Freightliner Classic 2005

• Recall 94608 [USA]: The steering could unexpectedly turn left or right, making the vehicle more difficult to control and increasing the risk of a crash.
  Daimler trucks is recalling certain model year 2005-2011 freightliner cascadia, columbia, century, coronado, and classic xl trucks manufactured from november 1, 2004, through june 15, 2010 for the rack and pinion steering system. The lower pinion bearing may corrode and fail. A failed bearing may lead to damage of the spool valve seals. A damage spool valve seal may allow hydraulic fluid to flow to the right or left turn port instead of flowing to the return port.
  daimler trucks will inspect the lower bearing for corrosion. If corrosion is found, the rack and pinion system will be replaced. If no corrosion is found, on the bearing, the bearing will be packed with grease and the rubber bellows will be replaced with sealant added between the bellows and the rack housing. An interim letter was mailed in december 2011. Owners may contact daimler trucks toll-free at 1-800-547-0712.
  daimler trucks' safety recall number is fl-614.Owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov .

  Show Content

• Recall 88783 [USA]: If a leak continues undetected under certain conditions, fuel may ignite at a hot engine surface and/or fuel may be spilled on the road surface.
  Daimler trucks is recalling 62,000 my 2005-2007 freightliner business class, century class, columbia, coronado, fld, classic, sterling a-line, l-line, and western star 4900 trucks. A fractured fuel line could leak diesel fuel.
  high pressure fuel lines and transfer tubes will be inspected and replaced free of charged. The recall began on july 9, 2008. Owners may contact daimler trucks at 1-800-547-0712.
  daimler truck recall no. Fl-526.Customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov.

  Show Content

• Recall 72586 [USA]: A fractured tie rod assembly will make the vehicle more difficult to control at higher speeds and a crash may occur.
  On certain trucks equipped with rack and pinion steering, the ball socket assembly at the inner end of the driver side tie rod may be damaged in a sharp turn. Excessive tie rod angles may loosen the tie rod in the ball socket or damage the threaded tie rod socket attachment to the steering rack on the driver side. The threaded end of the ball socket assembly may fracture and separate.
  dealers will change the front axle steering stops to prevent interference in the tie rod ball socket assembly and steering components will be replaced free of charge. The recall began on july 8, 2008, and will be mailed in phases through december 31, 2008. Owners may contact freightliner at 1-800-547-0712.
  freightliner recall no. Fl-513. Customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov.

  Show Content

• Recall 89091 [USA]: These conditions could either result in leakage and cause a delay in the application of the spring brake without warning or possibly lead to unintended vehicle rollaway or brake drag which could result in a vehicle crash, personal injury, or death.
  Certain freightliner school bus chassis, heavy trucks, and thomas built school buses manufactured between july 2002 and july 3, 2007, equipped with bendix sr-7 spring brake control valves. The parker scv brass 90 degree single check valves (scv) which attach to the supply port of a bendix sr-7 spring brake modulating valve can break apart. Pieces of the parker scv can become lodged inside the sr-7 spring brake modulating valve, potentially causing either leakage out of the sr-7 valve or preventing air from properly exhausting from the sr-7 valve. Also, due to a manufacturing defect in the internal rubber check valve inside the sr-7 spring brake modulating valves, the valves can become deformed and not seat properly.
  freightliner will notify owners and repair the vehicles free of charge. The recall began on january 11, 2008 to freightliner, sterling, and freightliner custom chassis owners; to thomas built bus owners on february 1, 2008. Owners can contact freightliner at 1-800-547-0712.
  freightliner recall no. Fl-504.Customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.Safercar.Gov.

  Show Content

• Recall 55344 [USA]: The oil line may be cut on the cylinder head causing an oil leak and a possible fire.
  On certain trucks equipped with caterpillar diesel engines, the variable valve actuation oil line may wear against the sharp edge of the cylinder head if not positioned correctly.
  caterpillar, in conjunction with freightliner, will be conducting the owner notification and remedy for this campaign free of charge. Owners may call caterpillar at 309-675-6496, or freightliner at 1-800-547-0712.
  freightliner recall no. Fl-471.Customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov.

  Show Content

• Recall 2008078 [Canada]: Fuel supply
  On certain trucks, the high-pressure fuel line at each injector may fatigue and fracture if a fastener at the end of the line is not properly connected. This would allow high pressure atomized diesel fuel to enter the engine compartment, creating a risk of fire, which could result in property damage, personal injury, or death. Correction: dealers will affect repairs.

