Chevrolet Ssr 2003

• Recall 2004088 [Canada]: Brakes
  On certain vehicles, the brake hoses are not labelled with a designation that identifies the manufacturer of the assembly as required by cmvss 106. This non-compliance has no effect on the performance of the involved brake hose assemblies. Correction: since this does not pose a safety risk, no corrective action is required.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

• Loss of headlights investigation # RQ17002

  The subject vehicles are model year (my) 2002-2009 chevrolet trailblazer, gmc envoy, 2004-2007 buick rainier, 2003-2008 isuzu ascender, 2005-2009 saab 9-7x, 2002-2004 oldsmobile bravada, 2003-2006 chevrolet ssr, 2005-2009 buick lacrosse, and 2006-2008 pontiac grand prix. This scope includes the trailblazer/envoy variants: 2002-2006 envoy xl/trailblazer ext and 2004-2005 envoy xuv. The original scope of this investigation was expanded to include all vehicles equipped with the subject headlight driver module (hdm). The focus of the investigation was to determine whether actions performed by general motors adequately addressed any unreasonable risk to motor vehicle safety in the subject vehicles concerning the headlights and the hdm that controls them.Under normal electrical load and environmental conditions, the hdm can overheat inside the underhood electrical center (uec). This can cause the module to fail and result in a simultaneous loss of both low beam headlights and both daytime running lights (drls), often with no warning or prior detectability to the driver. This failure can be intermittent or permanent. No other exterior lights are affected. High beams, turn signals, brake lights, and reverse lights are still operational.General motors addressed this issue with 2 recalls (14v755 & 15v519) and a special coverage program (n172091910). In view of the recalls and special coverage program implemented by gm and the vehicle high beams continuing to operate, odi has tentatively concluded that the actions taken by gm mitigate any unreasonable risk to safety posed by hdm failure in the subject vehicles.Accordingly, the investigation is closed. The closing of this investigation does not constitute a finding by nhtsa that a safety-related defect does not exist. The agency reserves the right to take additional action if warranted by new circumstances.The odi reports cited above are available for review online at nhtsa.Gov under the identification numbers in the attached document.
  

  Show Content

Possibly the ignition switch. Brand new batteries cannot hold a charge. Mechanic cannot find the problem. *tr

Was traveling on highway at 60mph, engine cut out and lost all power. Had to coast to shoulder in traffic creating dangerous situation. Diagnosed as faulty ignition switch. *tr

The front hood prop on the 2003 chevrolet ssr is very inadequate for its purpose and represents a potential danger - especially since the hood is so heavy.

Hood prop on my 2003 chevrolet ssr is poorly designed in an already bent configuration to hold up an exceedingly heavy hood. The 2005 model year will have gas-filled struts to hold up the hood. Their needs to be a retrofit kit to put the gas struts on the 2003 and 2004 models. According to the contributors to www.Ssrfanatic.Com as well as myself, there have been injuries and many near misses with the hood falling and bending the prop like a pretzel. *ak

I was checking the oil on my 2003 chevrolet ssr. It was parked outside with the hood up and held by the hood prop rod. A small gust of wind hit the hood and shook it slightly. I jumped back just to see the prop rod flexing quite a bit. I have always felt that the rod was not strong enough and since it has a bend in it so it can fit inside the engine compartment it just looks weak. After this i am extra cautious when working under the hood. I feel that the prop rod was never strong enough. When i mentioned this to the dealer they had no answer. I just learned that the 2005 ssr will have gas struts to hold the hood open. Evidently gm must have had enough complaints to make this change. I would like them to replace the prop rod in all 2003 & 2004 ssr's before some body does get hurt. This hood is very heavy and could cause serious injury.

Hood prop on 2003 chevrolet is not sufficient to hold the weight of the hood. Prop has bent and hood has fallen. The 2005 has a completely different design. Gm refuses to acknowledge the problem. *ak

2003 chevy ssr engine hood is extremely heavy (two or three times the weight of a normal hood) and chevrolet has outfitted the 2003 and 2004 chevy ssr with a simple metal hood prop rod to support the hood when open. 1) the hood is so heavy many owners will not be able to or will struggle with the opening of the hood. This can lead to situations where the hood may be dropped on the person trying to open the hood with the possibility for severe injury. My wife cannot open the hood by herself due to the extreme weight of the hood. 2) the 2003/2004 hood prop is very minimal and bends under the weight of the hood. Chevrolet has done away with the hood prop for the 2005 chevy ssr and has installed gas struts to lift and support the hood. The hood itself has not changed for 2005, so chevrolet has found there is a problem with the existing hood prop system. Existing 2003 and 2004 chevy ssr trucks on the road need to be updated with the same gas struts as the 2005 chevy ssr to avoid possible injury and/or death from the hood falling down on the person while trying to lift the hood or while it is in its fully open position. *jb

Hood prop rod is too flimsy to hold the heavy hood up(in the open position). My pro rod collapsed(bent) while my hood was being held open. Fortunately i was not "under the hood" when it fell or i would have been seriously injured or worse. The hood is much too heavy to be supported by the flimsy rod. Gm replaced my bent rod with a new rod of the same design. All 3,300 of the 2003 and 10,000 0f the 2004 chevrolet ssr's have this same prop rod system. Gm media announced last week that all 2005 ssr's will have a new, improved, gas-assisted, self-supporting, hood-struts rather than the prop rods to better hold the hood open. Several other ssr owners have had the same problem that i have, and have complained to general motors but gm has done nothing to solve the problem. It's only a matter of time before someone is seriously injured or killed because of this safety defect!*ak

While standing next to the hood the hood dropped down from the open position. This could have led to serious injury if i had been leaning into the engine compartment. The hood prop on 2003 chevrolet ssr is not sufficient to hold the weight of the hood. The 2005 ssr's have a completely different design. Gm refuses to acknowledge the problem. I have notified my dealer and he says there is no "fix" for the problem.

Common OBD-II Error Codes

• P050D [7] Cold Start Rough Idle
• P0300 [8] Random/Multiple Cylinder Misfire Detected
• P0308 [7] Cylinder 8 Misfire Detected
• P0442 [5] Evaporative Emission Control System Leak Detected (small leak)
• P0455 [3] Evaporative Emission Control System Leak Detected (gross leak)
• U1500 [1] U1500
• B101D [1] Electronic Control Unit Hardware Internal Malfunction
• U1041 [2] SCP (J1850) Invalid or Missing Data for Vehicle Speed
• C0201 [2] Reverse speed sensor right front - signal out of range / performance
• C0265 [2] C0265
• P2135 [1] Throttle/Pedal Pos Sensor/Switch A / B Voltage Correlation
• P0220 [1] Throttle/Pedal Position Sensor/Switch B Circuit Malfunction
• P0120 [1] Throttle Position Sensor/Switch A Circuit Malfunction
• P1514 [1] Idle Control System Circuit Shorted
• P1515 [1] Idle Signal Circuit Malfunction
• P1516 [1] Idle Switch (Electric Control Throttle) Circuit Malfunction
• P1518 [1] Intake Manifold Runner Control (Bank 2) Stuck Closed
• P1870 [1] Transmission Transfer Case Contact Plate Power Short To Ground
• P1626 [1] Control Module Long Term Memory Performance/ Immobilizer Code Words Do Not Match
• P1631 [1] Theft Deterrent Fuel Enable Signal Not Received/ B+ Supply To VCRM A/C Circuit Malfunction
• B1517 [1] Seat Driver Occupied Switch Circuit Short To Battery
• B1518 [1] Seat Driver Occupied Switch Circuit Short To Ground