T-SB-0054-13

T-SB-0054-13
April 23, 2013
CA/FED/50 State Certified Emission Control Underhood
Labels
Service
Category
Engine/Hybrid System
Section
Emission Control
Market
USA
Applicability
YEAR(S)
MODEL(S)
1997 – 2014
4Runner, Avalon,
Avalon HV, Camry,
Camry HV, Celica,
Corolla, Echo, FJ
Cruiser, Highlander,
Highlander HV, Land
Cruiser, MR2 Spyder,
Matrix, Paseo, Previa,
Prius, Prius C, Prius
PHV, Prius V, RAV4,
RAV4 EV, Sequoia,
Sienna, Solara, Supra,
T100, Tacoma, Tercel,
Tundra, Venza, Yaris
ADDITIONAL INFORMATION
SUPERSESSION NOTICE
The information contained in this bulletin supersedes SB No. PG006-00.
• The entire bulletin has been updated.
Service Bulletin No. PG006-00 is Obsolete and any printed versions should be discarded. Be sure
to review the entire content of this bulletin before proceeding.
Introduction
California (CA), Federal (FED), and 50 State Certified emission control underhood labels (emission
labels) may be obtained through your dealership’s Parts Department utilizing standard replacement
parts ordering procedures. Follow the guidelines outlined in this bulletin to ensure proper label
application.
NOTE
Although the California Smog Impact Fee has been discontinued, dealers are still required by
regulation to verify the correct emission label is installed on the correct vehicle in all states.
© 2013 Toyota Motor Sales, USA
Page 1 of 3
April 23, 2013
T-SB-0054-13
Page 2 of 3
CA/FED/50 State Certified Emission Control Underhood Labels
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
–
–
–
–
Regulations
The United States Clean Air Act (Title II Sections 202, 203, 205, and 207) mandates that the emission
control label must correctly match the emissions equipment on the vehicle. Any person violating this
requirement is subject to applicable State penalties and a Federal civil penalty (for more details,
refer to the U.S. Environmental Protection Agency [EPA] website: www.epa.gov/oar/caa/title2.html).
Personnel at franchised dealerships are authorized to affix such labels to vehicles and are, therefore,
subject to this regulation and the attendant penalties.
• Do NOT sell the labels over the counter. ALWAYS install the label on the vehicle.
• NEVER install a California and/or 50 State Label on a vehicle that is not a California/50 State
Emission Certified Vehicle.
• Do NOT install Federal emission labels on vehicles that are not Federal Emissions Certified.
Label Ordering Procedure
To ensure that the emission control labels are affixed to the correct vehicle, it is necessary to follow
these procedures.
1. Record the Vehicle Identification Number (VIN) from the vehicle requiring a replacement label.
2. Using the Technical Information System (TIS), conduct a VIN search in the Vehicle Inquiry tab to
confirm the emissions equipment of the vehicle and verify the vehicle’s emissions requirement
by referring to the following accessory codes:
• CA – California Certified
• FE – 50 State Certified
• RE – Federal Certified
• CN – California and New York Certified
3. Once the emissions equipment information is verified, obtain the part number information
by consulting the Electronic Parts Catalog (EPC) or parts microfiche for all Toyota vehicles,
including Federal Specification vehicles.
NOTE
Search the EPC using the VIN number and the part number prefix 11298 to obtain the
appropriate emission label part number for that vehicle.
© 2013 Toyota Motor Sales, USA
T-SB-0054-13
April 23, 2013
Page 3 of 3
CA/FED/50 State Certified Emission Control Underhood Labels
Label Ordering Procedure (Continued)
4. Order the label through your Parts Department, using standard parts ordering procedures.
5. When the part arrives, verify that the emission
label matches the emissions equipment on the
vehicle. This will ensure the correct label is affixed
to the vehicle.
Figure 1. Sample of Emission Control Label.
© 2013 Toyota Motor Sales, USA