  Show Content

• Recall 2007231 [Canada]: Brakes
  On certain vehicles, the internal rubber check valve inside the bendix sr-7 spring brake modulating valve can become deformed over time. The effect of this defect is intermittent and presents a potential delay or failure in applying the parking brakes; potentially resulting in a vehicle roll away. Should this occur, the unattended roll away vehicle could strike a bystander or cause property damage. Correction: dealers will install a check valve repair kit.

  Show Content

• Recall 2006034 [Canada]: Engine
  On certain vehicles equipped with a caterpillar engine, the variable valve actuation oil line (vva line) used on 6 cylinder, 15l turbocharged and air-to-air aftercooled diesel engines may wear against the sharp edge of the cylinder head if not oriented correctly. Oil line wear may cause an oil leak and a potential fire hazard. Correction: dealers will inspect and, if required, replace the vva line.

  Show Content

• Recall 2006084 [Canada]: Suspension
  On certain vehicles, the rear suspension transverse beam castings were not made to specifications. If a casting were to break when the vehicle is in motion, parts could become projectiles with potential to cause property damage, personal injury or death. Also, the transverse beam may drop down low enough to contact the road surface causing sparks that could ignite a fire. Correction: dealers will inspect and, if necessary, replace the transverse beams.

  Show Content

• Recall 2005266 [Canada]: Steering
  On certain vehicles, the front hubs may fracture and allow the wheel assembly to separate from the vehicle. This could cause a crash without prior warning. Correction: dealers will inspect and, if required, replace the hubs.

  Show Content

• Recall 2005292 [Canada]: Steering
  On certain vehicles, the lower yoke on the steering shaft may have been incorrectly fabricated. If the splines of the steering shaft push through the lower yoke, the steering wheel will be free to turn without any response from the vehicle. A loss of steering control could result in a crash. Correction: dealers will install a tension collar to the steering shaft to secure the connection to the yoke.

  Show Content

• Recall 2005318 [Canada]: Suspension
  On certain vehicles, the rear spindles may fracture as a result of incorrect heat treat process during vehicle assembly. Rear spindle failure could allow the wheel, tire, and brake drum assembly to separate from the vehicle. The wheel end assembly could become a hazard for other traffic. Correction: dealers will inspect for the heat treat date code on the end of the rear spindles. Axle housings will be replaced on vehicles manufactured with spindles that have the subject date codes.

  Show Content

• Recall 2007231 [Canada]: Brakes
  On certain vehicles, the internal rubber check valve inside the bendix sr-7 spring brake modulating valve can become deformed over time. The effect of this defect is intermittent and presents a potential delay or failure in applying the parking brakes; potentially resulting in a vehicle roll away. Should this occur, the unattended roll away vehicle could strike a bystander or cause property damage. Correction: dealers will install a check valve repair kit.

  Show Content

• Recall 2007279 [Canada]: Steering
  On certain trucks, the driver's side inner tie rod may be damaged while the truck is executing a sharp turn. Excessive tie rod angles may loosen the tie rod ball socket and/or damage the threaded tie rod attachment to the steering rack. As a result, the tie rod assembly may fail, possibly causing a loss of vehicle control and a crash. Correction: dealers will replace the front axle steering stops to limit turning radius and prevent interference with the tie rod assembly.

  Show Content

• Recall 2006034 [Canada]: Engine
  On certain vehicles equipped with a caterpillar engine, the variable valve actuation oil line (vva line) used on 6 cylinder, 15l turbocharged and air-to-air aftercooled diesel engines may wear against the sharp edge of the cylinder head if not oriented correctly. Oil line wear may cause an oil leak and a potential fire hazard. Correction: dealers will inspect and, if required, replace the vva line.

  Show Content

• Recall 2005266 [Canada]: Steering
  On certain vehicles, the front hubs may fracture and allow the wheel assembly to separate from the vehicle. This could cause a crash without prior warning. Correction: dealers will inspect and, if required, replace the hubs.

  Show Content

• Recall 2005292 [Canada]: Steering
  On certain vehicles, the lower yoke on the steering shaft may have been incorrectly fabricated. If the splines of the steering shaft push through the lower yoke, the steering wheel will be free to turn without any response from the vehicle. A loss of steering control could result in a crash. Correction: dealers will install a tension collar to the steering shaft to secure the connection to the yoke.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.