Maserati Quattroporte Gts 2016

• Recall 141071 [USA]: A stall can increase the risk of a crash.
  Maserati north america, inc. (maserati) is recalling certain 2015-2017 quattroporte gts vehicles equipped with a v8 3.8 liter engine. A resistor in the low pressure fuel pump resistor may fail, causing a loss of engine power or a stall.
  maserati will notify owners, and dealers will replace the fuel pump resistor cable assembly, free of charge. Interim notices informing owners of the safety risk are expected to be mailed 11/28/2017. Owners will receive a second notice when the remedy is available. Owners may contact maserati customer service at 1-877-696-2737. Maserati's number for this recall is 359.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall 123855 [USA]: An electrical short can increase the risk of a fire.
  Maserati north america, inc. (maserati) is recalling certain 2014-2017 quattroporte and ghibli, and 2017 levante vehicles. Adjusting the front seats may cause the seat wiring harness to rub, possibly resulting in an electrical short.
  maserati will notify owners, and dealers will inspect the vehicles, replacing the seat wiring harness, as necessary, free of charge. The recall began june 26, 2017. Owners may contact maserati customer service at 1-877-696-2737. Maserati's number for this recall is 342.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall 118702 [USA]: An improperly tightened rear tie-rod to hub carrier assembly attaching bolt may allow the tie-rod to separate from the hub carrier, resulting in a loss of control, increasing the risk of a crash.
  Maserati north america, inc. (maserati) is recalling certain model year 2014-2016 quattroporte and ghibli vehicles manufactured february 1, 2013, to september 18, 2015. During the assembly process, the rear tie-rod to hub assembly attaching bolt may not have been properly tightened.
  maserati will notify owners, and dealers will inspect the left and right rear tie-rod to hub carrier assembly attaching bolts to verify that they are properly tightened, replacing the rear tie-rod to hub carrier assembly as necessary, free of charge. The recall is expected to begin during july 2016. Owners may contact maserati customer service at 1-877-696-2737. Maserati's number for this recall is 303.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall 114610 [USA]: If the floor mat moves and becomes trapped between the accelerator and the vehicle carpet, it may result in very high vehicle speeds, which could cause a crash, serious injury or death.
  Maserati north america, inc. (maserati) is recalling certain model year 2014-2016 quattroporte and ghibli vehicles manufactured february 1, 2013, to november 30, 2015. In the affected vehicles, the driver-side floor mat anchor may break allowing the floor mat to move and get trapped between the accelerator pedal and the vehicle carpet.
  maserati will notify owners, and dealers will replace the driver-side floor mat and possibly the accelerator pedal cover, free of charge. The recall began april 29, 2016. Owners may contact maserati customer service at 1-877-696-2737. Maserati's number for this recall is 301. Note: these vehicles are equipped with a brake override system. In the event a pedal is trapped, pushing on the brake pedal will brake the vehicle and enable the driver to slow and stop and turn off the vehicle.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall R/2017/235 [UK]: Possible short circuit of driver seat wiring
  Some vehicles may have been manufactured with an incorrect driver seat wiring harness layout which can cause the seat wiring harness to rub against metal points on the seat/seat frame assembly through normal seat adjustment operation. Over time this can lead to an inoperative seat adjustment system and in rare cases a potential risk of fire due to an electrical short to ground between the seat wiring harness and the seat adjustment motor assembly.
  replace 2 seat circuit breakers with 25 amp mini-fuses check harness apply protective barrier and reposition if undamaged. If damaged replace harness and then ensure repositioned and protective barrier applied.

  Show Content

• Recall R/2018/028 [UK]: Loss of engine power
  The resistor for the low pressure fuel pump may fail which can cause loss of power and eventually the engine to shut down.
  recall the vehicles that are likely to be affected and replace the low pressure fuel pump resistor.

  Show Content

• Recall R/2016/278 [UK]: Possible loss of control
  It has been identified that the locking nut of the differential pinion may not have been tightened to the correct specification. This will be identified to the driver by noise generated from the differential and also possible vibration. If these warning signs are ignored and with prolonged use in this condition then it could result in a possible failure/locking of the differential and the subsequent loss of control of the vehicle.
  recall all affected vehicle to check the tightness of the locking nut on the differential pinion. If it is found to be incorrect then the differential will be replaced and possibly the drive-shaft if projections or metal contaminates are found in the differential rear cover.

  Show Content

• Recall 2017033 [Canada]: Seats and restraints
  On certain vehicles, the seat wiring harness layout may have been routed incorrectly during manufacturing. Through normal seat adjustment, this could cause the seat wiring harness to rub against metal points on the seat/seat frame assembly. Over time, this could lead to an inoperative seat adjustment system, and in some cases could result in an electrical short to ground between the seat wiring harness and the seat adjustment motor assembly, which could increase the risk of fire causing injury and/or damage to property. Correction: dealers will inspect routing and will secure and protect the seat wiring harness, and if necessary, install a new seat wiring harness.

  Show Content

• Recall 2016195 [Canada]: Suspension
  On certain vehicles, a bolt that attaches the rear tie-rod to the hub carrier assembly may not have been torqued to specification. This could cause the bolt to loosen, which could result in noise from the rear of the vehicle. Over time, this could lead to separation of the tie-rod from the hub carrier, affecting steering control and increasing the risk of a crash causing injury and/or damage to property. Correction: dealers will inspect tie-rod to hub carrier attaching bolts and will repair as necessary.

  Show Content

• Recall 2016097 [Canada]: Accessories
  On certain vehicles, the driver side floor mat anchors could break over time which could allow the floor mat to slide forward and potentially allowing the accelerator to become stuck in the wide open position. A fully depressed accelerator pedal may result in very high vehicle speeds and make it difficult to slow or stop the vehicle. This could result in a crash causing injury and/or damage to property. Correction: dealers will replace the driver side floor mat and possibly the accelerator pedal cover.

  Show Content

• Recall 2017474 [Canada]: Fuel supply
  On certain vehicles, the low pressure fuel pump resistor could potentially fail. If this occurs, the low pressure fuel pump would stop working, causing the engine to stall potentially while the vehicle is in motion, resulting in loss of motive power which could increase the risk of a crash causing injury and/or property damage. Correction: dealers will replace the fuel pump resistor cable assembly with a new and updated part.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.