteris ldw system to a wabco ldw2 system
- SB1634 - ENGINE AND ENGINE COOLING: Product improvement. Introduction of new single check valves in cooling-circuits deaeration lines.Van hool have recently switched over into production a new type of single check valve. Contrary to the previous type equipped with a plastic h
- SB1650 - ELECTRICAL SYSTEM: To check rating of lower-deck evaporator fans circuit-breakers for tdx25us coahes.On some of the tdx25us coaches the evaporator fans located in the lower deck climate control unit are protected by four 15 amp circuit breakers. Field reports
- SB1645 - WHEELS: To remove/install wheel-nut caps. Some vehicles have plastic chrome-coloured wheel-nut caps on top of the wheel nuts. This service bulletin gives instructions on how to remove/install these wheel-nut caps correctly.
- SB1599 - SERVICE BRAKES, AIR: Compressed-air brake system functional check. These tests are designed to identify the cause(s) of a sluggish performance and/or leaks in the system. The tests give you a general idea of the system condition. The procedures described in thi
- SB1580 - STRUCTURE: California proposition 65 decal. Vehicles delivered to the state of california from january 2018 onwards must have the california proposition 65 decal installed at the inside of the vehicle near the upper right or left corner of the driver
- SB1560 - ENGINE AND ENGINE COOLING: Improper operating coolant surge tank filler cap. We received a number of complaints regarding frequent coolant loss at the overflow line of the coolant surge tank filler cap. Tests have shown that this is due to the installation of a batch
- SB1299B - POWER TRAIN: Introduction of new generation dana g171 drive axles. Dana corporation have changed the wheel end bearing of the g171 drive axle from "unitized" to "compact" bearings. In line with this change associated components such as spindle, hub, hu
- SB1480 - SEAT BELTS: To change rigid seat belt buckles of aisle side passenger seats. Subject vehicles have passenger seats equipped with seat belt buckles of which the outer casing may fail. These casings are held in place by one plastic notch only. When subj
- SB1461 - ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:BELTS AND ASSOCIATED PULLEYS: To change fixing screws of fan-drive idler pulley bracket. Issues have been reported about broken fan-drive idler pulley bracket grade 8.8 fixing screws. Investigation has shown that the grade 8.8 fixing screws, securing the idler arm to th
- SB1487 - EQUIPMENT: Introduction of new type of etnrance door emergency valve. Emergency valves are fitted near entrance doors, at the inside and outside of the vehicle. The emergency valve allows the actuating cylinder of the relevant entrance door to be depr
- SB1468 - POWER TRAIN: Introduction of new transmission oil filler pipe assembly for vehicles with cummins isx engine and allison wtb500? Transmission. The new oil filler pipe removes possible stress on the grommet (part #11147825) that seals the oil filler pipe
- SB1449 - ELECTRICAL SYSTEM: Luggage compartment door operation during driving. Internal quality control has shown that the luggage compartment door can be operated while driving. Owners and operators of the vehicles mentioned above must load a new program into the mul
- SB1402 - ELECTRICAL SYSTEM:WIRING: Van hool has determined that the parcel-rack lighting circuit is not well executed due to an error in the production process. On td925 vehicles, a connection in the parcel-rack lighting circuit is inadequate. The splicing of the electri
- SB1348B - SUSPENSION:FRONT:CONTROL ARM:UPPER ARM: Update of the m20 fastening bolts and "reinforced" rubber bushings for wheel-suspension arm joints.
- 1261A - EQUIPMENT: Service information: bevel gear of front axle steering system service records have shown that the grease in the bevel gear could affect performance at very low temperatures (below -20c/-4f). If the grease in the bevel gear becomes hard e
Seat belt latch failure investigation # PE17006
Through early warning reporting (ewr) data review of 2016 q1-q3, several field reports were found that identified failures of seat belt latch casings on my 2016 van hool motorcoaches.While reviewing the ewr data related to the latch issue, odi was contacted by the national transportation safety board (ntsb) regarding seat belt latch issues they discovered while investigating a crash between a train and a 2016 van hool bus in biloxi, mississippi.Through inspections of buses similar to the bus involved in the crash, the ntsb found that casing failures were occurring on seat belt latches manufactured by fasching salzburg.These concerns were forwarded to odi suggesting the latch casing failures may be a wide spread problem found on my 2016 van hool buses.As a result of the information provided by the ntsb along with the related ewr field reports, odi opened a defect investigation (pe17-006) on the subject vehicles. The intent of the investigation was to better understand if there was a safety related defect involving the latches.During the investigation odi reviewed warranty claims submitted by van hool and found that many identified situations where passengers could not get the seat belt buckles to latch or in some case unlatch.This presented a situation where passengers were either unrestrained during a potential crash or could not get out of their seats to exit the vehicle in a potential emergency.With recall action 18v-209 taken by van hool this investigation is closed.Further use of agency resources does not appear to be warranted.The closing of this investigation does not constitute a finding by nhtsa that a safety-related defect does not exists on other model or my vehicles outside of the recall scope. The agency reserves the right to take further action if warranted by the circumstances.