NTB18-080

Classification:
Reference:
RS18-009
Date:
NTB18-080
November 13, 2018
AIR BAG WARNING LIGHT FLASHING
INDICATING SYSTEM DIAGNOSTIC MODE
APPLIED VEHICLES:
2009 – 2019 370Z Coupe and Roadster (Z34)
2017 – 2019 Titan (A61)
2016 – 2019 Titan XD (A61)
2013 – 2019 Sentra (B17)
2005 – 2019 Frontier (D40)
2014 – 2019 Versa Note (E12)
2012 – 2019 Versa Sedan (N17)
2013 – 2018 Altima (L33)
2013 – 2019 Pathfinder (R52)
2014 – 2015 Pathfinder Hybrid (R52)
2017 – 2019 Armada (Y62)
2012 – 2019 NV 1500/2500/3500 (F80)
2013 – 2019 NV200 (M20)
2014 – 2017 Taxi
2019 Taxi
IF YOU CONFIRM
The air bag warning light is flashing slowly (repeating 2 seconds ON, 2
seconds OFF).
NOTE: If this should occur, the Air Bag Diagnosis Sensor Unit is in
Diagnostic Mode and needs to be returned to User Mode.
Figure 1
ACTION
1. Use CONSULT-III plus to check for Air Bag DTCs and perform repairs as needed.
2. Return the Air Bag Diagnosis Sensor Unit to User Mode.
IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you
will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it
contains information that is essential to successfully completing this repair.
Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are
properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job
properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO
NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle.
1/3
SERVICE PROCEDURE
1. Use C-III plus to check for Air Bag DTCs and perform repairs as needed.
NOTE: If there are any Air Bag DTCs, necessary repairs must be completed and DTCs
cleared before continuing.
2. Return the Air Bag Diagnosis Sensor Unit to User Mode as follows:
NOTE: Do not use the air bag warning light as a timer for the following steps.
a. Obtain a timer that will accurately measure seconds (stop watch, stop watch app,
etc.).
b. At the same time, turn the ignition ON and start the timer.
c. At 7 seconds, turn the ignition OFF.
NOTE:

You must turn the ignition OFF within 1 second (turn ignition OFF after 7
seconds and before 8 seconds has elapsed). If 8 seconds elapse before
turning OFF the ignition, you must start over from the beginning.

If you are on the 2nd or 3rd repeat, starting over means repeating all 3 times
again.
d. Wait 2-3 seconds.
e. Repeat steps b, c, and d – 2 more times (total of 3 times).
NOTE: You must turn the ignition ON again for the 2nd and 3rd repeat within 4
seconds (before 4 seconds has elapsed). If 4 seconds elapse before turning the
ignition ON for the 2nd or 3rd repeat, you must start over from the beginning,
repeating all 3 times again.
f. Turn the ignition ON and observe the air bag warning light.
g. The air bag waning light should be ON for about 7 seconds and then go OFF, and
stay OFF.
2/3
NTB18-080
CLAIMS INFORMATION
Submit a Primary Part (PP) type line claim using the following claims coding:
DESCRIPTION
PFP
OP CODE
SYM
DIA
FRT
Reset Air Bag Mode
(1)
RX6TAA
ZE
32
0.2
(1) Reference the Electronic Parts Catalog (EPC) and use the Sensor-Side Air Bag, Center
as the Primary Failed Part (PFP).
NOTE: For repairs related to DTCs that may have been stored, refer to the current
Nissan Warranty Flat Rate Manual and use the appropriate claims coding.
AMENDMENT HISTORY
PUBLISHED DATE REFERENCE
November 13, 2018 NTB18-080
DESCRIPTION
Original bulletin published
3/3
NTB18-080