T-SB-0014-11 Rev

T-SB-0014-11
Rev1
February 17, 2011
Torque Converter Bolt Installation
Service
Category
Drivetrain
Section
Automatic Transmission/Transaxle
Market
USA
Applicability
YEAR(S)
MODEL(S)
1990 – 2015
4Runner, Avalon,
Camry, Celica, Corolla,
Cressida, Echo, FJ
Cruiser, Highlander,
Land Cruiser, MR2,
MR2 Spyder, Matrix,
Paseo, Pickup, Previa,
RAV4, RAV4 EV,
Sequoia, Sienna,
Solara, Supra, T100,
Tacoma, Tercel, Truck,
Tundra, Venza, Yaris
ADDITIONAL INFORMATION
REVISION NOTICE
October 16, 2014 Rev1:
• Applicability has been updated to include 2015 model year vehicles.
Any previous printed versions of this bulletin should be discarded.
Introduction
The purpose of this service bulletin is to provide information regarding the installation of the correct
torque converter bolts during automatic transmission/transaxle assembly replacement. Incorrect
torque converter bolts or missing washers can cause damage to the torque converter assembly. Use
the information in this bulletin when installing an automatic transmission/transaxle assembly.
NOTE
Not all applications will use washers on the torque converter bolts.
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
–
–
–
–
© 2014 Toyota Motor Sales, USA
Page 1 of 2
T-SB-0014-11
Rev1
February 17, 2011
Page 2 of 2
Torque Converter Bolt Installation
Installation Procedure
• When removing torque converter bolts and washers, take special care that the same bolts and
washers are used when installing the torque converter.
• Using an incorrect size bolt or washer may cause damage to the torque converter assembly.
• Torque the bolts to the specification found in the applicable Repair Manual.
Figure 1.
1
2
3
1
Correct
2
Incorrect
3
Bottom Is Damaged
NOTE
In most applications there will be 1 black torque converter bolt, be sure to install this bolt first to
aid in aligning the torque converter to the flywheel assembly.
© 2014 Toyota Motor Sales, USA