Nissan Nv200 2017

• Recall 138562 [USA]: If the vehicle stalls, it can increase the risk of a crash.
  Nissan north america, inc. (nissan) is recalling certain 2017 nissan nv200, sentra, nv3500 van, nv3500 bus, nv200 taxi, nv1500, nv2500 van, chevrolet city express, 2017-2018 frontier, versa note, and versa sedan vehicles that have a mechanical (physical) key ignition system. In these models, over time, the weight on the key ring and road conditions or some other jarring event may cause the ignition switch to move out of the run position to the accessory position, turning off the engine.
  nissan will notify owners, and dealers will inspect the production information on the ignition switch, and replace it as necessary, free of charge. The recall began october 1, 2018. Owners may contact nissan customer service at 1-800-867-7669.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall R/2018/234 [UK]: Internal ignition switch spring may have been maunfactured with a surface defect
  Ignition switch spring defect may cause engine to be turned off while driving
  inspect and where necessary replace the ignition switch

  Show Content

• Recall 2018440 [Canada]: Electrical
  On certain vehicles equipped with a mechanical key ignition system, a spring in the ignition switch could wear and break. This may allow the ignition key to inadvertently move from the on position to the accessory (acc) position while driving, causing the engine to shut off and the airbag system to lose power. The resulting loss of motive power, and change in steering and brake forces could increase the risk of a crash causing injury and/or damage to property. Additionally, in the event of a crash, this may also cause the airbags not to function. Correction: dealers will inspect the lot number of the ignition switch, and replace it with a new one if it is affected. Note: until the correction is performed, owners are advised to remove all objects from the ignition key ring, such as additional keys, key chains, etc.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

• Desiccated air bag inflator rupture investigation # EA21002

  From 2000 through 2017, takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("psan") propellant -- propellant 2004 and propellant 2004l. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 blomquist report at www.Nhtsa.Gov/sites/nhtsa.Gov/files/documents/expert_report-hrblomquist.Pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in us vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004l that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated psan inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All takata inflators produced with propellant 2004l contain desiccant, and none of these desiccated inflators using propellant 2004l are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated psan inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- takata (now known as tk global), the independent testing coalition, and exponent -- have been studying the long-term behavior of takata desiccated psan inflators using propellant 2004l (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004l is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004l.The office of defects investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated psan frontal inflators manufactured by takata. This investigation will require extensive information on takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated psan inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.Gov/recalls?Nhtsaid=ea21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede ea15-001, which remains open.
  

  Show Content

Gasoline was discovered dripping from the underside of the mini cargo van while both parked and in motion. Further visual inspection revealed that the hose between the fuel door on the passenger side of the vehicle and the gasoline tank was leaking.

Common OBD-II Error Codes

• B00A0 [4] Occupant Classification System (Subfault)
• P2813 [4] Pressure Control Solenoid "G" Control Circuit Range/Performance
• P0841 [4] Transmission Fluid Pressure Sensor/Switch "A" Circuit Range/Performance
• P0776 [5] Pressure Control Solenoid B Performance or Stuck Off
• P1715 [5] PNP Switch Out Of Self Test Range
• P17F0 [4] P17F0
• P17F1 [4] P17F1
• P0456 [6] Evaporative Emissions System Small Leak Detected
• P0442 [2] Evaporative Emission Control System Leak Detected (small leak)
• P0455 [2] Evaporative Emission Control System Leak Detected (gross leak)
• P0603 [2] Internal Control Module Keep Alive Memory (KAM) Error
• P0101 [1] Mass or Volume Air Flow "A" Circuit Range/Performance Problem
• C1130 [1] C1130