Volvo Vhd 2010

• Recall 139004 [USA]: The driver may operate the vehicle with the snow plow headlights on but the marker and tail lamps off, reducing the vehicle's visibility and increasing the risk of a crash.
  Volvo trucks north america (volvo) is recalling certain 2004-2019 volvo vhd trucks equipped with snow plow lamp preparation kits. The snow plow headlights can be turned on without other exterior lights, and high beam indicator will not work when the snow plow high beams are on. As such, these vehicles fail to comply with the requirements of federal motor vehicle safety standard (fmvss) number 108, "lamps, reflective devices, and associated equipment."
  volvo will notify owners, and dealers will update the software related to the plow lights, free of charge. The recall began december 19, 2018. Owners may contact volvo customer service at 1-800-528-6586. Volvo's number for this recall is rvxx1804.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall 125631 [USA]: If water and contaminants enter the ball joint, corrosion can occur and lead to accelerated wear, which over time can result in failure of the ball joint, possibly resulting in complete loss of steering, increasing the risk of a crash.
  Volvo trucks north america (volvo) is recalling certain model year 2009-2016 vhd trucks manufactured from april 7, 2008, through december 9, 2015, equipped with usk non-greasable drag links. The ball joint seals may be compromised, which can allow water and other contaminants to enter the ball joints.
  volvo will notify owners, and dealers will replace the drag links, free of charge. The recall began on december 2, 2016. Owners may contact volvo customer service at 1-800-528-6586. Volvo's number for this recall is rvxx1606.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall 97122 [USA]: Without a signal to disengage the clutch when the brakes are applied, the distance required to stop the truck may lengthen, increasing the risk of a crash.
  Volvo trucks north america (volvo) is recalling certain model year 2007-2014 vah, vhd, vnl, vnm, and vt models. The affected vehicles were built without a redundant clutch disengagement switch. Without a redundant switch, a loss of signal from the brake air pressure switch can prevent the clutch from automatically disengaging when the brake is applied.
  volvo trucks will notify owners and dealers will inspect and repair the vehicles if necessary. The recall began on august 26, 2013. Volvo's recall number is rvxx1303. Owners may contact volvo at 1-336-393-2000.
  owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall 90805 [USA]: In the event of a crash, an insufficient seat belt weld may prevent the seat belt from properly restraining the occupant. this increases the risk of injury to the seat occupant.
  Volvo is recalling certain model year 2002-2013 vhd and vn trucks, manufactured from august 4, 2000, through june 22, 2012, and equipped with bench passenger seats. The seat belt d-ring weld may not be sufficient enough to meet the seat belt pull test. Therefore, these vehicles fail to conform to the requirements of federal motor vehicle safety standard no. 210, "seat belt assembly anchorages."
  volvo trucks of america will notify owners, and dealers will replace the suspected d-ring, free of change. The safety recall began on may 10, 2013. Owners may contact volvo at 1-336-393-2000.
  volvo's recall campaign number is rvxx1204.Owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153), or go to www.Safercar.Gov.

  Show Content

• Recall 80182 [USA]: The misinformation on these labels could lead to a vehicle overloading that can increase risk of a crash.
  Volvo is recalling certain model year 2008-2011 vhd, vnl, vnm, as well as 2008-2010 vt vehicles for failing to comply with the requirements of part 567, "certification." the tire description may be incorrect on the vehicle's certification label.
  dealers will inspect and replace the labels free of charge. The safety recall began on february 25, 2011. Owners may contact volvo at 1-800-458-1552.
  volvo safety recall no. Rvxx1005.Owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov .

  Show Content

• Recall 2018604 [Canada]: Lights and instruments
  Certain vehicles equipped with a snowplow preparation kit may fail to comply with the requirements of canada motor vehicle safety standard (cmvss) 108 - lighting system and retroreflective devices. The snowplow headlamps can be turned on without other exterior lights, and the high beam indicator does not work when the snowplow high beams are turned on, which is contrary to the requirements of the standard. This could allow the vehicle to be operated with the snowplow headlamps on and marker and tail lamps off, making the vehicle harder to see and potentially increasing the risk of a crash causing injury and/or damage to property. Correction: dealers will update vehicle software to correct the non-compliance.

