Toyota T100 1994

• Recall 61658 [USA]: If the vehicle is continued to be operated in this condition, the relay rod may fracture, increasing the risk of a crash.
  On certain pickup trucks and sport utility vehicles, if the steering wheel is repeatedly turned under certain conditions where high steering effort and power assist are required, for instance, when fully turning the wheel while the vehicle is stopped, a fatigue crack may develop in the steering relay rod.
  dealers will replace the steering relay rod. The recall began october 5, 2005. Owners may contact toyota at 1-800-331-4331.
  toyota recall no. Ssc 50n.Customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov.

  Show Content

• Recall 2005261 [Canada]: Steering
  On certain vehicles, if the steering wheel is repeatedly turned under conditions where high steering effort and power assist are required, for instance, when fully turning the wheel while the vehicle is stopped, a fatigue crack may develop in the steering relay rod. Correction: dealers will replace the steering relay rod.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

The following is a list of any known keyfobs for the Toyota T100 1994 as well as their FCC IDs if available

• ASP-C-30-136: 1993-1998 Toyota T100 / 8-Cut / TR47 / Ignition Lock Cylinder / Coded / C-30-136 (ASP)

• Clutch pedal bracket/firewall investigation # PE02039

  
  

  Show Content

Vehicle would not start. Shift lever in first gear, clutch pedal fully depressed and clutch bypass switch engaged. Vehicle lurched forward approximately one foot while turning key nearly ramming into the side of another vehicle parked directly in front of disabled vehicle. Visual inspection of clutch pedal support assembly, toyota p/n 107-34010, revealed two metal fatigue cracks in the support, one approximately one and one half inches long and the other approximately one half an inch long in the heat zone of one spot welded area. The larger of these two cracks allows the firewall portion of the bracket to move in (flex) towards the firewall when the clutch pedal is fully depressed preventing the clutch master cylinder push rod from fully disengaging the clutch. The clutch master cylinder push rod has been adjusted (lenghteded) as much as possible and additional adjustment will not fix the problem. A photograph of the cracked bracket is available, if desired. Thank you! *tr

Tl* the contact owns a 1994 toyota t100. The contact stated that while in reverse, the front driver side tire suddenly disconnected from the frame. The contact was unable to steer the vehicle. The contact had the vehicle towed to a local mechanic where the mechanic noticed extensive rust on the frame. The mechanic advised the contact that the vehicle was not repairable. The contact called the manufacturer regarding the frame rust and the manufacturer advised that there was nothing they could do to assist. The failure mileage was 120,000. Updated 05/09/12*lj

Toyota refuses to accept our complaint about our 1994 toyota t-100. Toyota refuses to acknowledge 05v389000 as a valid source for a complaint. Toyota states that there is no recall for our vehicle. We never received any notice from toyota of a recall. *tr

Dt*: the contact stated while driving 30 mph on normal road conditions, the vehicle rode rough and at one point, overheated and blew a head gasket. The vehicle was taken to the nearest independent mechanic shop, who determined the head gasket was defective and caused severe engine damage. No repairs were made. The manufacturer was contacted, and determined that the recall on this issue had expired in 2004.

Dt*: the contact stated while turning left at 5mph the vehicle is difficult to steer. Upon inspection the contact determined there is a crack in the steering relay rod. There is a nhtsa recall, # 05v389000, regarding the steering relay rod. The vehicle has the same problems as indicated in the recall; however it is not included in the recall due to the vin.

I am having a problem with a defect with the clutch and assemble no longer being attached to the vehicle. I lost use when i was driving due to them no longer being attached at the welds and walls! This was not funny and dangerous. Not being able to shift and no longer able to start the truck. The pedal won't even touch the button to engage the truck to start. The pedal leads to the assembly inside the truck that is not attached any longer.

Tire wall failed castastrophically entire wall let go. Did not hit anything, tire pressure maintained at 35 psi cheched undamaged tires after incident all at 35 psi with two different tire gauges. Took tire to dealer (sam's) tread remaining 6/32 or orginial 14/32. Dealer will refund on 33% of orginial cost but michenlin demands damaged tire be returned in? Concerned because i recommended these tires as replacements for my daughters 2000 ford explorer . Called michenlin and got no indication of any concern about the incident or desire to learn why tire failed.*ak

When sitting in vehicle while it was in idle air bags deployed without any notice. Please provide more information.*ak

Had parked & left vehicle. Return & started vehicle. The air bag light came on. After arriving home, air bag light was still on. Took vehicle to dealer & informed the sensors were gone & was not covered under warranty. *ak

Common OBD-II Error Codes

• P0335 [1] Crankshaft Position Sensor A Circuit Malfunction