  Show Content

• Recall 2016494 [Canada]: Steering
  On certain vehicles, a defect in the ball joint seals on the drag link could allow corrosion to form in the joint, leading to accelerated wear. This could result in ball joint failure, potentially resulting in a loss of steering control which could increase the risk of a crash causing injury and/or damage to property. Correction: dealers will replace the non-greasable drag link with a greasable drag link.

  Show Content

• Recall 2013221 [Canada]: Other
  On certain vehicles, the secondary clutch disengagement switch may have been omitted during vehicle assembly or, in some instances, removed during servicing. As such, primary switch failure would cause the automated manual transmission’s clutch to remain engaged when the brakes are applied. This could increase stopping distances, possibly resulting in a crash causing property damage and/or personal injury. Correction: dealers will install a micro-switch at the brake pedal and update the software to run a diagnostic on the switch during engine start-up.

  Show Content

• Recall 2012356 [Canada]: Seats and restraints
  Certain vehicles may fail to conform to canada motor vehicle safety standard 210 – seatbelt assembly anchorages. The weld used to secure the nut to the center-passenger seatbelt d-ring mounting bracket may not be sufficient to meet the strength requirements of the standard. Failure of the seatbelt d-ring anchorage to restrain the occupant would increase the risk of personal injury during a crash. Correction: dealers will replace the d-ring for the middle seating position.

  Show Content

• Recall 2010347 [Canada]: Label
  On certain vehicles, the tire description may be incorrect on the certification label, which is a non-compliance to canada motor vehicle safety standard 120 - tire selection and rims. The description listed on the label may be for a tire with a lower rating that cannot support the gross axle weight rating (gawr) listed, which may result in a potential tire failure. Correction: updated labels will be mailed to owners of affected vehicles, along with instructions for proper installation.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

• Discrepancies in required cfr reporting investigation # AQ18005

  During a review of volvo trucks (volvo) 2016, 4th quarter ewr field report submissions, odi discovered, multiple communications that had not been submitted to the agency under cfr 579.5 ewr reporting requirements.Also, during a review of the nova lfs transit bus (a subsidiary of the volvo group) recall 17v-323 odi became concerned volvo may not have acted with appropriate speed in making a defect determination and filing the recall with the agency.Based on a review of these issues with volvo, their compliance office agreed to conduct an internal audit of all required reporting and found the following:1.Various forms of communications including, service bulletins, tech tips, case base reasoning reports and other data were not submitted.2.Reporting of some death and injury reports (d&i) had been overlooked and not submittedthis investigation will examine whether volvo acted in conformance with its responsibilities under the safety act.
  

  Show Content

• Stop lamp switch signal investigation # PE13002

  The office of defects investigation (odi) received early warning reporting (ewr) data from the manufacturer that indicated some number of subject vehicles equipped with the subject automated manual transmission had allegedly experienced a condition where the clutch failed to automatically disengage the transmission from the engine as intended. This may result in extended stopping distances and/or unintended forward motion of a vehicle previously at rest.To date, odi is aware of 134 subject vehicles with one or more complaints or field reports related to this condition.Also, odi is aware of 164 subject vehicles with one or more warranty claims related to this condition.By letter dated june 25, 2013, volvo trucks north america (volvo) notified odi that it has initiated a safety recall (nhtsa recall no. 13v268 and volvo recall no. Rvxx1303) to address a safety defect in approximately 23,003 model year (my) 2007 through 2014 volvo vah, vhd, vnl, vnm and vt model trucks. The affected vehicles were manufactured from december 20, 2006 through may 22, 2013 and were originally equipped with the subject automated manual transmissions.According to volvo, reports of the subject transmission clutch mechanism failing to automatically disengage as intended are associated with the removal of a brake pedal micro switch that provided a redundant signal to the transmission control module indicating the brakes had been applied.Previously, volvo had removed this brake pedal micro switch from new vehicle production and from certain vehicles already in-service via two field service campaigns (sp 432-024 and sp 432-026) because it decided the switch was unnecessary and/or a maintenance issue.In the absence of this redundant brake pedal micro switch, the clutch mechanism may fail to disengage the transmission from the engine at low vehicle speed should the stop lamp switch fail to send and/or the transmission control module fail to receive the primary signal.At the time of this closing, volvo is evaluating available remedies and will provide nhtsa with details when the recall remedy procedure has been finalized.Volvo will notify affected owners by mail by august 25, 2013.Please see nhtsa recall no. 13v268 for details.Accordingly, this investigation is closed.
  

  Show Content